Question about 2000 Volkswagen Beetle

2 Answers

Headllight replacement 2003 bug

Won't go back in and click have tried everything is there a trick?

Posted by on


2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.


    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 111 Answers

Yeah had this just takes lots of patience a little jiggling and lots of prayer and wala it goes right back in.

Posted on Mar 15, 2010

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Wipe off all the dirt then break out the WD-40! just remember,cheesy plastic breaks ez,costs plenty.

Posted on Sep 14, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 1997 Subaru Impreza won't turn over.

here is a trick ...jump it off and unhook + batt cable if car shuts off alternator if stays on replace batt

Aug 16, 2012 | 2002 Subaru Legacy

1 Answer

All my remotes won't unlock passenger doors, why?

this is a problem that can appear after your car battery died, cause the car didn't reset propely, so taking the battery out and putting it back in or letting your car die again would do the trick. I tried a lot of reprogramming procedured for my remote key, none of them worked, what did the trick though was simply unlocking the doors via the all door unlock button on the passenger side door, so simple.

Apr 27, 2012 | Cars & Trucks

2 Answers

Hi my 2006 Jeep Liberty won't start or turn over all keep hearing is this click sound when I turn the ignition , Plus I just replaced the battery .

Probably a starter. It sounds like the starter solenoid is working, but the starter motor is not energizing.

You could try this simple trick, but Im about 85% sure you have a bad starter.

Have a buddy help you push the vehicle in neutral for a short distance. When you get it moving at a walking pace, put the transmission in Drive, and let the vehicle come to a stop. You may hear a little clicking, but thats OK, it wont hurt anything. Put the transmission back in Park and try to start the engine again. Sometimes the starter gear gets stuck on the flywheel and it wont engage when you try to start the engine. This trick may move the flywheel a little so the starter can engage.

Mar 27, 2012 | 2006 Jeep Liberty

1 Answer

2003 impala everything works won't start won'crank

If you try to start the vehicle and there is a click when you turn the key, but does not start, you may have a solenoid problem. This is usually about 3 inches long and 1.5 inches in diameter and attaches to your starter. Try giving it a sharp tap with a hammer as this is often enough to loosen contact points inside.

Aug 13, 2011 | 2003 Chevrolet Impala

1 Answer

Both dim headllights went out at the same time. both bright lights still work. whats wrong

1st, switch #46 relay with the one right next to it, see if your lights go back on, if so clean the contacts of relay # 46 in the fuse box. If this doesn't work, replace it.

Nov 17, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

Im trying too locate the throttle position sensor on a 2003 chevrolet tahoe an how too replace?

1. Locate your airfilter box 2. Follow it back to the throttle body there you will find it mounted to the side. Replacement is simply 2 screws and no tricks to installation.

Oct 25, 2010 | 2003 Chevrolet Tahoe

1 Answer

Headllight replacement

The newer models usually don't have to have the entire bulb replaced. Under the hood you should be able to look behind the light in question. Reach down where the wiring goes to the back and twist the bulb casing to the right and pull it out. There should be a sorta hologin type bulb. How ever if you have a model that it is just wires that plug into the bulb with no plastic casing then the whole bulb might need replaced like the old days. Let me knpow how it turns out. Please bekind to my attemp to help. I can't see what you have. A thumbs up for the effort would be greatly appreciated, Raz

Apr 19, 2010 | 2002 Pontiac Sunfire

1 Answer

Replace front turn signal bulb

On most of these cars you can open the hood, reach in behind headllight, find the plastic ring behind headlight, turn counter-clockwise and remove the ring, Then take the bulb, turn and pull that out.
Now that everything is out, unclip and pull off the wiring harness and replace with new bulb.
Put new bulb in, put in socket and turn to lock in position, then slide down plastic ring and turn and lock this into position.

Nov 25, 2009 | 2002 Audi A4

Not finding what you are looking for?
2000 Volkswagen Beetle Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

79865 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides