Question about 1984 Ford Bronco II

1 Answer

1984 bronco 2-runs 15 min shuts down wont start again for 20 runs

Again 15 min shuts down agaIN CHANGED COIL ,DIS, MOD STARTER,WIRES, AND DOES 84 HAVE A MAP SEN OR COULD I BE HAVING TROUBLE WITH FUEL PUMP

Posted by on

  • Anonymous Mar 16, 2014

    my 1999 acura shuts down on me while am driving it turn on but 15 min later it cuts off

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 75 Answers

If the fuel filter is dirty it will settle when you turn the truck off. When it runs for a few minutes the debris in the filter will get sucked into the screen and stop the fuel from getting through. If it was a starter or coil, it would not start at all.

Posted on Dec 05, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change a flywheel on a 84 bronco 2 standard transmition


is the flywheel worn out or just the ring gear, (starter gear)
first remove the trans mission then unbolt the flywheel, and replace
if only replacing the starter ring gear, use a soft hammer and bump it as you rotate the flywheel until it comes off, if the back side looks good heat it in the oven to 350 degrees and with gloves on run out and put it on the flywheel, it will go on easily, just hold it all the way on against the edge it rests on and turn it about 1/3 turn and hold for about 15 seconds and that's it, it will not come off unless you beat it off again

Mar 23, 2015 | 1984 Ford Bronco II

1 Answer

1984 Bronco ii


starter silanoid feeds power to the coil after start up giving 9 volts could be giving to much voltage check with volt meter while running

Aug 27, 2012 | 1984 Ford Bronco II

2 Answers

Looking to reinstall a solenoid for my 84 Bronco II and a buddy mixed up the wiring for it, i have no idea how to reconnect it to the new one.


Big wire from positive from battery goes to big stud facing the battery. Big wire to starter goes on other big stud. Little wire or wires go to little post. If you have 2 little posts they are labeled I (ignition) & S (starter). If you put on wrong little post it wont engage starter when you turn key to start. Just connect it to the other then it will engage starter when you turn the key to start.

Sep 09, 2010 | 1984 Ford Bronco II

1 Answer

My 83 z28 ran fine then started shutting down after running for 10 or 15 mins and would not restart for 15 or 20 mins then would restart run fine for a mile or two and die again till finally it wont start...


could be the pickup coil in the distributor they go bad fairly often
pickup coil resistance should be 500 to 1500 ohms between the two leads.also move vac advance plate ohms should not change.there should be infinite ohms [no continuety] between either of the leads and ground

Apr 04, 2010 | 1983 Chevrolet Camaro

2 Answers

My 1984 Bronco's fan switch will only work on high. The switch is good. A/C has been disconnected from truck. How can I fix it?


Your blower motor resistor is bad. Replace this and it should fix your problem. Hope that helps.

Dec 31, 2009 | 1983 Ford Bronco

1 Answer

'84 Ford Ranger cuts off after about 30 mins of driving.


sounds like the auto choke isnt turning itself off properly but to be totally honest i would need this to happen when i test drive it to diagnose it correctly .

Sep 01, 2009 | 1984 Ford Ranger

1 Answer

CAR CUT OFF AND ACTS UP WHEN DRIVING 20 MIN..


Check the ignition coil or coil packs. It sounds like overheating coil(s)

Jun 14, 2009 | 1987 Ford Bronco II

1 Answer

Truck will crank and then shut off


You will need to do your testing while the vehicle is in failure to start mode.Check wether the coil is recieving 12v and pour a little fuel down carb to see if it wants to run.If pouring a little fuel down carb makes the car try to fire up you probably have a fuel pump issue.If it doesnt try to fire you have an ignition problem.Hope you get it sorted and good luck.

Dec 20, 2008 | 1984 Ford F 150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

322 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...