Passenger side window is inoperative 1994 toyota camry
Window will go down ( I haven't run it all the way yet), but will not go back up- even with assist, the drivers side door swith will not operate the window in either direction. All the other windows and switches operate as they are supposed to. There has been no prior problems with this window or the window system in general--- Your assistance for a FREE Reply will be appreciated-- please advise of any fees before submitting a reply"""""""
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The master switch is the one located on the drivers side. If this switch has a malfunction it can rob power from the passenger side causing the problem you have. If the regulator/motor are in working order and you know the passenger switch is ok then that could be the problem. Another couple of possible problems could be a broken wire in the harness traveling from the car to the door (inside the rubber protective boot or a weak window motor (1990 is pretty old for a motor of that type.
more than likely one of the switches are bad (down side of switch works but up side of switch dont) being as the switches are wired together if one goes bad other one won't work either take the switch out one of back doors should be same as front passenger door put rear switch in front passenger door if works then u know front door switch is bad if it doesn't then drivers door switch is bad u replaced window regulator Did that come with motor too??? if not check to see if motor is good there is two wires going to motor cut isolation back on wires and using some jumper wires attach one wire to positive terminal of a 12 volt battery attach other wire to negative terminal of battery window should move up or down reverse connections and window should move other way
its on the driver sidde of the engine. You will see the radiator hose running to the thermostat housing. You must remove the radiator hose and thermostat housing to see it. also make sure your radiator caps seals aren't leaking, especially the one on the top passenger side of the engine!!
No.The drivers master power switch is probably bad.YOu will have to perform a test on the three other switches on the master. Check for power and ground when you push each putton.If the master switch fails the test you need a new master switch.
Perhaps an item got caught under the seat and possibly affected the linkage wire between rail tracks.A small linkage wire trips the console side track.Without this,that particular track will not disengage.Look under the good working passenger side seat and you might notice this linkage wire.It will then give you an opportunity to see if it works well on the inop seat. You can pull that wire(or trip that linkage arm by hand if you are in a dilemma and need the seat moved in order to drive but use caution on these moving parts and dont get pinched.
Can you hear the moter or do interior lights dim when pressing button? If so remove door panel and lubricate tracks and rolers using lithium grease lube only the tracks that do not come in contact with glass.
Check the connections at the switch and at the moter with a volt meter if there is power than time for a new moter. no power than check at drivers side switch. If no power there and fuse is ok you have a open in wires and will have to trace entire circut