Question about 2007 Hyundai Santa Fe Limited

1 Answer

Pressure plate failed at 90 000kms

Why would this happen and why is it so expensive to replace?
Hyundai Terracan 2.9 CRDi

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Hyundai Master
  • 2,039 Answers

You can always get a difective part but normally it failled mush soonner then that plate is related with the driving nothing else im not saying you dont drive good but maybe slipping the clutch a bit to mush
and for the cost its a hell of a job and not old so parts are expensive sorry. pierre

Posted on Dec 07, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


Paint code is on the VIN. Check your engine bay on the firewall there should be a plate there.

You use an online decoder to figure it out

You may find some useful information in a repair manual also:

Jul 29, 2017 | Hyundai Cars & Trucks

1 Answer

What can cause the V Belt of my Terracan 2007 CRDi 4x4 to burn and break Recently had to put in a new engine & since 1 Sept 2 x V belts have been installed and burnt

Quite a few things can cause this, check the pulley for any nicks or rough edges, check the pulley alignment with each other, make sure of the correct belt tension. power steering pump binding causing overload. wrong belt for pulley, A section belt V section pulley , V section belt A section pulley.

Sep 27, 2016 | Hyundai Terracan Cars & Trucks

2 Answers

HYUNDAI TERRACAN LOSING POWER... Hi, I have a 2002 Hyundai terracan that has been losing power. along the highway and straight roads it was fine but on an incline it loses power and now has a job to do...

run the fault codes for an exact diagnosis but from your description of the problem I would be looking at a failing cat converter as it may be blocking up the exhaust system

Dec 14, 2014 | Cars & Trucks

1 Answer

My hyundal 2004 terracan 2.9 engine management light flashing up hills

Comon problem - first - check injectors - they can overleak -second - pressure on pomp too low- damage inside from bad fuel - this is extremal but hapend .
I thing more about first posibility - try start at this

Sep 07, 2013 | 2005 Hyundai Terracan 2.9

1 Answer

Hyundai terracan blower motor speed control resistor

I am also trying to find out where the blower resistor is on a Hyundai terracan 2006. On here someone says its on the passenger firewall is it beneath the battery I cant find it

Jan 29, 2013 | 2006 Hyundai Terracan 2.9

1 Answer

Diagram for fuse box hyundai terracan highlander 2002 4wd

Check this website, you find there fuse box diagram and description for Hyundai Terracan

Hyundai Terracan 2005 2007 fuse box diagram Auto Genius

May 16, 2011 | Hyundai Santa Fe Cars & Trucks

2 Answers

Hyundai tucson 2 liter crdi gear box sound its a manual transmission

Hi there, the Common Rail Diesel Inyection (CRDI) 2000 cc 112 Hp M/T have a big trouble on cluth plate, and sounds very loud between 1500 and 2000 rpm on 2,3,4 shift.That motor has too much torque and cause excesive wear in the cluth roll and plate so starts roominess in the cluth system. You could change those parts but quickly the sounds come again. Hyundai is the resposable of that damage. I hope in the near future recall the CRDI model 112 Hp and replace the cluth.

Sep 20, 2009 | 2005 Hyundai Tucson

1 Answer

Terracan delphi injection

I depends on what kind of problems you are having. The system consists of three main parts: 1) The 4 injectors, 2) The fuel rail and 3) the high pressure pump. Your problem can be pinpointed to any of them or all. Anyway, such repair calls for quilified technitians with proper tools and factory information on service. It may be expensive. BTW, the fuel tank has no reason to be replaced unless is cracked due to rust or accident. All components from tank can be repaired or replaced if needed.

Dec 21, 2008 | 2003 Hyundai Santa Fe

1 Answer

Burnt out clutch

hi there! i was a master tech 4 hyundai. sorry to say this was and is a common problem as it has a dual mass flywheel. take it to your dealer and they will replace the the flywheel and clutch, this depending on milage ect could be covered under warranty, or to a minamum charge to yourself.
any problems please feel free 2 contact myself.

many thanks

Dominic Hill

Nov 21, 2008 | 2002 Hyundai Santa Fe

Not finding what you are looking for?
2007 Hyundai Santa Fe Limited Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides