Question about 1998 Ford Taurus

1 Answer

No heat I am not getting any heat in ford taurus sho 1998...i was told i may need a temperature sensor valve..where does it go on the car

Posted by on

  • 1 more comment 
  • hine57 Dec 20, 2008

    help

  • budman7554 Jan 11, 2009

    need to fine the sensor,s in the car 1996 sho for the coolant temperture

  • Anonymous Jan 25, 2009

    is there a fuse for that? I have changed the thermostat and still no heat.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 260 Answers

If the engine temp is good (approx 200 degrees) you may have a clogged heater core. if engine temp is too low (less than 160 degrees) you may need thermostat

Posted on Dec 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Where is the crank sensor on a 1994 ford taurus gl


What engine? 3.0 DOHC 3.0 OHV 3.8 liter

Apr 10, 2013 | 1994 Ford Taurus

1 Answer

3.2 liter yamaha engine manual IAC valve How do I replace the IAC valve on this engine? Steps? I just bought a new one and I need to get it replaced. FORD 1994 Taurus SHO 3.2 liter engine YAMAHA


may just need cleaning with carb cleaner.

here is 1996, oldest I have:

Section 03-14: Engine Controls, Electronic 1996 Taurus, Sable Workshop Manual
REMOVAL AND INSTALLATION Idle Air Control (IAC) Valve Removal
  1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
  1. Disconnect the engine control sensor wiring (12A581) from the idle air control valve (IAC valve) (9F715) at the idle air control valve electrical connector.
  1. Remove the two idle air control valve retaining bolts.
  1. Remove the idle air control valve and idle air control valve gasket.
Installation
  1. NOTE: If scraping is necessary, be careful not to damage idle air control valve gasket surfaces, or drop material into intake manifold (9424) or throttle body (9E926) (depending upon application).

    Clean idle air control valve gasket mating surfaces.
  1. To install idle air control valve, reverse Removal procedure.
  1. Tighten the idle air control valve retaining bolts to 8-12 Nm (71-106 lb-in).
33b4417.gif

Jan 14, 2010 | 1994 Ford Taurus

1 Answer

IT is a 1998 taurus SHO model very rare it seems to be. Why can't I find a place that will sell me a Ford Taurus Manual for a 1996-1999 taurus SHO model with the 3.4 V8 yamaha engine.


If you are looking for a haynes manual or something which are based on complete tear down and rebuilds of the car, i would see if on the book itself it lists your engine, yamaha only made one car engine really and it was for the SHO which is fantastic however rare, look online and in google for a manual that lists your car, if you are not a fan of buying online, try phoning a company but unless the book you are searching does not list your engine it might cover all the rest but not your powertrain.

Here is a book i found online its a chilton.


http://www.autorepairmanuals.biz/site/573683/product/080199117X

Dec 10, 2009 | 1998 Ford Taurus

2 Answers

1995 Ford Taurus Sho 3.2 check engine light blink 3 3 1 3 3


Code 33 is EGR opening not detected, this is caused by a plugged EGR exhaust passage in the upper intake manifold, this is a common SHO engine fault, the valve works but the engine does nothing that the computer can sense, since no gas flows, to verify this is the problem open the egr at idle, the engine should almost die, if nothing happens or only a tiny change in idle speed or quality the passages are plugged, if it does stall or get real rough the egr position sensor (usual code for sensor is 32) may be faulty or the valve is sticking. I was a ford dealer tech for 30 years and did quite a few of these, there is a TSB (technical service bulletin) about this problem

Oct 12, 2009 | 1995 Ford Taurus

1 Answer

I have a 1995 Ford Taurus SHO 3.0 liters. I


Hi did you do a continuity check check if there's a wire shorted or open you'll need a volt meter check if the wires on the crank sensor going to the control module and also the one from the coil to the module there has to be a shorted or open wire check this and get back to me good luck

Sep 04, 2009 | 1995 Ford Taurus

2 Answers

My 95 Taurus Sho 3.2L, stalls every day. All lights comes on when it stalls. The coolant reservoir is full but, the light in the panel shows LOW COOLANT. Ford Dealer can't find the problem. They used the...


Will it stall if you keep your foot on the gas like the Idle speed is set low? Possible Idle speed motor? I'll have to look up the location of the low coolant sensor.

Jun 07, 2009 | 1996 Ford Taurus

1 Answer

Ford Tauras Pulley has gone bad


Drive Belt Tensioner—3.4L SHO Engine

0a7a73f.gif Is this one you need.
Base part number is 6B209. needs prefix & suffix

Apr 29, 2009 | 1998 Ford Taurus

1 Answer

No spark on my 98 ford torus sho


it is the cam or crank sensor

Mar 15, 2009 | 1998 Ford Taurus

2 Answers

1995 Ford SHO


your best bet for a diagram is to ask for a suspension printout at your local dealership. Or take a look under any 86-95 Ford Taurus SLO, SHO, or Sable and they use the same design (the SHO just uses slightly different parts. Here is a link though for a SHO parts list with part numbers. Hope this helps.

http://members.bellatlantic.net/~rbruce/SHOParts.htm

Mar 12, 2009 | 1995 Ford Taurus

1 Answer

Check Engine Soon light


auto zone does not trouble shoot cars older then 2000 advance does the same i have never heard a lose gas cap on a 98 taurus causeing that light to come on u are better to get a estimate on what the trouble is and see if it is worth fixing Looking forward to helping u Shaun

Oct 25, 2008 | 1998 Ford Taurus

Not finding what you are looking for?
1998 Ford Taurus Logo

Related Topics:

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...