Question about 1994 Jeep Wrangler

2 Answers

Rear transfer case seal leaking...how do i replace it myself?

Can you please help walk me thru replacing the seal on the rear transfer case on my 1994 jeep wrangler 4 cylinder.
do you have step by step instructions on how i can do this?
please let me know.
thanks!

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

Rear output shaft? you should only have one transfer case :) Ok so put the ebrake on. Put the truck in neutral. Matchmark the yoke to the tcase. remove the bolts that hold on the ujoint. This should drop the driveshaft from the tcase. Use an axle socket to remove the nut holding on the yoke. Tap the yoke off with a soft face mallet. pull out the felt ring. Using a seal puller remove the seal. tap in a new one very carefully. reinstall in reverse order. ensure you torque the nut to the required torque aling with the ujoint bolts.

Posted on Apr 15, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a 1997 ford expedition that has a leek in my transfer case how do I replace that.

Posted on Oct 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Replace main rear seal on a 2005 cayenne s


Lots of tools!!! engine crane, engine stand, tranny stand, fluid collections buckets (collant, engin oil, tranny oil, transfer case fluid.
Remove transfer case, remove tranny. drop oil pan, lossen off rear eng bearing and remove slowly, remove seal materiial from upper seal have, install new seal material in both halfs, reinstall bearing and turgue to specs for bearing, install new seal and reinstall oil pan, reinstall trannt, reinstall transfer case, refill all fluids. start it up and check for leaks everyday for next week. it take 2 people to reomove case and tranny. it wiil take 16-18 hours of constant work for an experienced DYI

Dec 26, 2014 | 2005 Porsche Cayenne

1 Answer

Bellhousing leak


did you just have the fluid replaced in the transfer case?? if the answer is no, the you may have a leak from the series of seals that are internal. you will have to have the transfer case removed and have the CVT seal replaced and other seals inside of the transfer case. lengthy repair and costly also. the transfer case has to be removed to replace the CVT side seal and while you are in there replace seals inside of the transfer case also. that what its sounds like to me. transfer case seal leak or the inside CVT seal leak. however if its leaking right from the bellhousing, it also could be the torque converter seal. this is when proper diagnosis comes to play. if its d converter seal, than the trans has to come out. have this one checked by someone that knows what they are doing. could be transfer case seal leak and it could be converter leak.

Jul 12, 2013 | 2003 Nissan Murano

1 Answer

I am leaking transmission fluid right where the transfer case is how do i replace the gasket?


I assume this is a truck, you will need to remove the driveshaft and then remove the bolts holding the transfer case to trany, theres a gasket that goes there but the real problem is the seal, once you remove the transfer case look inside the rear of the trany you will see a seal that seals that shaft replace that seal there should not be any oil in that space, hope this helps.

Oct 26, 2010 | Chevrolet 1500 Cars & Trucks

1 Answer

What causes the transfer case to leak wher the driveline goes into it


the drive shaft seal needs to be replaced in the transfer case

May 21, 2010 | 1994 Jeep Grand Cherokee

1 Answer

I need to change the real seal in my 94 S10 blazer and i don't know what I have to do! please help?


Hello wizardofoz17: My name is Roger and I will help you. By replacement of the rear seal I assume you mean the rear main seal of the motor. To replace this seal you will need to remove the transmission from the vehicle. Should this vehicle be a four wheel drive then you will also remove the transfer case as well.Remove the flywheel from the engine. Remove the seal from the crankshaft and install the new seal. Reverse the procedure and reassemble the drive train.
Should you be asking about the rear pinion seal of the rear end then please just ask and I will be glad to give you the information. Please rate the answer you received. This way I know it was helpful. Thank You for using Fix Ya. Roger

Apr 14, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

2003 Ford Explorer Eddie Bauer Edition


Don't worry about it,all seals seep,that is nothing but normal wear.unless you see where fluid has leaked out and hit the ground.
It sounds like a commission garage that he went to,and trust me they would just pressure wash those seepage's

Nov 28, 2009 | 1994 Jeep Wrangler

1 Answer

Transmission fluid leaking back, 1988 Ford Bronco


your output seal on the tranny or input seal on your transfer case is bad. you have to pull your transfer case to tell. this is a pretty straight forward job. block wheels. put transfer case in neutral. drop front and rear drive lines.diconnect transfer case shift linkage. there is a short commponent connecting the trans to the transfer case. the bolt on either end face each other. remove the bolts to the transmission. the transfer case is heavier than it looks, i suggest getting help. pull back on the transfer case until it will drop down. it will pull out a bit because of the trans output shaft. replace what will probibly turn out to be the tranny output shaft seal and reassemble in reverse order.

Nov 06, 2009 | 1988 Ford Bronco II

1 Answer

Automatic transmission leaks on my 2000 Rodeo 4wheel drive Any help? Please


If you have never serviced the transmission, it just may be time to have the transmission fluid and filter to be replaced if the transmission fluid is leaking from the transmission pan. If it's leaking from the rear of the transmission where the drive shaft goes in to, then it's the rear seal from the transfer case and the seal needs to be replaced and the transfer case topped off with fluid. If the fluid is leaking from the front of the transmission where the engine connects to the transmission than it's a good chance that it's the torque converter or front pump main seal. The other place that it could be leaking from is the transmission oil lines from the transmission to the cool at the radiator. Please let me know if it's leaks worst when the engine is running or only when your parked for a few hours. Keep me posted, be glad to help. 

Jul 03, 2009 | 2000 Isuzu Rodeo

2 Answers

Rear output shaft seal on transfer case is leaking hummer h2


How to remove axle shaft seal on hummer H2

Feb 20, 2009 | 2005 Hummer H2

Not finding what you are looking for?
1994 Jeep Wrangler Logo

2,223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...