Question about 2002 Chevrolet Monte Carlo

1 Answer

Horn And turn signals

I have two diffrent issues. First my turn singals have a mind of their own sometimes they work and sometimes they don't.When they stop working if I turn the hazards on they start working most of the time. Second, my horn goes off by itself sometimes, most of the time I can get it to stop right away by hiting the horn. I think it might be the modgle in the stearing collum. If anyone would give an opinion on these issues it would be much help. Thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 51 Answers

Try moving the tilt wheel feature up and down to see if the condition worsens or improves. There's a ribbon cable on the outside of that column that may have worn off the insulation in some spots. If that's it, you'll need a steering wheel puller to get to it. You may not have to replace the cable, just insulate it from inside the column. You can use tape, but a wide piece of heat shrink, cut along one side would be cleaner.

Posted on Dec 05, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Turn singal and flashers not working, but it sounds like it is


Sounds like your turn signal switch. Move your turn signal lever around while turn signal is on. You indicator on the dash sometimes will light up. Very common problem on Fords.

Aug 15, 2014 | 2003 Ford Focus

1 Answer

Sometimes singal flasher work sometimes dont


turn signal switch bad or could have short in wiring.

Aug 09, 2013 | Cars & Trucks

1 Answer

2001 chevy silverado horn and front turn signal failure


you need a new horn, and find the bulb that is out

Jan 17, 2013 | 2001 Chevrolet Silverado 1500

1 Answer

What if my driver side turn singal is not working


more than likely just your bulb needs ghange, if thers more than 1 not working then I would look at the turn signal flasher , that should fix the problem, if not maybe a ground issue

Dec 07, 2012 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

My turn singal wont come on an its makes noise when I do turn it on a 99 durango 4x4


The noise you here may be a bad flasher, sometimes you hear a buzzing sound.I have found that a lot of dodge, jeep and Chrysler have a problem with aftermarket flashers.Sometimes the flasher will go bad and not work or make noise.If you like you can go to an auto parts store and try the flasher they sell, if you have a problem still then try a dealer flasher.See if the 4 way flashers work, or try to put signal on and gentle move the signal switch arm up , or down and see if the signal starts to work. if it does then you have a bad signal switch, also called a multi-function switch. let me know the out come, good day.

Apr 26, 2012 | 1999 Dodge Durango

1 Answer

Turn signals not working


I suggest to check fuses frasher devices and relays; keep in mind that some circuit is porbably in short.

Mar 07, 2012 | Mercedes-Benz E320 Cars & Trucks

1 Answer

LEFT TURN &4WAYS WORK NO RIGHT TURN SI98 BUICK PARK AVE


The first thing is to replace the flasher, the 4ways and signals use diffrent flashers, after replacing the flasher or changing it with the 4way flasher and see what happens. if this doesnt help then you may have a bad signal switch, a good trick is to turn on the signal and watch it as you move the lever around, pull back a little or lift it more and pull down a little, sometimes the switch contact goes bad and by moving the lever without take signal off will make it flash and if that happens then the signal switch is bad even if the 4ways work this still means a bad switch, the 4ways are wired through diffrent contacts then each signal, good luck.

Mar 17, 2011 | 1998 Buick Park Avenue

1 Answer

2001 Malibu - turn signal & horn problems


Google Service Bulletin No. 04098A. There is a recall for the hazard switch. My car's vin is not within the range, but I have the blinker problem. I was told by the Chev. 800 number that if a dealer determines that is the problem they will replace it. You can also buy the switch for about $20 and replace it yourself if you don't want to have to deal with a service dept.

Sep 23, 2009 | 2000 Chevrolet Malibu

1 Answer

Turn signals not working in front


you have a shor in the steering colum typical in gm cars... replace the whole coulm

Jul 09, 2009 | 2002 Pontiac Bonneville

Not finding what you are looking for?
2002 Chevrolet Monte Carlo Logo

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...