Question about 1998 Chevrolet S-10 Pickup

1 Answer

Blower fan motor

Where is the blower motor fan located and how do i fix this

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

It is located under the dashboard, usually on the passenger side or towards the center of the vehicle. Generally these items are not serviceable and should be replaced when faulty.

Posted on Dec 10, 2008

6 Suggested Answers

emissionwiz
  • 63842 Answers

SOURCE: blower motor

You have power the fact that you hear the blower relay click tells me that. In this case I think the reason the Blower Motor Relay is clicking is because you have a bad Blower Motor Resistor. . So that would be the first thing to check out.

Posted on Sep 03, 2008

  • 3 Answers

SOURCE: Blower motor\fan

It is under the passenger side dash. You will need to remove the glove box and the plastic cover just under the dash to expose the fan.

Posted on Sep 17, 2008

  • 107 Answers

SOURCE: Lincoln 2000 town car Blower doesn't work at HI-MED-LOW speeds...

it is called blower motor resistor , should be close to blower motor , you will see a plug type connector with two screws , remove the screws and there should be a resistor inside the cover for the motor, swap with new and reassemble

Posted on Feb 19, 2009

jomabug76
  • 1146 Answers

SOURCE: blower motor relay location

UNDER THE DASH EITHER THE RGT OR THE LEFT,,,,IT WAS ON A 93

Posted on May 15, 2009

  • 26 Answers

SOURCE: Blower motor location

Hi, I had to replace mine also. It's located under the glove compartment, passenger side. Pull off the chrome moulding around the glove box and undo the screws. This will allow you access to the blower motor cover. Be careful of the light inside the glove box. You have to ubdo it's screw and feed it through the back. Undo the cover to expose the blower motor. You can also replace the interior filter in the same area if you haven't done so yet. Two screws on a narrow cover.
Good luck.
Norm

Posted on Jan 12, 2010

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the resister located


on the firewall close to the blower motor usually

Feb 29, 2016 | 2010 Ford F-150

1 Answer

How do I fix the blower fan in my Ford F-150? It's STUCK on HIGH!


the problem is not the fan (blower motor) , it is the resistor in the blower motor hosing under the hood...
open the hood and look over by the passangers side firewall to locate the blower plenum (housing).
There is a plug that has 4 wires and it is plugged dirrectly to the housing.behind that is the resistor configuration that runs the fan at the different speeds ( more resistance = slower fan speed).
It is this part you need to replace.

Mar 23, 2013 | Cars & Trucks

2 Answers

Dead Fan blower 2006 Kia Sportage has 12v power, should I replace it?


Could be your blower motor resistor,it's mounted next to the blower motor,Autozone will take part back for refund if it don't fix problem.Here's what it looks like,Here's where the blower motor is.Easy to remove,disconnect electrical connector,remove 2 screws,can't look at it to tell if bad.Here's the relay.

Dec 23, 2012 | 2006 Kia Sportage

1 Answer

Were is the a.c. blower motor located?


The blower motor is placed within the blower fan unit . You will need to remove the dash board front and also remove the blower motor assmebly with the filter and vent settings to remove the blower for servicing and cleaning.
Removal of the dash and the motor unit can be easily done if you follow the pattern to remove the screws that fixes the motor body to the rotary fan unit.

Sep 12, 2011 | 2000 Hyundai Accent

1 Answer

1997 Chevy S10 pickup Fan switch for heater runs on high only.


replace the blower motor resistor located on the heater box were the blower motor is located the wiring to the blower may go to it. This is very easy to locate if you buy the part first.

Jan 06, 2010 | 1997 Chevrolet S-10 Pickup

3 Answers

Chevy 2007 Silverado-blower motor not working


The bower motor is most likely what you are smelling.Replace the blower motor,and the blower resister next to the blower motor if,the blower motor has no speeds.

Oct 17, 2009 | 2007 Chevrolet Silverado 1500 2WD

1 Answer

The fan blower only works on high. The other


its the resistor, and its located with the blower motor. you will need a new motor assy. .......in Chryslers infinite wisdom, its all one unit.

Oct 08, 2009 | 1998 Plymouth Voyager

1 Answer

I have a 1999 Saab 9-5. The fan blower doesn't


The fan is located under the windsheild wipers. The windsheild wipers will have to be removed. Then remove the plastic shroud and wiper motor and assembly. The fan is located in the middle under the windsheild. If your feeling the AC you can check the stepping units located on the AC unit behind the front console under the dash.....KEH

Aug 04, 2009 | 1999 Saab 9-5

1 Answer

1996 dodge neon ac fan not working


It has a fan motor relay that is usally located next to the blower motor itself its the cheapest fix and if not that the blower motor itself which is located under the dash on the passenger side.

Jul 30, 2009 | 1996 Dodge Neon

1 Answer

2003 Ford Explorer Fan Blower Motor


Jeff, If I understand you correctly you say your blower motor only works on high? check your blower motor resistor, located next to blower motor. The resistor makes the other speeds availiable, high bypasses the resistor, let me know if that fixes you up

May 27, 2009 | 2003 Ford Explorer

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...