Question about 1996 Cadillac Eldorado

1 Answer

Cannot find flasher blinkers dont work - 1996 Cadillac Eldorado

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cadillac Master
  • 70,347 Answers

Front seating area, driver side, under dash, mounted on passenger side of steering column.

Posted on Dec 09, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blinkers dont work.Bulbs are good.Flashers work.The car was bought with no cover for fuses.Dont know whats what.,to see if its the fuse.Where is that fuse located, and whats the amps


Pull all the 10 amp fuses 1 by 1 until you find the one that is blown. If the 4 way flashers work (as you say) it is likely the fuse. Otherwise... The selector arm. (The lil handle you push up or down for the blinker) 10 amp fuses

Sep 25, 2014 | Cars & Trucks

1 Answer

Turn signals and flashers dont work 1997 c1500


Look near the fuse panel and you will see a cylinder (about an inch in circumfrence) this is your blinker relay. Usually there is a seperate one for flashers and one for blinkers. I am not sure that it would make your front flashers illuminate.

May 11, 2014 | GMC C1500 Cars & Trucks

1 Answer

Blinkers and hazards dont work


check the flasher relay under the dash

Mar 02, 2014 | 1996 Mercury Sable

1 Answer

Blinkers dont work. flashers work


Most GM the blinkers and flashers have seperate relays. But if see your flashers work you know the bulbs are good. So there is one thing out of the way.

The turn signal relay should be a two prong relay on the interior fuse panel. The hazard relay would be one with three. The hazard relay may be on a "convienience" center which is usually tucked way up under the dash.

Sep 23, 2011 | 1994 Chevrolet Cavalier

1 Answer

My blinkers are not working.I replaced fuses and flasher.My hazard lights work but my blinkers still dont.What else could I check.


are you sure you replaced the signal flasher and not the hazard flasher as they look the same.put the hazards on and check to see if it was the one you replaced.if it is then you need to located the signal flasher and replace it.if you still have the old one you replaced you can use it.

May 01, 2011 | 1997 Ford Thunderbird LX

1 Answer

1989 chevy 1/2 ton.brake lights or emergency flashers dont work.tail lights an blinkers work.


The Blinkers and the Brake Lights are the same bulb. So check the brake light switch. Flashers use a different flasher unit, than the turn signals

Dec 16, 2009 | 1989 Chevrolet K1500

1 Answer

TURN SIGNAL, BRAKE & HAZARD LIGHTS


No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below:
Troubleshooting Procedure
To start troubleshooting this problem:
  • Turn the key to the on position (do not start engine)
  • Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
  • When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
  • 1b7f814.jpg

Jul 09, 2009 | 1999 GMC Denali

1 Answer

Have 2001 Cherokee, for some time the blinker will turn on but not blink. If you moved blinker handle up and down they would work, Now it wont work at all. Dont know how to find fuse


likely your flasher unit was failing or you had a bulb out somewhere. Flasher should be on right side of steering column under dash yours could be a "combination flasher" Older models had flashers on fuse box under dash on left side.

Mar 10, 2009 | 2001 Jeep Cherokee

1 Answer

Blinker dont work flasher and other lights work


The turn signals don't work, but the emergency flashers do? If that's the case, replace the flasher, you have 2 flashers, one for emergency (hazard) flasher, and one for the turn signals. It should be on the fuse block under the dash.

Oct 23, 2008 | 1995 Jeep Cherokee

Not finding what you are looking for?
1996 Cadillac Eldorado Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...