When the ac is turned on the air is not cool.
SOURCE: the ignition won't turn for a 2003 gmc yukon denali
make sure the wheels are straight.. if you park them with them turned to one side the steering column is under a bind.... if they are turned all the way to the right you will for example have to turn it a little to the left to release pressure as you turn the key...
SOURCE: 2003 yukon denali---relay locate for blower
the relay is built into the speed resistor or motor control module ) depends if you have automative or manual heater controls. is automatic it will be motor control module and manual is the resistor module. these units are located beside the heate fan motor. the motor helps keeps the unit cool. just unbolt the module, unplug it and install new one. Just check to make sure the connector is good.. The heat created by the connection sometimes melts the power or ground leads (red or black) and if this is so you will need to replace the pin.
SOURCE: 2004 yukon xl denali self-leveling rear air shocks
There's a lever that connects the driver-side rear shock to the Automatic Level Control module (the air compressor and the ride-height sensor). Disconnect the lever from the shock and rotate it up and hold it. The compressor should kick in when you hold in place after a few seconds. If it doesn't kick in, make sure your fuses and relays are good. Otherwise, you may have a failed ALC module/burned out air compressor (from the shocks being shot). After you replace the shocks (and after you recouped from the heart attack you had when you shelled out $500+ for each shock), replace the ALC module/compressor (it's all one unit), and test it - it should kick on when you rotate the lever up again.
Figure about $350 for the ALC module from your dealer, and make sure the part numbers match! Your truck came with an upgraded ALC module from the 2001-2004 module, which were prone to water damage.
Good luck!
SOURCE: 03 Yukon denali park brake warning wont turn off
hi for info the brakes warning light on dash is also an indication that brake fluid level is low? or there may be a leak resulting in fluid level drop ? also considering age of car you may need to inspect brake pads wear ? if your car has low brake pads wear indicators attached to pads ? or the hand brake switch req's checking to ensure it is being pushed to off position when h/brak is down ? so fluid level low is the obviouse 1st check as fluid will displace from reservoir as pads wear low hence the level indicator on fill cap trips on may i suggest if it is low level b4 you top up? check your b/pads if you have not done so recently? or replaced since new ? hope this helps you locate problem best wishes from the uk
SOURCE: locting the throttle position sensor on a 2003 gmc
The throttle position sensor is located on the throttle body. Which is in the front of the intake manifold.
461 views
Usually answered in minutes!
×