Question about 1993 Chevrolet S-10 Blazer

1 Answer

4 wheel drive

Hi I have a 93 S-!0.Blazer. Four high works great but at times it stops working and makes a spinning sound from front driver side. That goes away when I push the button to disengage. Is there a motor that engages the tranfer case? Thank you

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 33 Answers

Small switch isnt working right on the top of transfer case. vacome operated. replace or check the three lines that run to it

Posted on Dec 13, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 chevy blazer passenger front wheel noise


driving in 4wd on hard surfaces produces what is known as torque wind up as the wheels cannot slip so the variations of distance going around corners , dips in the road etc place considerable strain on the transmission , transfer case , drive lines and diffs
that is why it is difficult to get out of 4wd unless you drive with 2 wheels on a grass verge to relieve that torque wind up
as for the noise check wheel bearings and the cv ("U") joint at that wheel as there appears a proble where the dog teeth in the hub are not engaging properly or are jumping out of engagement

Mar 26, 2017 | 2000 Chevrolet Blazer

2 Answers

Trying to get lower ball off on driver front


I know that this is going to sound strange. But hit it with a hammer like you are putting it on. This will pop it right off. I know it sounds strange but it works great!

Feb 16, 2011 | 1996 Chevrolet Blazer

1 Answer

My four wheel drive is not working. i replaced the switch on the dash. tried it and all it did when i hit 4-hi both 4-hi and 4-lo blink a few times the it goes back to 2 wheel drive. it did stay in 4-hi...


It's the transfer case motor.I had the same problem exactly and replaced, now it works great. Part is about $100.00 ( aftermarket ) .Ifyou are going to replace yourself you will have to remove front drive shaft and remove yoke from transfer case with an impact wrench for clearance to remove transfer case motor . When you put the new transfer case motor in make sure you line up slot with grove in transfer case motor. Good Luck.

Jan 03, 2011 | 1997 Chevrolet Blazer

1 Answer

My four wheel drive will not work when i push the button it makes a sound but it will not go in to four wheel drive


The actuator is stuck. You can find your 4x4 actuator mounted to your front axle housing towards the passenger side from center.

Jun 29, 2010 | 1999 Chevrolet Blazer

1 Answer

2000 silverado 4x4 not working


sound like the electronic actuators are not working properly,get your test light out

Apr 15, 2010 | 2000 Chevrolet Silverado

1 Answer

Ive got a full size blazer its a 93 and its a manuel engaded i put it in four wheel drive high or low and the front wont spin what could it be the blazer runs fine in 2 wheel hi


your transfer case could be burned out for 4 wheel and thats why your only getting the back wheels to turn. when was the last dif service done?

Jul 19, 2009 | 1999 Chevrolet Blazer

1 Answer

My four-wheel drive does not work


could be the switch very common problem on those

Apr 25, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

95 blazer 4x4 4 wheel drive not working


There is a vacuum actuator mounted on the front differential that locks the shafts to engage four wheel drive.

Jan 28, 2009 | 1995 Chevrolet Blazer

2 Answers

1998 chevy blazer won't go in to four wheel drive


It sounds like the encoder motor. That's the black plastic box on the driver's side of the transfer case. But just to make sure, the control module for the encoder motor is located behind the passenger side kick plate (inside the vehicle, passenger side, where your feet would be, outside side). Disconnect it for a few seconds and then reconnect it. If the problem still exists, you will have to repair or change your encoder motor. I grabbed one at a scrap yard for less than $100.00.

Nov 27, 2008 | 1998 Chevrolet Blazer

Not finding what you are looking for?
1993 Chevrolet S-10 Blazer Logo

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...