Question about 2002 Isuzu Rodeo Sport

1 Answer

Isuzu 4wd Rodeo is stuck in 4wd position - 2002 Isuzu Rodeo Sport

Posted by on

  • 1 more comment 
  • 98RodeoFan Dec 18, 2008

    My 1998 Rodeo does the same thing for extended periods during the winter. In addition, it will slip out of drive entirely while the car is moving. I have to come to complete stop, put the car into neutral, then use the manual 4WD stick to put it into 4L. If I put it into High, it will slip out again once I resume 40+ mph.

  • dashworth1 Jan 30, 2009

    I have a 99 Honda Passport that has the same problem. The dash button engages the 4WD and the light stays on but the 4WD shift lever pops out of gear in HI or LO. When you push the 4WD button to disengage, it just flashes. At this point I have not recieved and answer from Honda specialists but have been informed I would probably have better chances from an Isuzu expert(which is what the 99 Passport is)

    Thanks Dave

  • Anonymous Mar 10, 2009

    97 rodeo wont go into 4wd been in garage 6 weeks they cant find out why. any help?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Isuzu Work shop for Amigo/Rodeo/Trooper.

This will help

Posted on May 08, 2009

  • lardon01952 May 08, 2009

    look for the Isuzu Rodeo trooper Amigo workshop...you can dowload and have a look on the transmission chapter

×

2 Suggested Answers

  • 1 Answer

SOURCE: isuzu rodeo sport 4wd, stuck in 4wd

Don't know if this will help with your exact problem, but I can share with you how I have "fixed" this.

If the 4WD indicator is flashing, then it means the 4WD select switch is working but the 4wd "clutch" hasn't released. Backing the vehicle up slowly, or sometimes just switching into reverse with the 4WD switch in the 2WD position is usually enough to release the 4WD and the 4WD indicator should go off. It after all this, the indicator still does not go off, it could be some issue with the electric 4WD clutch not releasing.
You should be able to tell if the 4WD drive is still engaged by driving slowly in a circle. On drive pavement, the front wheels will "hop" around. Don't do this too fast or too often on drive pavement, since the part time 4WD was not meant for this. The front wheels have to be able to slip in relation to each other, when in 4WD.

Hope this helps and wish you well in your troubleshooting.

Posted on Oct 22, 2008

  • 96 Answers

SOURCE: 1991 isuzu rodeo o2 dash light is stuck on...

The O2 sensor needs to be replaced. There is a screw on the back side of the instrument panel that is removed and switched to another hole in the circuit board to reset the light for another 90,000 miles. Only a shop manual will have the exact location. You can try and obtain one from http://www.helm.com and buy one using print on demand.

Posted on Aug 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Isuzu rodeo 4wd indicator has come on. What would be the reason for this?


Is the unit in stuck 4X4 even though the leaver in in 4X2? or is there a short in the wiring?

May 03, 2015 | Isuzu Cars & Trucks

1 Answer

Is a isuzu rodeo a front wheel drive vehichle?


The '95 Rodeo was not available in front-wheel drive, only RWD and optional 4WD:

http://www.edmunds.com/isuzu/rodeo/1995/features-specs.html

Jun 22, 2012 | Isuzu Rodeo Cars & Trucks

1 Answer

2002 Isuzu rodeo lse 4wd sunroof will vent but not open it looks like it gets stuck on the metal of the car but passes the metal and the glass is uneven.


you have popped it off track,try to pop it back on with your hands first if not you will have to disassemble it

May 05, 2012 | 2002 Isuzu Rodeo

1 Answer

My 2003 rodeo is stuck in low range 4wd is there a manual overide i can try


most vehicles get stuck in 4wd low when they arent shifted into neutral before removal also check the lins to your front differential

Apr 25, 2011 | 2003 Isuzu Rodeo

1 Answer

1998 Isuzu Rodeo 4wd v6 3.2 SUV. The following has


check your IAC or stepper motor operation run the vehicle with the AC on and see if its makes a difference

Jun 09, 2010 | 1998 Isuzu Rodeo

1 Answer

Check 4wd light on


just found this worked a trick..mine stuck for two weeks in 2wd

A mere 2,400km into the life of my 07 Rodeo TD 4WD, I used 4L for about 2km of medium-steep/slippery track. After stopping and selecting 2WD the 'Check 4WD' light appeared, meaning I was stuck in 2WD for the rest of that trip. Luckily I was able to complete the trip in 2WD without incident.

The dealer blamed me for 'not following the instructions in the manual' (utter codswallop), 'fixed' it, and very reluctantly gave me a scribbled set of instructions on resetting the system, which I've included below.

When I suggested that these instructions should be included in the manual, the response was 'not necessary if owners use the system correctly'. More cods.

Here's how to reset it:

1. Ignition off, hold all 3 buttons (2H, 4H & 4L) in together

2. Switch ignition on to 'reds' position (last position before start)

3. Hold in this state for 30 seconds

Hope this may be of use !!

Dec 12, 2009 | 2004 Isuzu Rodeo

3 Answers

HOLDEN RODEO WONT ENGAGE 4WD


If for any reason your Rodeo is or seems to be "stuck" in 2WD or 4WD then below is instructions to reset the system

1. Ignition off, hold all 3 buttons (2H, 4H & 4L) in together.

2. Switch ignition on to the "reds" position (last position before actual engine ignition).

3. Hold in this position for 30 seconds.

Oct 18, 2009 | 2004 Isuzu Rodeo

3 Answers

4 wjheel drive problem


not transfer case motor....there is none on a rodeo....trooper has torque on demand.....rodeo problem is likely shift on fly mtr...mounted on front axle....if u dont use 4wd regularly it sticks and gets stuck.

Dec 30, 2008 | 2000 Isuzu Rodeo

1 Answer

Isuzu rodeo sport 4wd, stuck in 4wd


Don't know if this will help with your exact problem, but I can share with you how I have "fixed" this.

If the 4WD indicator is flashing, then it means the 4WD select switch is working but the 4wd "clutch" hasn't released. Backing the vehicle up slowly, or sometimes just switching into reverse with the 4WD switch in the 2WD position is usually enough to release the 4WD and the 4WD indicator should go off. It after all this, the indicator still does not go off, it could be some issue with the electric 4WD clutch not releasing.
You should be able to tell if the 4WD drive is still engaged by driving slowly in a circle. On drive pavement, the front wheels will "hop" around. Don't do this too fast or too often on drive pavement, since the part time 4WD was not meant for this. The front wheels have to be able to slip in relation to each other, when in 4WD.

Hope this helps and wish you well in your troubleshooting.

Sep 21, 2008 | 2002 Isuzu Rodeo Sport

Not finding what you are looking for?
2002 Isuzu Rodeo Sport Logo

Related Topics:

1,240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...