Question about 2007 Pontiac Grand Prix GXP Sedan

1 Answer

2007 grand pri car only runs 10 minutes when remote start is used

Is there anyway to lengthen this time

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

No, but you can restart the vehicle remotely a second time if it doesn't have sufficient time to warm/cool properly. After that, you must start the vehicle manually

Posted on Mar 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Diesel engine runs then stops then runs stops every few minutes


Mate I use to drive a freightliner and it cut out on me one day, I eventually got it started but cut out again after about 5 minutes, I rang a mechanic to come out and he found a heat sensor wire came off the radiator and that caused the motor to cut out... Hope I haven't wasted your time.......

Mar 09, 2016 | 2007 Chrysler Grand Voyager

1 Answer

Auto start shuts off within 10 seconds?


you have 2 choices
get car serviced,
or
read below. (pick one?)
sure, this is easy, (system logic not)
but you forgot to say , car starts with key, and runs perfect.
right. for get remove start toy.
certified , = warranted, or some bs.?

runs perfect means zero if the CEL glows running,
does car run perfectly you in seat starting with key and driving?
my guess you mean car stalls, 10second (ONLY ) remote started.
sure.
"engine light" means not running right, on all cars 1988 to now.

the XBM remote start will never work , with any errors from
ECU
PCM
BCM
or TCM
ever.
or if it sees doors ajar or alarms of any kind
by logic and federal laws.
scan it 1st and correct all DTC errors first.
that is what to do. if you are savvy and have a scan tool.
$10 to $100 tool, sold in all autostores usa.

think for 1 second how dangerous this FEATURE, can be.
hummmmmmm (a driverless moving car...)

why not read the FSM book on the 2013?
it covers most the logic, there.

quoted, so you can learn "complexity extreme"
verbatim
the following table below is a list of possible causes for the inoperative Remote Start System. If any of the following conditions exist, the Remote Start System will not work. Use this information as a guide to the diagnosis of the Remote Start System. ABORT BATTERY VOLTAGE HIGH BATTERY VOLTAGE LOW BRAKE PRESSED COOLANT TEMPERATURE HIGH CRANK NO START DRIVER DOOR AJAR PASSENGER DOOR AJAR LEFT REAR DOOR AJAR RIGHT REAR DOOR AJAR TRUNK/LIFTGATE AJAR HOOD AJAR NO HOOD SWITCH (INOPERATIVE) FUEL LEVEL LOW EXCESSIVE GLOW PLUG TIME (DIESEL ONLY) FAILED COUNTER REACHED (START) HAZARD LAMPS (SWITCH PRESSED) IGNITION IN RUN/START IGNITION NOT IN LOCK IGNITION SNA (SIGNAL NOT AVAILABLE FROM OTHER MODULE) INVALID KEY KEY IN IGNITION LOW RPM SHUTDOWN MIL ON NO AUTOMATIC TRANSMISSION NORMAL TIME OUT CUSTOMER ACCESS NORMAL TIME OUT RUN MODE (15 MINUTES) NOT CONFIGURED NOT ENABLED NOT IN PARK OR NEUTRAL NOT PROGRAMMED OIL PRESSURE LOW PANIC MODE (ACTIVATED) POWER LOSS RKE OFF MESSAGE RPM TOO HIGH (EXCEEDS 2500) START COUNTER REACHED VEHICLE SPEED HIGH VTA ALARMING If all of the previous items checked OK, and the remote starting system will not operate, refer to the REMOTE START POOR PERFORMANCE diagnostic procedure.

good luck running the engine in your garaged
and everyone eating carbon monoxide in the home.
good luck with that....."the silent killler"

Feb 19, 2016 | 2013 Jeep Grand Cherokee

1 Answer

How to program avital 7143L keyless remote to a 2007 Chevrolet HHR Lt?


Turn the key on without starting it leave it on for 10 minutes then turn it off for 10 seconds repeat it 3 times if you let it go for more than 10 minutes your going to have to start again it's got to be right on the money 10 min on 10 sec off remberm 3 times

Sep 10, 2015 | Chevrolet Cars & Trucks

1 Answer

I have a 2007 chevy impala when I try to use the remote start does not start and after that if I use the key it acts like the batterys dead and I have to jump it but if I use the key only it starts fine...


Is this a factory option remote start or after market?
If after market, the passkey bypass module may be malfunctioning which, after a few attempt at starting the car, will cause the car to go into tamper mode and prevent starting via remote start or key for a few minutes (10 minutes to an hour)

Dec 13, 2011 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

I have a 2005 Pontiac Grand AM and because of the security system it wont start, what do I do ?


most likely your key got erased from memory make sure you are using a chip key, in a 3 times 30 minutes put your key on (without starting the engine) and live it on for 10 minutes,shut it of and back on the same way for another 10 minutes,do it again 10 minutes more at the end shut it off wait 30 seconds and start the car,if it is not a brand new key it may take 1 or 2 times this sequence to get it to start. let me know

Aug 11, 2010 | 2005 Pontiac Grand Am

1 Answer

I need to know how to reset my remote so i can use


Hold down the the lock and unlock buttons on the remote while by the vehicle for about 10 seconds this should reset the key fob.The locks may cycle but should correct the issue.

May 13, 2010 | 2007 Pontiac Grand Prix GXP Sedan

1 Answer

On our 2005 Grand Prix, the key is stuck in ignition, after battery ran down, was recharged, now won't start. I suspect fuel relay needs reset, where is it? Car would run before battery ran down. I need to...


Hello! It sounds like you're having a fairly common issue, and one that you should be able to remedy - on your own; in about 30 minutes! :)

First - I'm not sure if you're having the problem where your key is not only stuck, but also won't turn...if so, then follow these steps to be able to turn the key. If you can turn the key, ignore these steps. :)
- On the bottom of the steering wheel - you will see a small, circular cap - using a small flat blad screwdriver, pry that cap off.
- Inside the hole there is a switch that you need to push up on with the screwdriver, and while doing so - you will then be able to turn the key.

Now - once you have done this - you need to reset or "relearn" the security system. Here's how:

1.) Turn the key to the "ON" position, then attempt to start. Car will not start.
2.) On your instrument cluster, you should now see the security light flashing. Leave the car on, and wait approximately ten minutes or until that security light stops flashing. (NOTE: if it doesn't stop flashing after about 10 minutes, turn the key to "OFF", disconnect the battery cables for 10 minutes, reconnect, and restart procedure at Step 1)
3.) Turn ignition to off. Wait five seconds.
4.) Repeat steps 1-3 two more times, for a total of 30 minutes.
5.) The PCM is now ready to learn the security system2.gif on the next crank. Turn the car to off, then attempt to start. Your car should start at this time. I would then start the car with all other keys that you have for that vehicle to ensure that they are all working.

Hope this helps and good luck! Thanks for using FixYa!

Sep 28, 2009 | 2005 Pontiac Grand Prix

1 Answer

Starter will not engage anti theft light is on it is a 2005 cobalt


I found this on a website try this

1. Put the newly cut Master key into the keyway and turn it to the ON (RUN) position. A "security" indicator
light on the dashboard will stay on for 10 minutes.
2. Within 1 minute after the indicator light goes off, turn the ignition to "OFF", then return to the ON (RUN)
position. The indicator light again will stay on for 10 minutes (Do not remove the key.)
3. Again, within 1 minute after the indicator light goes off, turn the ignition to "OFF", then return to the ON
(RUN) position. The indicator light again will stay on for 10 minutes. (Do not remove the key.)
4. When the light goes off the third time, the new key is programmed into the computer and will start
the car. Remove the key and then re-insert it into the ignition lock and start the car.
All previously stored codes will be erased. To stop the process at any time, simply remove the key and use
an existing key to start the car.

Mar 25, 2009 | 2007 Chevrolet Cobalt Coupe

1 Answer

Increase range for remote starter on 2007 grand prix


Try changing the battery in the key fog. If that doesn't work you can try finding an aftermarket key fog with a greater range. It is probably just default range.

Jan 16, 2009 | 2007 Pontiac Grand Prix GXP Sedan

1 Answer

Reprogramming the factory remote starter on a 2008 Chevy Siverado


No, its a Auto-Anti-Theft Unit, your best bet would be to buy a $100 kit from auto zone. The Stick unit is built that way because if you start it and walk away, I can use a blank key to unlock the ignition and drive off.

Dec 04, 2008 | 1997 Oldsmobile 88

Not finding what you are looking for?
2007 Pontiac Grand Prix GXP Sedan Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...