Question about 1999 Chevrolet Cavalier

1 Answer

Directionals do not work

Hazards do work, but neither directional work. Checked all fuses none seem to be bad. Replaced turn signal switch and they still do not work.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 599 Answers

There is another flasher relay (2 of them) one for hazards and one for turn signals .....replace that and advise here

Posted on Dec 05, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My f150 does not have directionals or brake lights but has hazards


Could be the turn signal switch.
All three circuits go thru the switch on different fuses.

Jul 15, 2012 | Cars & Trucks

1 Answer

I SEE THAT THERE IS A TURN SIGNAL FLASHER AND A HAZARD FLASHER DO THEY BOTH GO BAD AT THE SAME TIME???


Usually not. Both are on separate circuits. Directionals are only on when the key is in the on position, Hazards are on (hot) all the time. If I remember correctly, they both share a common junction though as they pass through the directional switch in the top of the steering column. You will need to do some testing: fuses, and wiring to trace power. Also check power at the flasher sockets. If you just bought it, be aware that a common "on the road fix" for a bad directional flasher is to swap it with the one for the hazards. In that case, when the directional flasher that was swapped fails, both would in fact test as bad.

Apr 29, 2011 | Oldsmobile Achieva Cars & Trucks

1 Answer

Directionals and hazard lights wont work replaced fuse but still wont work


It needs a new flasher. I just had it done on my 99 two weeks ago. Were you using the hazards to try and trip the turn signals? What a pain in the ****!
The flasher will cost like 20 buck to install at Merchants.
100% sure of this solution

Apr 12, 2010 | 1999 Jeep Grand Cherokee

3 Answers

1993 Geo Prizm turn signals dont work. Hazard lights DO work. Checked fuse several times & its ok. Any suggestions?


You have a bad turn signal switch if the hazards work and the turn signals do not. It has nothing to do with the fuse or the flasher unit. Your switch is bad or you have a bad connection some where.

Feb 15, 2010 | Geo Prizm Cars & Trucks

1 Answer

Hazard ligts working....not directionals. Checked all fuses as best I could. Location of fuse block is difficult to get at.


Sometimes the hazards run on a different circuit than turn signals. There is probably a fuse that needs to be replaced. If no fuse, make sure that the turn indicator is working properly. After that look for broken wires along the circuit.

Mar 08, 2009 | Ford Econoline Wagon Cars & Trucks

2 Answers

98 chevy Blazer Turn Signals quit


Combination switch in the steering column is most likely bad

Mar 01, 2009 | 1997 Chevrolet Blazer

1 Answer

My directionals won't work


The fact that other than the turn signals themselves, everything else is working indicates to me that htere is something manually mechanical, not electrical casuing your problem. If you replaced the switch mechanism it is possible that in doing so the lever itself was set out of position and cannot operate the signals as it should, or the contact points on the switch itself are not meeting the way they should when the switch does go into position.

Jan 12, 2009 | 1990 Chevrolet Suburban

1 Answer

2000 ford windstar, directionals both not working, hazards work f


turn signal flasher module or turn signal switch. I usuall try to wiggle teh column switch or move it slowly up and down, back and forth to help determine if it has a bad contact. if i cant get a failure (or turn signal) that way I begin the testing at the base of the column. the flasher module is a common failure on those and isnt unreasonably priced. if i had no diagnostic procedure i would try that first. oh yea, try turning the hazards on and off rapidly several times. the signal goes through the four way switch.

Dec 31, 2008 | 2000 Ford Windstar

Not finding what you are looking for?
1999 Chevrolet Cavalier Logo

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...