Question about 1999 Pontiac Montana

1 Answer

Changing fog light bulb

I have a 2002 pontiac montann. how do i access to change bulb in lower front bumper.

Thank you kindly

Larry
canada

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

You will have to remove the skirting around the front fenderwell of the tire (just a couple of screws really), enough to be able to get you hand to the back of the fog light socket and undo the light.

Posted on Jan 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change my front fog light bulbs on my renault laguna 2 2002 model cheers steve .


Easy way - you have to take down the underside splash panel to get access to the fog lamps not so difficult - OR, remove the bumper, longer harder - Firstly lift the bonnet and the front grille is removed by pressing a plastic tag to release the grille in the centre as you look down, use an open ended 17mm spanner which seemed to do the job well, the grille should then be removed. From underneath you will need to remove some 10mm bolts that hold the bumper trim to the subframe, and release the side plastic quadrants by removing 1/2 20 torx screws, a couple of black plastic mushroom clips. Behind the inner wheel arch liners in line with the top of the bumper there is one 10mm bolt to be removed each side and then you should be able to slide the bumper forwards to release it. I believe your vehicle will have headlamp washers, so you may need to disconnect the washer piping at the quick release union behind the bumper, but if you are just resting the bumper on the floor, you can leave all connected and remove the 10mm nuts for the fog lamp in question, release the wiring connector and swap over the unit. I would also advise checking they work before refitting. As long as you don't have any seized bolts etc the front bumper should take no more than 30 minutes to remove and refitting is even easier as you know how it all fits together. Access to all of the fixings is quite easy, just a little tricky for your first time until you realise where they are. Not a great deal holds the front bumper on in all honesty. I hope this helps. Kind regards Also see:-
Read more: How to change a Renault LAguna front fog lamp - JustAnswer http://www.justanswer.com/uk-car/2rzo5-change-renault-laguna-front-fog-lamp.html#ixzz26AFagyaU

Jan 05, 2011 | 2001 Renault Sportwagon

1 Answer

How do I change my fog light bulb in my 1999 oldsmobile alero


YOU HAVE TO REMOVE FRONT SPLASH SHIELD TO REPLACE FOG LIGHTS.THEN YOU REMOVE THE TWO BOLTS RETAINING THE FOG LAMP TO THE BACK OF THE FRONT BUMPER REINFORCEMENT BEAM AND LOWER THE FOG LAMP.

Apr 30, 2010 | 1999 Oldsmobile Alero

2 Answers

I cant get to the lower fog light housing on my 98 trans am


yes u get it at the bottom,,u have to remove the splash guards to get to it,,

Feb 20, 2010 | 1998 Pontiac Firebird

1 Answer

How do I replace fog lights on my 2002 Hyundai Santa Fe?


Look up into the bumper and see if you can access the fog light. The bulb should just twist out of the back. If not, the assembly should either pop forward or back to come out. I've heard though, that many santa fe's require the removal of the entire front bumper fascia just to get to the bulbs in which case you'd have to remove your headlights to get to the screws holding the bumper fascia on

Sep 09, 2009 | 2002 Hyundai Santa Fe

2 Answers

How to replace fog light bulbs


hi..You will have to access the fog light bulb from below the vehicle.
Remove the plastic clips from the wheel well cover extension that is
below the fog light.once the clips are out and the plastic cover is pull
down,you should be able to see the back of the fog light.you can try
to replace the fog light bulb by removing the two 10mm bolts and slide
the fog light assemble out through the front of the bumper.Turn the cover
of the rear of the fog light and replace light.
try this out..
thank u..
kindly rate my response..

Jun 14, 2009 | 2004 Toyota Celica

1 Answer

How to change fog light bulb


Open the engine hood and you'll see there is a plastic housing holding the head light ans side light to the frame. There are two wing nuts and one wing bolt holding it all together. Remove those and pull the headlight and side light housings out from the frame. You'll be able to access all of the lights now.

Jun 10, 2009 | 2002 Pontiac Montana

1 Answer

Fog/driving light bulb replace


There is a panel under the corners of the bumper that is held by two screws. You can access the Light bulb by removing the panel, careful that when installing the new bulb's. Try to keep from touching the glass and it's a go thing to change both side. Good luck

Mar 14, 2009 | 2003 Pontiac Montana

1 Answer

Changing fog lamp in 2002 corvette


you need to take off the lower splash sheilds on bumper they are retainer or bolted 10mm or retainers just pull the center and then pull out/ Please rate my response thank you very much

Jan 30, 2009 | 2002 Chevrolet Corvette

1 Answer

Changing Fog Lights


if you look directly under the bumper just under the fog light you will see a bracket that holds a 13 mm bolt. undo that and pop the light out from the front of the bumper and replace the bulb. install is the reverse

Aug 19, 2008 | 1999 Dodge Neon

2 Answers

FRONT FOG LIGHTS


the entire front bumper has to be removed to access bulbs

Jun 15, 2008 | 2005 Renault R5

Not finding what you are looking for?
1999 Pontiac Montana Logo

277 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...