Question about 1995 Nissan Pickup

1 Answer

Right side headlight stays on after switch shutoff

95 nissan xe pickup right head light low beam stays on after switch on turn signal lever is turned off. Gets brighter when switch is on. Brights still work normally.

Posted by on

  • hitzemang1 Dec 09, 2008

    relay is opaque. can't see inside.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Have you looked into the relay?

Posted on Dec 09, 2008

  • jaguar5584 Dec 09, 2008

    i didnt mean literally look inside, try swapping it out with one from a junk yard.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Right low beam headlight does not come on but my right turn signal will stay even tho i diddnt turn it on. If I cut on my high beams the rurn signal cuts off. Whats wrong? Helo


It could be the lamp control module !
Headlamps
Battery positive voltage (B+) is applied at all times to the lamp control module (LCM) through the underhood fuse block HDLP fuse.
When you place the headlamp switch in the HEAD position, the headlamps input to the LCM is grounded. The LCM then applies battery positive voltage (B+) through the underhood fuse block HDLOBML fuse and HDLOBMR fuse, which feed the left low beam headlamp and the right low beam headlamp respectively. When you activate the headlamp dimmer switch by pulling on the multifunction lever until the switch clicks, the high beam input circuit to the LCM in grounded . The LCM then removes battery positive voltage (B+) from the low beam headlamps and supplies battery positive voltage (B+) through the underhood fuse block HDHIBML fuse and HDHIBMR fuse, which feed the left high beam headlamp and the right high beam headlamp respectively.
Check this fuse in the left under hood fuse box first. HDLOBMR Fuse 18 10 Amp. RH Low Beam Headlamp . If the fuse is good check for B+ voltage with the low beams on . Use a test light or volt meter . If you look on top of fuse there are two metal tabs ,check there for B+ voltage , If no B+ voltage the LCM - lamp control module isn't supplying any .
Lamp Control Module (LCM)
Under the left side of the IP, to the right of the steering column
Turn Signal Flasher
Under the left side of the IP, to the right of the steering column
Lighting Systems Component Views in Lighting Systems
Lighting Systems Connector End Views in Lighting Systems
Turn Signal/Hazard Switch
In the left front of the passenger compartment, in the steering column

Apr 28, 2016 | 2000 Buick Park Avenue

1 Answer

Isuzu Pickup 1989 multifunction turn switch headlights wont stay on


both high and low beams fail?????
if highs fail, does pressing the flash lever wake up HIGHS?
all 4 elements fail, hi and low? left and right?
a Blast from the Past,
not many 89 cars on the road today.
nor any working 100% , not ever. that old. (unless i own it)

head lights on this car are cave man simple.
super simple... so simple any tech can fix them.
a fuse , light and a switch, and Zero computers or NASA engineers needed.
i do blast from past here., my bag.
first i tell you now,, im answering for USA only
as Canada cars have DRL lamps, we dont.

this is 1987 , no 89 in my set.

there is the path that is broken.
try a fresh fuse first. they can have internal cracks(micro)
50cent fix if lucky.
check for burned pins


25895719-gulfqn0rsmd1zwbqhnkn4a4e-2-0.jpg

Oct 06, 2015 | 1989 Isuzu Pickup 2WD

1 Answer

Nissan pickup I shut off the pickup the left low beam stayed on I bought a headlight/turn signal switch everything works now except the left low beam will not come on


Did you actually check the bulb? It may have burned out or the wiring to it may have lost connection. Some of these vehicles actually have a separate fuse for the left and the right headlights.

Feb 24, 2015 | 1995 Nissan Pickup

1 Answer

My light problem is i have low beam on right side no low on left side i turn highs on and right side goes out and high on left turns on then when back to lows beams and i pull turn signal to flash high...


If you have separate bulbs for the low and high beams(4 light system), if you pull the turn signal and hold it, all 4 lights will stay on until you release the turn signal. You need to replace the bright bulb on the right side and the low bulb on the left side. If your headlights only have one bulb on each side, then you will have to replace both of them to get everything to work.

Jan 04, 2011 | 2000 Ford Mustang

1 Answer

I have a 95 Nissan 4X4 pickup. I have had this


It seems like you have a bad ground wire or a short.

May 26, 2010 | 1995 Nissan Pickup

1 Answer

Turn Signal Lever 2004 Ford Focus LX


$35 sounds right for the lever. It definitely sounds like it's your lever acting up as the contact seems to be stuck

Oct 02, 2009 | 2004 Ford Focus

2 Answers

The headlights are stuck on high beam.


pull on the signal lever toward you (ceter position). the signal lever controls the head lights either high beam or low beam. if you pull on the signal lever toward you again, you will have high beam temporarily. and if you push the signal lever towards the front, you will have the high beam locked.

Jan 12, 2009 | 1990 Buick Regal

2 Answers

95 pathfinder only 1 headlight comes on both bulbs good


im a mechanic who owns a1995 pathfinder, had the same problem.your trouble is in your daytime running light module. try giving it a tap, bet they will come back on

Jan 08, 2009 | 1995 Nissan Pathfinder

1 Answer

Lights turn on slowly


I found the problem was with the headlight switch. I took the housing off and inspected the contacts for the light switch. Over the years the dielectric grease was causing the hi beam post to get stuck enough to make a hi resistance connection. Once the truck warmed up the grease on the post, it would slide back into the "off" position. I cleaned up the plastic and relubed it. All is well and my buddy is happy he didn't bring it to Nissan who quoted him $120.00 to fix it.

Oct 08, 2008 | 1983 Nissan Pickup

Not finding what you are looking for?
1995 Nissan Pickup Logo

354 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...