Question about 1994 Pontiac Trans Sport

1 Answer

Erratic Blower Behavior

I've got a 92 Trans Sport (3.8L) with about 102K miles on her. With the heat on and the fan set on any speed, the blower will cut out momentarily but kick back in after a second or two. Any suggestions as to the root of the problem? I was thinking of replacing the blower motor. Thanks for any help. George Same erratic behavior with minor additions, the blower motor only runs on high setting, anything else and motor does not run. resistors maybe??

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 153 Answers

The blower motor resistor can cause eratic behavior and the loss of some speeds and not others. I would check this first before replacing the motor.

Posted on Dec 08, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2004 crown vic. only 63K miles on her. AC/heat fan was sporadically working, now its done. AC was nice and cold, working fine. Is the fan a hard replacement if I were to find one at a parts yard?

Try to check the power and ground on the blower fan. If you missing the ground on the blower fan connector than most likely it is the blower fan resistor (controller), it is located under the hood close to back firewall behind left cylinder head.

Aug 17, 2015 | 2004 Ford Crown Victoria

1 Answer

The fan is not working

Prob blower motor resister check voltage at blower motor and grounds at the resister connector while changing speed setting will come on the different wires in that connector if you have powers and grounds at the blower motor it's a bad blower motor

May 27, 2014 | 2002 Mitsubishi Montero Sport

1 Answer

1992 chevy C1500: Heat works on low speed, no medium, and high only works intermittantly.

On any other vehicle it sounds like the blower fan switch.
The fan switch provides power or ground to the resistor and there would be a high speed blower relay to bypass the resistor.
But in your case the fan switch is part of the controller.
I don't have a diagram for a 92 but the 94 model shows relays for low medium and high speeds. Each relay gets power from a fuseable link. The high relay gets power thru the low relay if the low relay is not engaged.
If you have the model with 3 relays you may need to check them.

Feb 01, 2013 | 1992 Chevrolet C1500

1 Answer

Blower not working 1998 ford escort sport

there is a fuse but check the blower connector for power, if you have power at blower it may be a bad blower resistor, this is located near the blower bolted to heater box, this is what sends the ground to blower to complete the circuit and control the speeds.

Jan 23, 2013 | 1998 Ford Escort

1 Answer

Heater blower motor.,Highspeed only works..problem??

9 out of 10 times its the heater fan resistor doing this. it has wires that corresponed to diffreent speed settings for heater fan. the resistor is beside the blower motor, Your Kia Sportage Blower Motor Resistor controls the heating equipment in the vehicle by opening and closing the fan motor. The Kia Sportage Blower Motor Resistor allows the heating and climate control system to control the speed of the vehicle's cooling fan. its under the passenger side glove box. undo 2 screws and disconnect the electrical connector. thats it!!

Jan 24, 2012 | 2000 Kia Sportage

2 Answers

I have a '92 park avenue with the automatic


Mar 19, 2010 | 1992 Buick Park Avenue

1 Answer

How do i remove the fan wheels from my 92 accord heater motor?

Difficult to describe without pics, but…:
Once you’ve removed the glove box (I assume you’ve done this, and maybe you already have the motor out, in which case you can ignore most of this down to the underlining)
If the vehicle is equipped with air conditioning, remove the strap bolt (between the two nuts for the evaporator on the left and the two nuts for the blower housing (the housing is probably white) on the right, just a bit lower than those) then the blower under-cover and the three blower housing retaining nuts (two nuts at the top, already mentioned, and the nut at the bottom, which is roughly between the evaporator on the left and the blower housing cover on the right).
Pull the housing out far enough to unplug the electrical connectors (at the lower right edge, right above the kick panel) and remove the blower assembly housing.
If you’re replacing the blower motor itself, or either of the blower fan wheels, separate the two halves of the housing, remove the motor, remove the retaining clip(s) and remove the fan wheel(s). Easier said than done in may cases. The wheels, from heat and cold over many years, become very set on the blower rod. You'll have to work them off using whatever break-free lube you can find to do it, and a good deal of slight twisting, etc.
Installation is reverse. Then check for proper operation, before you put them back.
Hope this is at least helpful.

Dec 20, 2009 | 1992 Honda Accord

2 Answers

I?ve had many blower fan motor failures in such a short time?

This is Typical around this YEAR, if the Blower Resistor Is ok they should give you a Few Years service. The VOLTAGE READINGS Are GOOD that your Friend Checked. Be Sure the GROUNDS are RENEWED on these Vehicles as POOR GROUNDS are Pretty Typical for failure also around that Year

Sep 20, 2009 | 1995 Toyota T100 Xtracab

1 Answer

1996 Deville AC/Heater Blower (Fan) Stopped Blowing

I would recommend a salvage yard to get a good used one alot cheaper also try this place they carry only GM parts: Schram Auto and truck parts 1-800-292-1032 and also explain to them the problem you are having and these guys can assist you in getting the right part

Feb 04, 2009 | 1996 Cadillac DeVille

Not finding what you are looking for?
1994 Pontiac Trans Sport Logo

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides