Question about 2003 Chrysler PT Cruiser

2 Answers

Rear wiper blade

How do remove blade to replace - the arm does not swing all the way up like front ones and I can't seem to figure out how to replace. I'm not stupid - just a single mother ...

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

If you still have your '08 Cruiser, I just changed mine (I'm also a Mom)...You have to pop off the plastic cap on the base of the wiper where it attaches to the window, then with a small wrench, take off the hex nut. Work the wiper arm off the spindle, then replace like the front wipers...push old wiper hook up, pull thru, and replace blades per instructions in the blade package...Pat

Posted on Aug 29, 2012

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I took to repair shop...

Posted on Dec 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace rear wiper assembly


The wiper arm has a cover on the left end that pops up after gently spreading the two bottom sides apart. That allows the arm to swing out for cleaning the window or replacing the blade.
The wiper blade assembly attaches to the end of the arm . It is pressed in and will pop out with a little force rotating the left side away from the arm. It pops back in with a little push. The arm remains attached to the rotating shaft assembly.
I believe you can then replace just the rubber blade and not the whole blade assembly, if that is your fancy.
Dave

Oct 18, 2013 | 2008 Toyota Highlander

1 Answer

How to take off the rear windsheild wiper on a 94 grand cherokee


You will need a 13-inch wiper blade for the rear window. 1 - When removing the wiper blade lift the wiper arm away from the window. ----- 2 - With one hand holding the wiper arm press the small tab on the underside of the wiper blade where it meets the wiper arm. ----- 3 - Slide the wiper blade off of the arm by pulling the center toward the bottom of the arm.----- 4 - Lightly lay the wiper arm on the window.----- 5 - Prepare your new wiper blade by taking the curved part of the plastic clip and line it up with the curve of your wiper arm. ----- 6 - Lift the wiper arm and press it through the center of the wiper blade up and over the plastic clip. 7 - Pull the wiper blade up until it clicks. Place the arm back on the window.

Jan 11, 2012 | 1994 Jeep Grand Cherokee

1 Answer

How do i remove the windshield wiper blade


The 1998 Dodge Grand Caravan has the most common hook-end wiper arms. See related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.

1998 Dodge Grand Caravan Wiper Blade Installation Videos (hook front, hook rear)

1998 Dodge Grand Caravan Wiper Blade Size Options w/Correct Lengths & Attachments

Sep 09, 2011 | 1998 Dodge Grand Caravan

1 Answer

02 liberty rear wiper dose not work plugin has power changed wiper motor still doses work


There is a nut under the black plastic bezel that needs to be removed. Here is the complete procedure for you to look at. Its possible that your arm isn't adjust at wiper motor...

REMOVAL
- Disconnect and isolate the battery negative cable.
- Remove the rear wiper arm from the rear wiper motor output shaft. (Refer to 8 - ELECTRICAL / REAR WIPERS / WASHERS/REAR WIPER ARM - REMOVAL).
- Using a small thin-bladed tool, gently pry at the notch in the base of the rear wiper motor output shaft bezel to unsnap the nut cover from the bezel (REAR WIPER MOTOR OUTPUT SHAFT NUT REMOVE/INSTALL). Be certain to take proper precautions to protect the outer tailgate panel and its paint finish from damage during this procedure.
- Remove the nut that secures the rear wiper motor output shaft to the outer swing gate panel (REAR WIPER MOTOR OUTPUT SHAFT NUT REMOVE/INSTALL).
- Remove the bezel and gasket from the rear wiper motor output shaft.
- Remove the trim panel from the tailgate inner panel. (Refer to 23 - BODY/SWING GATE/TRIM PANEL - REMOVAL).
- Disconnect the tailgate wire harness connector for the flip-up glass ajar switch from the flip-up glass latch connector receptacle.
- Disconnect the tailgate wire harness connector for the rear wiper motor from the motor connector receptacle (REAR WIPER MOTOR REMOVE/INSTALL).
- Loosen the two screws that secure the rear wiper motor mounting bracket to the top of the tailgate inner panel.
- Slide the rear wiper motor and mounting bracket forward far enough to disengage the two mounting screws from the keyed slots in the top of the tailgate inner panel.
- Remove the rear wiper motor and mounting bracket from the tailgate as a unit.

zjlimited_494.gif

1 - BEZEL AND GASKET
2 - OUTPUT SHAFT
3 - TAILGATE OUTER PANEL
4 - NUT
5 - NUT COVER

What you will need to do is to remove the small plastic cap on the wiper arm by prying it off with a screw driver. Then remove the nut that holds the arm onto the shaft. Then get yourself a battery cable puller (from auto parts store) and pull the arm off of the shaft..

zjlimited_495.gif

1 - SPARE TIRE
2 - WRENCH
3 - FLIP-UP GLASS
4 - PARK RAMP
5 - REAR WIPER ARM
6 - PIVOT COVER

Jul 19, 2011 | 2002 Jeep Liberty

1 Answer

Can't remove rear wiper to replace on 96 caravan


Lift wiper arm from rear window. then release latch that holds the blade to the wiper arm.( It's small tab)

Jan 16, 2010 | 1996 Dodge Caravan

1 Answer

How to replace the wiper insert at the back of


moz-screenshot.jpg
  1. REMOVE RR WIPER BLADE
    1. Raise the rear wiper blade to the position as shown in the illustration where the meshing of the claw disengages with a clicking sound. NOTE: Be careful not to break the claw.
    2. Pull straight the rear wiper blade to vehicle's left from the wiper arm. NOTE: Do not fold the rear wiper arm with the rear wiper blade removed from it.1722d05.gif

  1. REMOVE REAR WIPER RUBBER
    1. Place the rear wiper with the rear end of the rubber protruded from the blade stopper as shown in the illustration. NOTE: Do not pull out the wiper rubber forcibly, as the backing plates will become deformed or the blade claws will become damaged. HINT: The rubber can be easily pulled out by pushing the middle area of the blade.
f54b10a.gif
  1. INSTALL REAR WIPER RUBBER
    1. Install the 2 wiper rubber backing plates to the rear wiper rubber. NOTE: Be careful to observe and keep direction of curvature for correct replacement.
0dd144d.gif
b. Insert the rear wiper rubber from the claw of the middle of the rear wiper blade into the rear end position.
8f40009.gif
c. After passing the rear wiper rubber through the rear end side claw, protrude it from the rear end stopper and pass it through the front tip side claw.

Sep 12, 2009 | 2005 Toyota Matrix

3 Answers

How do you change the rear wiper blade on a 2007 Prius


either you go to the dealor and get a whole new arm wich is toyotas solution to the problem or you go to the auto parst store and ask them for 16 inch insert not a blade just an insert most stores will even instal it for you

Aug 26, 2009 | 2007 Toyota Prius

1 Answer

1993 jeep cherokee country series--replace windshield wipers


Are trying to remove the blade or the arms?

The arms are released by holding the wiper blade fully extended away from the winshield and wiggle the arms off.

The blades are removed by a little tab where the blade hooks to the arm,using a small screwdriver push down on tab,and slide blade off arm but do not let arm slap windshield as it could crack it,I have seen people pull and the blades suddenly come off and the arm slaps down,yor can put a towel or cloth down where the arm sits against the windshield to prevent the possibilty of the arm slapping down.

Dec 25, 2008 | 2001 Jeep Grand Cherokee

1 Answer

Problem removing rear wiper on 2006 honda pilot


You can't replace the wiper. But Parts department at any Honda dealer should sell the replacement blade (just the rubber part). I believe it was under $10. Good luck!

Nov 26, 2008 | 2006 Honda Pilot

1 Answer

SW2 Rear Wiper Replacement


There is a clip on the base of the wiper arm that swings out. Then you just lift the wiper arm up and off. Very simple once you know what to do. ( no, I'm not that smart. A guy at NAPA showed me how to do it.) Hope this helps. B.

Sep 29, 2008 | 2000 Saturn SW2

Not finding what you are looking for?
2003 Chrysler PT Cruiser Logo

395 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...