An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: how to put a new drivers side mirror on
On the inside of your door there is a little plastic cover shaped like a triangle pull that off and there will be a couple of bolts and a wire disconnect the wire and take out the bolts then pull the mirror off the when you put the new on connect the wire then put the bolts back in and the plastic piece back on..
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There is a relay in the power block under the hood. Try to switch it out with the one for the horn. This is a easy test to see if your relay is bad. Both the relays are the same, so you will not short out anything.
on the drivers side of the center console there is a plastic screw that removes a cover the fuse is behind there i have found that the switches fail more often than anything else try rocking the switch back and forth firmly
There is some sealed units with no drain or fill. Or it could be on the driver side bottem of the transmission but is not accessable because it is too close to the frame. Hope you find it and its accessable.
Just a screw driver and a wrench or socket (actual size varies with cars) On the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door