Question about Nissan Hardbody

1 Answer

Nissan micra heater blower

I have only one setting of four and thats full on ,how easy is it to fit another one ,it is an lx version on a n reg

Posted by on

  • 1 more comment 
  • JRosas6470 Dec 13, 2008

    We have a 1998 Nissan 240SX SE, recently the blower stopped working on settins 1,2,3 but works on setting 4. I thought I had a fuse problem, but the fuse decal on the underhood fuse box is long gone.

    I would appreciate any help with this problem.

  • Rabindra Robinson May 11, 2010

    what is a reg?? if you have only one setting working for you it is due to a bad blower motor resistor usualy found under the glove box in your heater box.

  • Anonymous Mar 25, 2014

    gauge goes straight to full and stays there

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Nissan Expert
  • 99 Answers

Robynumber1 is correct, you have a blower motor resistor that needs to be replaced.

Posted on Dec 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan micra 07 modal how to fix heater motor


Do you mean blower ? There is no motor in heater ! ... check its coupler and relay if it is not working. If the air flow is not proper than please get your evaporator coil cleaned

Jan 01, 2015 | 2007 Nissan Micra 1.4

2 Answers

How to set clock on 2012 nissan micra radio


get correct manual from Nissan.
if stock radio,
the generic nissan, for 2011 will list all radios sold that year.
get one.
nissan dot com, its free.
online or at the parts counter.

Jul 19, 2014 | 2011 Nissan Micra 1.2

1 Answer

How to remove radio from nissan micra 03 reg to get serial No just acquired car but no manual or radio code and i'm a( new older lady driver) ant hints tips on anything would be great!


You go to the dealer for the radio code

Why would you remove the radio ?

The dealer has your Vin # & shouldn't need any radio serial #

Aug 01, 2012 | Nissan Micra Cars & Trucks

1 Answer

Micra 55 reg 1.6 Sr right indicator flashes fast randomly


when a balb gos it will flash fast. but its random so that would be a loose wire or plug

Mar 17, 2012 | 2005 Nissan Micra Acenta

1 Answer

Can I take my 53 reg auto nissan micra to an independent garage for engine diagnostics?


Yes you can only to a Nissan competent person who is familiar with the Nissan strategy

Mar 05, 2012 | Nissan Micra Cars & Trucks

1 Answer

How to replace a blower motor in a 1996 ford thunderbird lx


Removal
  1. Remove the glove compartment liner to gain access to the heater blower motor and blower motor wheel assembly mounting screws.
  1. Use a small screwdriver to remove clip retaining hydraulic damper strut.
  1. Remove four screws and remove the heater blower motor assembly and blower motor wheel assembly from the heater blower motor housing.
Installation
  1. Using a new seal, position the heater blower motor and blower motor wheel assembly to the heater blower motor housing with the flat side of the flange near the heater blower motor switch resistor (18591). Install the four retaining screws.
  1. Tape the heater blower motor power lead to the air inlet duct to keep the wire away from the blower outlet during installation.
  1. Install the heater blower motor and blower motor wheel assembly in the vehicle.
  1. Install the glove compartment liner.

Oct 07, 2010 | 1996 Ford Thunderbird LX

2 Answers

Blower heater unit in micra k12


hi did you get the resistor fixed if not you need to remove the glove box by removing the screws that can be seen then there are two plastic lugs that need to be pulled out sideways to enable you to remove the glove box then you will see the resistor card on the side of the motor thats on the new shape micra k12

Mar 03, 2010 | 2006 Nissan Z

1 Answer

Fan works on Full Setting ONLY. 98 pathfinder


there is a ballast resistor that should be next to the blower motor that controls the low speeds on the blower. change it and you should be all set.

Jan 21, 2009 | 1998 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,835 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...