Question about 1999 Ford Explorer

1 Answer

1999 ford explorer a/c

I have a 1995 ford f150 and when I go up a steep grade the a/c will turn off. I can live with that. My 1999 ford explorer does any time i excellerate and it makes a sound like some door closed .

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,369 Answers

1999
you have a vacuum leak probably the vacuum storage canister in the engine compartment.
---------------------------------------------------------------------

1995
The a/chas a cutoff for full throttle aceleration so that's why it cuts out on step grades. Let of the gas just a little to get it to stay on.

Posted on Feb 18, 2009

6 Suggested Answers

emissionwiz
  • 60667 Answers

SOURCE: 1986 Ford F250 Brakes

You are boiling the brake fluid and hence the sinking pedal, go to silicone based synthetic fluid, it will not boil, all the old fluid must be flushed from the system before installing this fluid, this should cure your problem for good.

Posted on Sep 22, 2008

  • 255 Answers

SOURCE: Ford 1995 F150 Truck. Turn ignition key off but Truck still runs

ignition switch electrical portoin above brake pedal on steering column

shack

Posted on Apr 14, 2009

  • 1129 Answers

SOURCE: 1995 ford f150 4.9 how to remove a/c clutch

remove drive belt then aquire the clutch removal tool from Auto zone or Napa, there is a specific puller designed to remove this clutch,in some cases in order to hold the pulley while removing center nut or bolt you must use a chain wrench with an old leather belt wraped around the pulley to protect the v-ribs on pulley in order to get the pulley bolt or nut loose the clutch will just turn when trying to loosen center nut if you don't use the chain wrench to hold it, after removing said nut or bolt attach the puller to the clutch and while holding it stationary with the chain wrench proceed to turn the shaft of the puller to remove the clutch, it should pop free after a couple of turns with a socket wrench of the appropriate size. PS use the chain wrench ($22.00 Auto zone) only in the corerect direction it does not clamp effectively either direction. also sometimes there is special holding tool for certain clutches, consult Napa or the dealer before buying the chain wrench it may not be effective in holding the clutch while trying to remove center bolt.

Posted on Jul 08, 2009

Audioaholic
  • 376 Answers

SOURCE: 1995 ford f150 when I push the overdrive button,

cut wire/ or lost ground signal to switch

Posted on Sep 13, 2009

  • 5 Answers

SOURCE: my 1995 ford f150 v8 302 will not start

Ford truck was running fine then it just shut's OFF, afterwards did start once stayed on for a couple of minutes then shut off again. A friend thinks it's the computer after checking the car. Note I did pressure wash the engine 2 day's before and didn't use it till now.

Posted on Nov 24, 2009

sscullys
  • 984 Answers

SOURCE: 1999 ford f150, air bag light flashes 27 what

The PAD ( Passenger Airbag Deactivation ) light is inoperable.

Could be unpluged if you have been working around there, or the bulb could be out.

Radio shack sells the same type bulb, if you are good with soldering it is an easy fix.

Posted on Nov 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause an engine to hesitate on a steep grade or by increasing on the gas pedal???


it sounds like it is trying to flood itself take it to ur local parts store and see what sensor is bad or it may also be ur fuel pump is going bad but I would see what the part store say first

Feb 27, 2015 | 2004 Ford F150

1 Answer

Will a f150 alternator fit into a ford explorer?


i was wondering if a front bumper on a 1999 ford explorer would fit on a 2004 f150 the old body style any help or advice would br great thank you

Jul 09, 2012 | 1998 Ford Explorer

1 Answer

I have a 1995 4x4 f150 & a explorer and nether temp guage will work? help


Hi!!

Look for broken wire or loose connection to water them sensor, usually located in the thermostat housing or very close by. If plug is tight and no visible wire damage present. Replace Temp Sensor.

Don't forget to rate this post!! Good Luck.

May 06, 2010 | 1995 Ford F150 Styleside Regular Cab

4 Answers

How much oil do i put in a 1999 ford explorer when i change


1999 FORD TRUCKS EXPLORER 4.0L 6-cyl Engine Code [E] SOHC
Engine Oil Grade 1......API* All TEMPS......5W-30 Engine, with filter..........4.7 liters
1999 FORD TRUCKS EXPLORER 5.0L 8-cyl Engine Code [P]
Engine Oil Grade 1......API* All TEMPS......5W-30, 5W-20 approved for this application per Ford TSB 02-1-9 Engine, with filter..........4.7 liters
Here's the information your looking for and thank you for using Fixya





Mar 10, 2010 | 1999 Ford Explorer

1 Answer

Ford 1995 f150 ignition key will not reset to run position will stay in start if not turned back


You can try lubricating it with WD40 but you most likely need a new ignition. not sure about your location but if you live in Canada you can check partsource.com

Dec 18, 2009 | 1995 Ford F150 Styleside Regular Cab

1 Answer

1997 F150 4.6l cruise control does not work.where do i start?


Does Ford replaced the cruise control deactivation switch.
Vehicles involved in the recall include the following:

1998-2002 Ford Ranger
1992-1997 Lincoln Town Car
1992-1997 Ford Crown Victoria
1992-1997 Mercury Grand Marquis
1993-1998 Lincoln Mark VIII
1993-1995 Taurus SHO
1999-2001 Ford Explorer
1999-2001 Mercury Mountaineer
2001-2002 Ford Explorer Sport
2001-2002 Ford Explorer Sport Trac
1992-1993 E150-350 Vans
1997-2002 E150-350 vans
1993-1997 Ford F-Series pickups
1993 Ford Bronco
1994 Mercury Capri
2003-2004 Ford F0150 Lightning
1995-2002 Ford F53 motor homes.

May 15, 2009 | 1997 Ford Expedition

1 Answer

1997 Ford Expedition - cruise control won't work. Need a diagram for the fuse block!Help!


Vehicles involved in the recall include the following:

1998-2002 Ford Ranger
1992-1997 Lincoln Town Car
1992-1997 Ford Expedition
1992-1997 Mercury Grand Marquis
1993-1998 Lincoln Mark VIII
1993-1995 Taurus SHO
1999-2001 Ford Explorer
1999-2001 Mercury Mountaineer
2001-2002 Ford Explorer Sport
2001-2002 Ford Explorer Sport Trac
1992-1993 E150-350 Vans
1997-2002 E150-350 vans
1993 Ford F-Series pickups
1993 Ford Bronco
1994 Mercury Capri
2003-2004 Ford F0150 Lightning
1995-2002 Ford F53 motor homes.

Apr 12, 2009 | 1997 Ford Expedition

1 Answer

Truck shakes in four whell drive


I think you may have a problem with the drive shaft angle being to steep, check with a drive line shop for the correct angle, the make special wedge shaped shims to correct this problem.

Oct 04, 2008 | 1992 Ford F150 SuperCab

1 Answer

1986 Ford F250 Brakes


You are boiling the brake fluid and hence the sinking pedal, go to silicone based synthetic fluid, it will not boil, all the old fluid must be flushed from the system before installing this fluid, this should cure your problem for good.

Aug 24, 2008 | 1986 Ford F 250

Not finding what you are looking for?
1999 Ford Explorer Logo

Related Topics:

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...