Question about 1995 Mercury Mystique

1 Answer

Eec fuse keeps blowing on mercury mystique

When ever i hit the gas pedal hard my eec modual fuse blows but if i drive it soft it is fine any ideas of what this could be?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

When you go to wide open throttle, the only thing that happens is your a/c cut out is activated by the throttle position sensor. I owuld check there, but it is very rare that the TPS would cause a fuse to blow.
You may have an engine wire harness that has the wiing insulation decomposing causing wires to short against each other. Peel open the plastic convolute and look for cracks in the insulation. Here is info on a Ford program to repair if less than 100,000 miles on your car.

October, 1999
To:
All Ford and Lincoln-Mercury Dealers
Subject:
Owner Notification Program 99M03 - Certain 1995-1997 Contour and Mystique vehicles - Under Hood Wire Harness - Additional Coverage.
PROGRAM TERMS:
This program provides extended coverage on certain under hood wire harnesses through 10 years or 100,000 miles which ever occurs first, from the original warranty start date. AFFECTED VEHICLES
Certain 1995 - 1997 Contour and Mystique vehicles built from Job #1 1995 through Model Year End 1997. REASON FOR RECALL
Under ambient factors of high temperature and high humidity, certain 1995 - 1997 Contour and Mystique vehicles may be susceptible to the wiring insulation becoming brittle and cracking on certain engine compartment wiring harnesses. These harnesses deliver electrical power to the engine and its cooling and control systems, the climate control, and other power distribution systems. If wire harness insulation cracking is found during the additional warranty period, the under hood wire harnesses are to be replaced at no charge to the customer. SERVICE ACTION
Additional Warranty Coverage
Effective immediately, Ford is providing additional coverage for the replacement of the under hood wire harnesses on these vehicles for a period of 10 years or 100,000 miles, which ever occurs first, from the original warranty start date. This coverage exceeds the provisions of the original component warranty coverage on the affected vehicles and is automatically transferred to subsequent owners at no charge. This additional coverage does not include normal service diagnostic or repair charges unrelated to wire harness brittleness and cracking. After this additional coverage has expired, wire harness replacements will be at the expense of the vehicle owner.

eec fuse keeps blowing on mercury mystique - c2d6344.gif
802a4ff.gif

Posted on Jan 12, 2009

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
james klgr
  • 362 Answers

SOURCE: what would cause the eec module fuse to blow in a

mine had a short in the wire had to replace resister in wiring to coil pack

Posted on Nov 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Eec fuse blowed while driving and blows each time replace it


must have a short to earth ,would'nt advise using wire no matter what the situation,trace the wires and find a break or worn part , might be rubbing against a metal edge somewhere

Apr 02, 2014 | 1994 Ford Explorer Limited

1 Answer

Soft clutch pedal


see the diagram attached. God bless you
However you can go to www.automecanico.com and translate this website with your browser and fix it.
9ed66222-4257-4799-ac7e-24aaee63efca.gif

Jul 23, 2013 | 1992 Toyota Celica

1 Answer

On My 1991 Olds Trofeo 3.8 If I Drive Realy Easy It Runs Fine But If I Hit The Gas Pedal To Fast Or Hard It Blows A Fuse That Powers The Inighion Moduel Then It Dies.If I Sit Still In Neutral And Gun The...


Have you checked your motor mounts? Stomping on the gas in gear torques the engine. If the mounts are bad the engine will move (it's not supposed to) and this may strain the wiring harness which can then come into contact with the frame or something that could short a wire to ground. It is very unlikely that the problem is in the ignition module itself or any of the coils, as you probably discovered when you replaced them and the problem didn't go away. Open the hood and have someone rev the engine GENTLY while you watch. The engine shouldn't move very much at all. Check your wiring harness at any possible point of contact if the engine does move and look for cuts, gouges, exposed wiring, etc.

Feb 24, 2012 | 1991 Oldsmobile Toronado

1 Answer

My 02' mdx won't come out of park, keep blowing a 20 amp fuse. This fuse controls the Cruise, break lights, memory seat, horn and linkage. I have to manually delink. I have unhooked the comand...


Here is an idea, when do you blow the fuse key on, key on engine running, key on engine running hitting the break pedal? Try and get the key on without blowing fuse if possible, then one at a time try those circuit loads ie: horn, brake pedal and so on, if you isolate which load is pulling to many amps(blowing fuse) unplug that load itself, then restart testing, see if fuse stays ok. You can also substitue the fuse with a circuit breaker and unplug each load until click(of breaker) stops.

May 17, 2011 | 2003 Acura MDX

1 Answer

Whenever I put the Audi A4 in reverse it shifts fine but when i put in in drive it shifts real hard and when I am slowing down at times it downshifts like something hit me.Where do I add trans fluid?


down the dipstick tube!!!(really)DO NOT OVERFILL...
Your audi is fitted with a fuzzy logic gearbox, it will change according to your driving style.TRY THIS,put into 1st and without touching gas pedal, let the car accelerate to top gear,stop Then using onle 1/3rd gas pedal do it again.then using 2/3rds do it again.then only using the minimum pedal req accelerate to max legal limit.(try not to use brake pedal,let the car slow down itself,until you have to)then drive as normal, it will feel like a different car.

Mar 22, 2010 | 2000 Audi A4

1 Answer

Ford explorer eec relay


Try a new relay first. This may not be good news if that does not work. If you can find the EEC (computer) and unplug it, then replace the fuse-if it blows you have another cheaper part on the circuit thats bad.
If the fuse does not blow, then the EEC must be shorted.
If you have to replace the EEC you may find a kindly dealer with a cash-for-clunker sitting there to violate. Salvage yards have them, Ebay sells them. I have seen them at swap meets for $20. They are a high price part even rebuilt at Dealers or autoparts stores.

Aug 24, 2009 | 1991 Ford Explorer

1 Answer

93 chev silverodo missing on 2 cylinders


This could be a few things. The first thing i would check is the firing order as 2 crossed leads will cause this . If this checks out ok try a compression test. A blown head gasket between 2 cylinders will also cause this. Hope ive helped

Jan 13, 2009 | 1994 Chevrolet C1500

1 Answer

Tranny wont shift


turn key on engine off mash gas pedal to the floor for 15 secs let off of pedal turn key off this resets tcm Tramission (control modual) unless you burmt somthing jumping it.check fuses.
those auto trans are tempermental sometime they get comfused when there is a running prob are more than one driver.try reset proceedure make sure correct fluid level. lots of info on TDI club.

Nov 18, 2008 | 2001 Volkswagen Jetta TDI

2 Answers

E.E.C fuse keeps blowing in 1991 Ford Explorer


sounds like you got a short try tracing harness to see if theres anything visible

May 26, 2008 | 1991 Ford Explorer

Not finding what you are looking for?
1995 Mercury Mystique Logo

Related Topics:

1,855 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

fordexpert

Level 3 Expert

5622 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...