Question about 1999 Toyota Corolla

1 Answer

1999 Corolla F0301 need Help

1999 Corolla code F0301 came up. I have changed spark pluge, spark pluge wire and ignition coil but the code still comes up. Is anyone can help? please.

Posted by on

  • joshbriscoe3 Dec 27, 2008

    I have the same problem except I am getting it on the number 1 and 2 cylinders

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 28 Answers

Your toyota should be odb2 the F in your code makes no sense to me. The only code i can see it being is maybe P0301 Misfire Detected - Cyl. 1.

Posted on Dec 10, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Change ignition coilon clylinder 1 in 2009 Toyota corolla? got the code P0351


First of all, even though the Issue says Coil Pack, that does not necessarily mean the Coil Pack is Bad. It could be a Loose Connection, it could be a Bad Wire, it can also mean a Bad Spark Plug or fouled Injector but to answer your question...

The Coil Pack is located under the Plastic on top of your Engine and Directly connects to the Spark Plug. If I was you I would Swap the #1 and #3 Coil Packs and see if the Fault Code follows the Coil Pack. If it does then replace the Coil Pack. If it stays with the Cylinder, I would be checking the Connectors, Wires, Injector and Spark Plug.

Mar 07, 2015 | 2009 Toyota Corolla

2 Answers

My 1999 jeep grand cherokee skips after changing the coil and spark plug,what could be the problem


get plug wire tester at parts store and test plug and coil wires if there bad change them to also did you check plug gap?

Nov 21, 2014 | 1999 Jeep Grand Cherokee

1 Answer

How can i fix the missfire on a cylinder toyota corolla 2000 1.8ltr


First you need to retrieve codes from the Engine control module. You can buy a cheap code retriever at harbor freight and get the codes. After you get the codes, if it is P0301 it means cyl #1, P0302 = cyl #2, P0303=cyl 3 and P0304= cyl 4. For ex: if you got P0301 you should remove the ignition coil #1(near the front of the engine, where the pulley is) and change its position with the coil # 2. Also remove the spark plug #1 and change the position with the spark plug #4. Clear the codes and start and run the engine until the check engine light goes on. Check for codes and see if the code change for a different code. If it change the position observe which one is the change. If is P0304 you have a bad spark plug, If it is P0302 you have a bad coil. If it repeat P0301, you have either a low compression, bad injector/connector, bad intake gasket them you should continue your diagnostic. I hope this help you.
Junior.

Dec 17, 2012 | 2006 Toyota Corolla

1 Answer

I have a 1998 Chevy s10 blazer that is running ruff and shaking and bad smell from exhaust like sulfur.When I step on gas black smoke comes out of exhaust.There are no codes when hooked to code...


Check the spark, it should be blue, if it is yellow than you need to check your ignition system, coil,spark plugs, spark plug wires, dist cap, rotor ect.
Black coming out the exhaust is unburned fuel, when you have the spark plugs out do a compression test.

Jul 23, 2011 | 1999 Chevrolet Blazer

2 Answers

My toyota corolla was idline fine then just cut off . no spark in distributor


If your engine cranks normally but will not start and cuts off because it has no spark, or it stalls and won't restart because it has no spark, the problem may be due to any of the following:
A bad pickup inside the distributor a stripped distributor drive gear (common problem with plastic distributor drive gears, broken, loose or corroded wires from the pickup to the ignition module or PCM.
If there is power going from the coil to the dist, but no spark coming out of the dist. the Condenser is bad. Small round thing that has a wire that hooks to the points. If the engine has no spark, check for voltage at the coil positive terminal when the ignition key is on.
If there is voltage, the problem is on the trigger side of the coil (pickup, crank sensor, ignition module or primary wiring circuit).
If there is NO voltage at the coil, the problem is on the supply side (the ignition switch or ignition wiring circuit).
If the coil has voltage, the problem may be a bad high voltage output wire from the coil to the distributor, hairline cracks in the coil output tower, or cracks or carbon tracks inside the distributor cap or on the rotor.You can check this with voltmeter.------------------
That's it.

Nov 18, 2010 | 1990 Toyota Corolla

3 Answers

Toyota Corolla 1999 code p0301


I HAVE A COROLLA 1999 MODEL. IT IS MISFIRING. I CHANGED THE PLUGS AND CHECK ATHE INJECTORS. NOW I DONT KNOW WHAT TO DO BECAUSE THE ENGINE STILL VIBRATES AND THE CHECK LIGHT IS ON

Dec 12, 2008 | 1999 Toyota Corolla

Not finding what you are looking for?
1999 Toyota Corolla Logo

Related Topics:

281 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...