Question about 1989 Chevrolet K1500

1 Answer

89 chevy 350

Truck will start and run for a bit then it dies out and i cannot get it running again unless i wait for a long period of time.the service light is on but i cannot retreive any codes with my code reader. I was able to read the codes before but now it will not send me any codes . The truck also backfires when it is running and you step on the gas

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Bad gas or bad ignition 

Posted on Dec 11, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

03 Ford Focus starts and run for short period of time and dies then starts and runs again for short time again.


During one of the times that it runs, take it to your mechanic, and ask them to change the fuel filter

Dec 02, 2016 | Ford Cars & Trucks

2 Answers

Just turns off on it's own, Wait 60 sec. restart press pedel it dies.


This engine is electronically controlled so the first thing that must be done here is to have the systems control computer tested for fault codes and then do the proper diagnostics based on those codes.

Jun 07, 2012 | 1995 Plymouth Voyager

1 Answer

Once my blazer gets up to 55 and runs a little while, i start to lose rpms and when i give it gas it does nothing unless i give a very little gas until it dies down to nothing. if i pull over and wait few...


Sounds like you are running out of gas. When was the last time you changed the fuel filter? PO 300 means there is a miss fire which can harm the catalytic converter. It could also be a ignition problem. Coil pickup. Without hands on diagnosis it is hard to exactly pin point the problem.

Aug 08, 2011 | 2001 Chevrolet Blazer

2 Answers

My Saturn has been sitting in my driveway for about a year and a half. We just replaced the battery and the fuel filter and when I try to start the car, the engine turns over, starts for a minute, and then...


If the gas in tank is that old you need to drain it. Once you have good new,clean fuel in tank. Turn key to run position,(do not energize starter just want red lights on dash to come on) listen for fuelpump whine. It will shut off. Turn key off.Turn key to run again, listen for fuelpump again. Turn off key again. Repeat this procedure total 5 times. On last time turn key to engage starter. It should build up enough pressure & fuel & start right up.

Jul 01, 2010 | 1999 Saturn SL

1 Answer

The service engine light stays on. We have


The problem you describe sounds like what I had a few months ago. Have the trouble code checked at Autozone for free and if you get 172 & 174 then you have isolator bolt problems (The engine is running lean). The fix is to replace the isolator bolts ($7 each) and clean the ports. Should take about an hour or two. Contact me at cmckllar<at>bbtel<dot>com for futher help.

Oct 05, 2009 | 2000 Ford Windstar

1 Answer

It just stops running no kinda actual sign. the service light on


Crank sensor monitor. Just had mine replaced.

May 28, 2009 | 2002 Saturn VUE

1 Answer

1996 chrysler sebring 2.5l v6 dies randomly


it sounds like it the crank pos. sensor

Apr 04, 2009 | 1996 Chrysler Sebring

1 Answer

1991 Mazda truck starts, then dies unless


Not a solution but i am going through the exact same nightmare and same symptoms with my 1991 mazda b2200. I've apwnt over two grand to have my rebuilt TWICE and my alternator replaced and still does the same thing just starts only to die 2 seconds or so later unless i let it warm up to its max but will still die when taking turns and stopping at lights.

Mar 23, 2009 | 1991 Mazda B-Series

2 Answers

2000 s10 Blazer dies very 3-6 weeks for no reason


i would check your ignition system. you would need a meter for this but look for broke or loose connections. if it was a fuel problem i dont think it would just start up after 20 minutes. or you might try your ignition switch. if its shorting or something then ya well it would cut your engine off real quick

Mar 20, 2009 | 2000 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...