Question about 2002 Nissan Xterra

1 Answer

Passenger side mirror wiring harness nissan xterra

I broke my mirror off and i dont know where the wires connect i have the mirror hanging by the wires now

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 60 Answers

Take your door panel off slowly and unplug your mirror from inside the door

Posted on Dec 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How d I swith passenger side mirror on a power mirror on a 2004 Jeep Grand Cherokee limited edition


no symptoms posted (broke glass or ???) can we be on same page?
"how do I switch," verb switch , the mirror as switches inside, too.

please say what that word means. switch and the failure.
1: remove and replace with new.
2: move right to left and left to right side.

why would you do that #2
fold away mirrors/ Export only (this is usa forum so..)
these,NASA grade mirrors are very complex... not just glass and plastic. heaters ,motors, memory , etc.

the FSM cover all tests for the mirror, including scan data.

ill quote the FSM now , 8 steps (just 1 fail,not heat, not memory failure or fold failure)
ONE MIRROR INOPERATIVE
(1) If the one inoperative mirror is on the passenger
side, go to Step 2. If the one inoperative mirror is
on the driver side, go to Step 3.
(2) Check if the passenger front door will lock and
unlock using the power lock switch on the driver side
front door. If OK, go to Step 3. If not OK, go to Step 6.
(3) Disconnect and isolate the battery negative
cable. Remove the trim panel from the front door.
Disconnect the 12-way mirror wire harness connector
from the door wire harness connector.
(4) Using two jumper wires, test the mirror as
shown in the Mirror Test chart (Fig. 2). If the mirror
tests OK, go to Step 5. If the mirror does not test
OK, replace the faulty mirror.
(5) Disconnect the 12-way door wire harness connector
from the door module connector receptacle.
Check all of the circuits of the door wire harness
between the connector for the mirror and the connector
for the door module for opens or shorts. If all of
the circuits are OK, replace the faulty door module.
If any of the circuits are not OK, repair the open or
shorted circuit(s) as required.
(6) Use a DRB scan tool and the proper Diagnostic
Procedures manual to test and repair the faulty Programmable
Communications Interface (PCI) data bus
communication between the two door modules.

(bar stool answer) all cars. mostly
pull door skins
unplug motor conn.
unscrew mirror base from door.
extract mirror,

Mar 07, 2015 | 2004 Jeep Grand Cherokee

1 Answer

Dashboard lights dont turn on as well as tail tights


If you confirm the side marker lights,tail lights,fog lights and/or dash illumination are inop,and fuse number 39 is open,the wire harness is chafed/damaged at either the left or right front side marker lights....Removed both front side marker light and repair the harness wil fix your problem.....Let me know if you find any damaged wire harness

Nov 09, 2013 | 2002 Nissan Xterra

1 Answer

Can I super glue the outside side view mirror on my Xterra?


Clean both the bases and use silicone to stick the glass to the base and tape it for few hours and you will be fine.

Jun 20, 2012 | 2004 Nissan XTerra

1 Answer

I hit a fence and tore off the passenger side mirror this morning. It's hanging by the electrical wires. Called Honda and they said they'd have to order the part. In the meantime, can I do anything to...


No temporary repair, but If you want to remove broken mirror parts, you must remove inner door panel so you can access wiring harness connector and attaching screws. rayo49.

Nov 29, 2010 | 2005 Honda Civic

1 Answer

I have a 2006 Nissan Altima & I broke the side mirror at commercial bank deposit. I have tried |"super glue" but got more on my fingers than the car. Also, I need to try & find out how to fix the...


sounds to me like you need a whole new mirror assembly. The motors that operate the mirror position are most likely damaged along with the wiring harness. There are aftermarket parts warehouses and salvage yards that can reduce your parts cost significantly. I feel this is your best / easiest solution.

Sep 30, 2010 | Nissan Altima Cars & Trucks

2 Answers

Replacing passenger side mirror


no the door pannel does not need to come off but there is a triangle shaped plastic trim pannel above the door pannel that needs to be removed to access the mounting bolts.

May 28, 2009 | 2003 Nissan Xterra

1 Answer

My right side mirror of my 2004 nissan sentre is hanging off how can I fix it my self


If only the glass is affected, it can be replaced by slipping a new mirror element into place and locking it. Some mirrors press in, others are locked with a screwdriver turning a little gear through a slot under the mirror. If the mirror plastic body is broken, you can also replace that with a used assembly from Ebay or a junkyard. Replacement requires removal of the door panel, which is more difficult than replacing the mirror. Be sure you have re-connected all the wiring harnesses and checked the mirror operation if it is electrically adjusted before replacing the door panel. Replacement assemblies range from $20-$70 on Ebay. Glass only is much less.

Dec 12, 2008 | 2002 Nissan Altima

Not finding what you are looking for?
2002 Nissan Xterra Logo

Related Topics:

355 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...