Question about 2004 Land Rover Range Rover

2 Answers

2000 range rover

My car is stuck in park. car turns on, dash is on but gear wont go into drive or even neutral please help asap my cr is sitting in aparking garage and is about to be towed if i cant move it asap!!!

Posted by on

  • IJEAKUSOBA Feb 07, 2009

    stopped to do grocery. Came back to the car but can't shift the gear out of park. Had to go home with a cab. Please helpt the RR 2002 HSE 4.6

  • yadayada
    yadayada May 11, 2010

    CHECK AND SEE IF THE BRAKE LIGHTS WORK, IF NOT THAT IS THE PROBLEM.

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Land Rover Master
  • 813 Answers

SHIFTER LOCKED IN PLACE

  1. Remove the instrument panel cover below the steering column, then remove the steering column shrouds to gain access to the brake transmission shift interlock (BTSI) solenoid. The solenoid is part of the interlock cable assembly.
  2. Disconnect the wire connector from the rear of the BTSI solenoid.
  3. Insert the ignition key and turn it to the ON position.
  4. With the brakes applied, try moving the shifter out of the PARK position.
    • If the lever now moves freely in and out of PARK, perform the Circuit Test below.
    • If the shift lever still does not move from the PARK position, remove the BTSI solenoid from the shift lever assembly. If the shift lever now moves freely in and out of the park position, the BTSI solenoid is faulty and the interlock cable must be replaced. If the shift lever still does not move from the park position, the problem is in the shift lever assembly or the ignition interlock cassette

Posted on Dec 21, 2011

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 229 Answers

Pull hard on the steering wheel to the left and the steering wheel lock mechanism should release. I mean pull hard to left because shift interlock is froze if you cannot get it this way you will need a pro to help! Good Luck Mate.

Posted on Dec 07, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My transfer case is stuck in neutral. the car will not shift and when I put the car back in park it makes a grinding sound. how do I reset my transfer case?


Make sure the Rover is on level ground. With the key on and engine off and the transmission in neutral or park, try to reset.

Nov 05, 2014 | 1997 Land Rover Range Rover

1 Answer

Transfer neutral


The site is not allowing me to post a good solution for your rover

Apr 18, 2014 | 1999 Land Rover Range Rover

1 Answer

2000 ford explorer 5r55E stuck in second gear and all gear positions


It sounds like the linkages have let go. If this is the case, then drive it to a repairer straight away. If you turn the vehicle off you might not get it started again.

Oct 10, 2012 | 2000 Ford Explorer

2 Answers

I was driving my97 rangerover and came to a stop light and upon leaving thestop it wouldnt move dash computer says transfer case in neuteral i tried to put it in park and it made a sound as if it was not...


Hello Joey... Have you ever put your Rover into Low range? You might have accidentally bumped the shifter to the right and it started to select Low range, but it is in Neutral because the Low shift was interrupted. To correct this, with the engine off, but with the key on, select Neutral first. Then start selecting Low by putting pressure on the shifter towards the right(to engage low, the second set of gear/numbers). Keep pressure on the shifter until the dash shows a Low range light and is no longer beeping...now you are in Low Range. Next try to select High range by putting slight leftward pressure on the shifter. Keep pressure on it toward the left until it quits beeping and no longer has any gearbox, neutral, or low range lights (20-30 secs Max each way/Range, etc.) Then select park and try restarting the engine, if you hear any funky/grinding sounds shut it down and repeat above process. It should work on the first try, however, You may Try it a few times before giving up on it if you never use low range. The Low range shift solenoid is probably shot if you cannot get it back into High Range, etc. Good Luck, Brian

Jan 17, 2012 | 1997 Land Rover Range Rover

1 Answer

Range rover 2003 transfer in neutral help please


hi, this is a long shot so dont give me negative if no joy.
on the p38 they suffer from a bad electronic selector.
now, i do not have a clue what gear box or transfer you have.
any way if you look at your transfer, beside where the prop comes out, is ther like a window wiper motor with 6 wires.
if so they get stuck, rust or dirt etc.
have you checked your fuses, alos i would add. again not sure on your model.
in the fuse box there is a blank fuse, when inserted it shifts it to neutral.
the dealers wont tell you where it is.
have you put any fuses in etc, i did this 5 year ago, a p38 was jump started, leads wrong way.
i got a call as the aa did not want to help anymore. aa had a hand full of fuses out, i stuck in were contacts were. after new ecu had no drive.
you are sure its not a gearbox fault, get back to me if not sure, i can tell you how to test this.

Jun 17, 2009 | 2003 BMW 330

2 Answers

My 2003 Mercury Mountaineer Gear Shift is stuck.


THERE IS A SENSOR ON THE BRAKE PEDAL THAT RELEASES THE THE SHIFTER.THERE A 3 COMPONENTS INVOLVED.U CAN PUT IT IN NEUTRAL BEFORE U START THE CAR.THEN WIL SHIFT.

May 01, 2009 | 2004 Mercury Mountaineer

1 Answer

Dashboard indicator stuck on Drive


My Dodge Intrepid 99 is stuck in he drive position. The gear wont go back to park or neutral or anything. I was looking for the shift release cable but can't locate it. Can someone please help.

Apr 27, 2009 | Dodge Grand Caravan Cars & Trucks

2 Answers

Online owners manual 2000 land rover range rover hse


Do a serch on Google for RAVE. This is the land rover workshop manuals. The owner manuals are included.
MickyDrew

Apr 07, 2009 | 2000 Land Rover Range Rover

1 Answer

My grand prix wont go into gear


set your parking brake, insert your key into the shift interlock, located next to your shifter, push all the way in, move your gear shifter to neutral, remove key, start car, release parking brake, drive away, have it serviced ASAP

Jan 28, 2009 | 1999 Pontiac Grand Prix

Not finding what you are looking for?
2004 Land Rover Range Rover Logo

1,149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21989 Answers

yadayada
yadayada

Level 3 Expert

63661 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...