Question about 2005 Ford F-150

1 Answer

OUTSIDE TEMP GAUGE 2001 F150 DISPLAYS INCORRECT TEMPP

IT SHOWS 49F WHEN THE TEMP IS 69F. WHEN I TURN THE VEHICLE ON THE DISPLAY SHOWS A THING LIKE A PLUSS SIGN WITH THE SEFT WING GONE FOLLOWED BY 88 AND SOME OTHER STUFF. THANKS KEN AIKEN. 361 855 9432

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 39 Answers

;ikely a bad sensor

Posted on Dec 11, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The radio is locked on a 1995 oldsmobile 88


How to Unlock a Chevy Radio Step 1: Start the vehicle and turn on the radio.
Step 2: Press and hold preset numbers 2 and 3 until a three digit code appears on the radio display. Write this code down.
Step 3: Press the AM/FM button. Your radio will display a second three digit code. Write the second code down. You will now have a six digit code.
Step 4: Call the Chevy Radio Code phone line at 1-800-537-5140.
Step 4: Enter 106010 followed by the # key to direct you to the radio code retrieval system.
Step 5: Enter the six digit code you retrieved in steps 2 and 3 followed by the * key. They must be in order. You will be given a four digit radio code. Write down the radio code.
Step 6: Start your vehicle and turn on the radio. Using the Minute and Hour buttons, enter in the four digit radio code to your stereo system. Press the AM/FM button to unlock your stereo.
How to Unlock a GM Radio Step 1: Start the vehicle and turn on the radio. The radio will display "LOC" indicating the Theftlock system is activated.
Step 2: Press and hold preset buttons 1 and 4 for ten seconds. (If you don't have a fourth preset button, press and hold presets 2 and 3.) The radio will display a three digit number. Write this number down.
Step 3: Press the AM/FM button. Your radio will display a second three digit code. Write the second code down. You will now have a six digit code.
Step 4: Contact your local GM Dealer and give them the six digit code. They will give you a four digit radio code.
Many dealers will give you your radio code for free, while others may charge a small fee. If your dealer is charging a larger fee, consider calling another dealer or doing a Google search for sites offering GMC Radio codes. They usually charge a small (around $10) fee.
Step 5: Start your vehicle and turn on the radio. Press the Hour button on the radio until the first two number of the code appear. Next, press the Minute button until the last two numbers of the code are displayed. Once all four digits appear, press the AM/FM button to unlock your stereo. The display will read "SEC" indicating you have successfully unlocked your radio and it is fully operational.
If radio display reads "INOP" while the vehicle is on, too many incorrect radio codes have been entered. To remove "INOP" from your display and unlock your radio, you must leave the key in the On position for one hour. Once you've retrieved your radio unlock code, write it down for future use. Your radio code will not change and having it handy will save from going from the radio code retrieval process again.

Jan 30, 2014 | Cars & Trucks

2 Answers

This Sign appears on the dashboard , What Is the problem? VW eurovan


I m not familiar with VW Eurovan but, assuming your vehicle is diesel powered, I would say that the sign indicates a fault with the "pre-heaters" which should only come on when cold starting a diesel. Normally, this sign appears on switching on, and you wait until it goes out before starting.
Does this happen on your vehicle and, has this symbol previously gone out after a few seconds? There is a relay, on the starting circuit, which should cut these pre heaters, after a short while.
I see that your temp gauge shows 90 degrees so, he engine is hot.
Try disconnecting the leads to the glow plugs, check that the engine starts OK and see if the warning symbol disappears In warm weather you can leave the leads disconnected and, if you have a meter, check if there is still power to the glow plug leads after the engine has started. (a 12 v bulb and wire would do). It they are still powered, there is a fault with the glow plug relay.

Oct 06, 2012 | Cars & Trucks

1 Answer

Ignition will turn but when i turn the ignition nothing it is on a 1996 Olsmobile 88 I just can't find the problem and fix it so wat would it be?


check to see that power is going in and out of switch. chances are the switch ic bad. an ignition switch handles about 50% of total power needs, for a vehicle. one major sign of a bad ignition switch is that dash lights do not come on. vehicle may crank but not start. no current to dash lights, fuel pump etc. also check the big fuse in fuse box for the ignition switch. have a good day !!

Jun 10, 2011 | 1996 Oldsmobile 88

1 Answer

V6 2008 1/2 ton PU 2wd "Engine temp high/AC turned off " display. Temp guage shows 160 deg , fans running constantly , heat from vents normal. Coolant expansion tank full , oil level full...


160 is not high-thats below warmup temp--the fan sensor has issues etc Vehicle is not gettin to operation temp so hav it diagnosed for free at a parts place-fan motor may be goin bad

Nov 24, 2010 | 2008 Chevrolet Silverado 2500HD 2WD

1 Answer

Digital display ford fairmont au 2000


Unfortunately, if it shows nothing at all you will have to replace it. The only serviced part is the globe for the backlighting.

Aug 26, 2009 | Ford Fairmont Cars & Trucks

2 Answers

Rear turn signal bulb


Open the trunk, behind the light you will see a plastic wing nut, remove it.
Then pull the carpeted trunk liner away and you will find 2 more plastic wing nuts. remove both of them and the wireing harness. the lamp will now com off the back of the car. twist the bulb base out and replace with new bulb.

You can go to www.chargerforumz.com with any other charger questions. use me Sandman2053 as a refrence. its FREE to sign up

Feb 03, 2009 | 2006 Dodge Charger

Not finding what you are looking for?
2005 Ford F-150 Logo

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5653 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...