1997 nissan quest rear ac not working - 1998 Nissan Quest

SOURCE: 1994 nissan quest crankshaft rear main seal removal

There is no other way other than to remove the engine.I now its a lot of work but if you want to do the job properly then thats the way to do it.You can remove the gearbox and try.I think thats a waist of time good luck.

Johnny Brown

• 5763 Answers
• Posted on May 09, 2010

SOURCE: 1997 nissan quest camshaft sensor where is it & how to replace it

The camshaft sensor is located inside the distributor and is part of it, in order to replace it you must replace the distributor,to replace remove the dist cap. mark the location of the rotor,by marking where its pointing to, then mark the dist housing, so now theres a mark on the rotor and housing to show where rotor points, next mark the location of dist going into housing, mark the shaft and the block,because it spins in block this way you can line back up.next remove hold down bolt and pull out,mark the new dist in exacat same spots as the old so you can install back the same,you may have to put it in and pull it out until your marks are lined up,this way the timing will be dead on, when done you can check timing. good luck

SOURCE: I need to know where to find the A.C. condenser on

Condenser coils look like a radiator, normally mounted in front of the radiator. You should be able to trace A/C lines to fittings that are attached to the condenser.

SOURCE: 1997 Nissan Quest wont start

If you tried jumping it and it still doesn't start, then it's not your battery. There may be a problem with the solenoid/starter. Try tapping the starter a few times with a metal object (tire wrench or something), but not too hard. Then try starting it again.