Question about 1987 Toyota Pickup

1 Answer

NO OVERDRIVE 87 pickup r22 auto with O.D. shifted fine.motor blew, changed motors.cant get overdrive anymore.what adjustments do i have wrong?

Posted by on

  • Toyota Ed May 11, 2010

    Where does the temperature gauge read? If it reads "LOW"; the OD is prevented from engaging. Please advise.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 42 Answers

Toyota ed is right when he speaks of low coolant temp as a cause. there is also a temperature sensor on the engine that is specific for the auto trans model. may be a white plastic single pin connector by the t-stat housing, not to be confused with the blade type connector that is used for the temp. guage. were you sure to connect the connector that powers to o/d solenoid on the side of the trans. when you installed the engine?

Posted on Dec 20, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It wont shift into overdrive the transmission has pressure I changed to fluids when I go to pass it wont shift into overdrive


strange as it may sound, transmissions do not shift into overdrive to pass
they down shift a ratio to get extra torque from the motor and will stay down shifted until the vacuum actuator shifts it back and only then when the VSS reports to the TCM that a ratio change up is needed will the overdrive click in
If you cannot get OD under any circumstances run the fault codes and check for a problem overdrive servo/ solenoid , TCM unit

Apr 24, 2016 | 2007 Dodge Ram Truck

1 Answer

Sorry question came out wrong don't know why. I have a 1993 ranger 4.0 auto. When you try to take off on overdrive whont go, if you put in drive shifts fine then you shift into overdrive works OK. You...


If it seems to still be in overdrive when you come to a stop, the brake light switch has an electric cut out switch incorporated in it to shut off power to the trans/overdrive to kick it out of OD. If this switch is malfunctioning, it can cause this problem your having.

Nov 27, 2017 | Cars & Trucks

2 Answers

My transmission is not shifting into overdrive I have a code reading of P1346.


smell the trans fluid if it stinks its time to change, change the filter and do a pressure flush to make sure all bad fluid is gone.

Jan 08, 2015 | Lexus RX 300 Cars & Trucks

1 Answer

Shifted fine changed motors now won't shift to drive or overdrive


check that you have connected correctly the cables for the torque converter solenoid / servo unit as it may not be making good contact after the engine change . Also as the battery was disconnected for a time I would use a scanner to reset the CPU program as the program may be corrupted from the lost battery power.

Mar 22, 2014 | 1983 Chevrolet Silverado

1 Answer

95 subaru impreza shifting problems when cold


too heavy a motor oil can cause hard shifting also,but when its cold out let your car warm up longer before you take off,it might help

Jan 19, 2013 | Subaru Impreza Cars & Trucks

1 Answer

My 1980 mgb overdrive shifts fine cold when it reaches operating temp.it won't shift up or down.


Solenoid coil warms up and dissipates too much voltage with age and needs replacing. Bottom of overdrive unit. Sometimes cleaning and adjusting can help extend their life a bit.

Nov 12, 2012 | Cars & Trucks

1 Answer

Check engine light on motor idles up and transmission will not shift to overdrive


Could be an idle air control valve,but to be 100%,you need to get the codes pulled and write them down. Most Advance auto parts stores will pull the codes for you for free.

Sep 26, 2012 | Cars & Trucks

1 Answer

I have a 1985 toyota pickup auto trans w/od 4 cycle. It will not shift into overdrive. Can this be something I can fix myself.


OVERDRIVE BAND IS BROKE OR TRANNY FILTER IS CLOGGED PULL PAN IF ANY PCS OF BAND ARE PRESENT YOU NEED A REBUILD

Jun 27, 2010 | 1985 Mitsubishi Pickup

3 Answers

1995 Windstar transmission problem


having same problem with tranny but the overdrive light keeps blinking any ideas?

Feb 01, 2009 | 1995 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

308 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...