Question about 2000 Isuzu Rodeo

2 Answers

My check trans light is blinking?

I was driving home and my trans light started blinking what can it be? it shifts fine! its a 2000isuzu rodeo,
thank you,
Billy.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 194 Answers

Your transmission sencor may be malfuctioning or you need fluid

Posted on Dec 08, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had this problem. I was losing tranny fluid. The part on the bottom was plastic. It was cracked and had to be replaced. The only people who would touch it (because some parts can fall out while replacing it) was the dealer. Positive: It was only about $100 to fix. parts and work. That's a positive because we are talking about the transmission here.

Posted on Dec 19, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000Isuzu rodeo that does not drive in any gear,,I had to manually shift my automatic transmission from first gear all the way to drive every time I drove it..


run the fault codes to check for a failed TCM
check that the wires to the auto are in good condition and are clean at the terminals.

Jun 12, 2015 | 2000 Isuzu Rodeo

1 Answer

Rodeo wont shift right from winter drive


well you need tranny service.?
right?
did you scan the PCM first to see if there are DTC errors for the trans. seem not and that is first. after.
1: checking levels in box.
2: checking fuses.


older post missed by me.

Mar 09, 2015 | 2001 Isuzu Rodeo

1 Answer

I changed the oil on my 2000 isuzu rodeo and now when I start the can and i shift the car dose not move. It starts fine but wont revers or drive when I put it in gear.


you have apparently drain the transmission fluid out of the trans pan. check your oil level to see if it is overfilled, this would be a good indication especially if you didn't have to refill the oil with at least 5 quarts.

Aug 12, 2011 | 2000 Isuzu Rodeo

1 Answer

Check trans light started blinking


CHECK TRANSMISSION FLUID.IF FLUID IS FINE CHECK OWNERS MANUAL

Jul 19, 2011 | 1995 Isuzu Rodeo

1 Answer

Its 2 wheel drive, but the transmission won't shift unless you manuallyl put the gear shifter in low then work your way up to get the gears to change. The gears work fine it just won't change on its on. If...


Trans shifts into gear harshly, car feels sluggish off the line, No 1st, 4th or TCC lockup available, Manual 2nd, 3rd and Reverse are only available gears, CEL is on: Transmission is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under-hood fuse that powers the transmission, and if it pops again, look for a short in that circuit like an O2 sensor harness touching exhaust. Otherwise, check PCM codes for a particular fault in the transmission causing the PCM to put it in limp-home mode.

No 1st or 4th available; trans shifts 2nd to 3rd by itself in D or OD and locks the converter : ShiftA solenoid failed. Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Car goes into gear but feels very sluggish like the brakes are dragging, but it will roll easily (starts out in 4th gear), you manually shift to 2 to get it moving, once it's moving you put it back in OD and the car shifts 3rd to 4th on its own and locks the converter at the appropriate time: ShiftB solenoid failed: Easy fix in the pan. Or a wiring problem from PCM to trans.. or PCM.

Good luck and keep me posted, there are other things but these things mentioned seam like what you described.

Nov 19, 2009 | 1993 Isuzu Rodeo

1 Answer

I HAVE 99 ISUZU RODEO 2WD LOST 1ST & 2ND


if your close or over 100,000 miles, better to have the tranny rebuilt.

Nov 07, 2009 | 1999 Isuzu Rodeo

1 Answer

2001 Isuzu Rodeo Check Engine Light flashes when accelerating.


I would change the trans flter, trans fluid, and have the linkage on the trans adjusted.

Jul 21, 2009 | 2001 Isuzu Rodeo

1 Answer

1996 TBird 4.6 auto/overdrive trans problem


Your transmission fluid contain water,thats why the colour of the fluid changed to pink.And of such the clutch is slipping causing the engine to reve up before shifting - Check transmission cooler.

Aug 21, 2008 | 1996 Ford Thunderbird LX

Not finding what you are looking for?
2000 Isuzu Rodeo Logo

Related Topics:

344 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...