Question about 2002 Chevrolet Camaro

1 Answer

The SECURITY LIGHT is ON on the dash?? - 2002 Chevrolet Camaro

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

The resister on the key is not being read by the contacts inside the ignition switch. disassemble the key switch with new springs and contacts or follow the two purple wires down the steering wheel and match the ohms on the key with a made resister and short the two purple wires out. No more security light no more sitting and waiting 5 minutes to try to start your car again.

Posted on Jun 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

08/97 Tahoe with no chip key and it won't crank over. And security light is on solid


what did you do with the original key . it is a chipped key with security code embedded to turn off the security system .

Sep 20, 2015 | Cars & Trucks

1 Answer

How do you reset security system in 2004 dodge neon


Try pressing down on the red security light on the dash and hold it down for about 3-5 seconds. Sometimes Neon's just have a dummy light on the dash that isn't actually hooked up to anything, but its a good place to start.

Mar 27, 2015 | 2004 Dodge Neon

1 Answer

99 olds will not start


What have you checked so far ?

Jul 15, 2013 | Cars & Trucks

1 Answer

Security light comes on and engine will not turn over


find fuse for the security system under hood if remote or switch does not turn it off pull this fuse out light should be out on dash when u find the right one then open door turn ignition switch on not crank just power on then replace security fuse then try to crank if dont work pull fuse again and the main 50 amp fuse that sends power to everything turn switch on leave door open replace fuses in proper places and then crank

Sep 06, 2012 | 2005 Chevrolet Impala

1 Answer

I have a03 saturn vue and the security light comes on and off the dash lights do the same and on yhe way home tonight itdied on me


I know that when the security light comes on, it can shut down your vehicle. Here is a link to some info and ways to beats this problem

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Nov 13, 2011 | 2003 Saturn VUE

1 Answer

My security light on the dash won't turn off in


Sound like the ANTI-THEFT system or PASS-LOCK system is armed; in your Cadillac Owners Manual (need yahoo register for free) could find this and other details...

zjlimited_1753.jpg_zjlimited_1754.jpg


zjlimited_1751.jpg_zjlimited_1752.jpg

Hope helps (remember to rate and comment this answer).

Aug 19, 2011 | 2001 Cadillac Sts

1 Answer

Starter turns but no ignition, PK3 M security, the problem is intermittent and does not cause a problem with every start. So far I have been able to get it started after several attempts with differing...


is your security light in dash flashing if so try to start let off key but do not cut off leave key on so all your dash lights are on let vehicle set for at least 15 mins. flashing security light should stop flashing once it stops flashing start vehicle sounds like it has tripped security

Mar 16, 2010 | 2002 Pontiac Grand Prix

1 Answer

Security light blinks on dash , truck wont even try to start


Does your key have a chip on it? If it does its probably the problem

Aug 23, 2009 | 2004 Dodge Ram 1500

1 Answer

How do I program my key for my 2006 Chevy Impala?


Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
Originate New Master Key (PK3 or PK3+ key)

1. Insert new key into ignition cylinder and turn it to the ON (RUN) position.
The security light on the dash will illuminate and stay on for ten minutes.
2. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back to the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
3. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back on the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
4. After the security light has gone off the third time, the key has been programmed
into the vehicle’s computer and will operate the car. It has replaced ALL the
previous electronic key codes and is the ONLY key programmed into the
vehicle’s computer.

Add Duplicate Key (PK3 or PK3+ key)

1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.

May 20, 2009 | 2006 Chevrolet Impala

Not finding what you are looking for?
2002 Chevrolet Camaro Logo

Related Topics:

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...