a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Jun 11, 2012 - Uploaded by 1A Auto Parts
How To Install Replace Windsheild Washer Reservoir Bottle FordEscape ... a broken, damaged, split or leaking windshield washer bottle.
SOUND LIKE TRANSMISSION COOLER LINE FITTING AT THE RADIATOR EITHER CAME LOOSE OR THE LINE BROKE RUPTURE.IT WOULD THAT LINE TO BREAK TO LEAK OUT ALL TRANSMISSION FLUID FLUID SINCE FLUID UNDER PUMP PRESSURE.FILL TRANSMISSION BACK UP WITH FLUID AND FIND THE LEAK.DONT DRIVE UNTIL LEAK FOUND OR YOU COULD DAMAGE THE TRANSMISSION.
Very common on this make and model trans, pump drive splines inside torque converter strip out and pump is not turning, Most times there is no damage to pump shaft. Remove trans and remove torque converter, inspect the splines at the very bottom of the hub hole. If stripped out inspected pump shaft splines which are the smaller center splines coming out of trans, if ok replace torque converter and re-install trans, change out fluid, clean any metal from magnet and replace filter, fill with fluid and verify proper operation.
Yes a shop is usually great advice with this but heres some things you can do yourself. first lets keep it simple have you inspected rear nozzle and cleared nozzle openings with sharp pin? First you must have these following tools: haynes or chiltons repair manual multitester with voltage and impedance features Step one: location reservoir for washer fluid Step two: access the sprayer motors under washer reservoir step three: using multi tester set to 20V test hot leads to motors if theres power then move on if not check fuses and follow power leads to look for damaged power wiring Step four: if there was power make sure the lines are intact and full of fluid after youve pressed switch (you may have to trace fliud line all the way to the rear for damage or leaks) After all this you should've been able to find problem theres nothing left once theres power and fluid to rear nozzle except clearing the nozzle openings