Question about 2002 Ford F250 Super Duty SuperCab

Open Question

2000 Ford F250 Super Duty has no headlights with switch on

All other lights work. High beam indicator on dash is lit regardless of high beam lever location, does not turn off. Fuse 16 in passenger compartment fuse panel checked OK. Fuses 9 and 11 in power distribution box checked OK. One headlight bulb ( left ) looks OK. ???????

Posted by on

  • kevin carpenter May 11, 2010

    not uncommomn two see both headlamps go bad at once, buy one headlamp and in stall it. remeber this is a ford any think can happen , check your pig tail connections at the head lamp they prone for failure clips brake. do you hear a click when switching from high to low

×

6 Suggested Answers

  • 3 Answers

SOURCE: 2000 ford f250 super duty 4x4 7.3L diesel oil leak

The HPOP (high pressure oil pump) is right under the filter housing. There are 2 lines that distribute the oil to the cylinder heads. The o-rings on those fittings go out. Kit is available from Ford or International. You will need a special wrench to get to the fittings though.

Posted on Jun 23, 2008

  • 2 Answers

SOURCE: I have a 2007 ford

No its not just a ford problem. I just had this same problem with my lights on a 99 chevy suburban. Turned out to be a little relay switch located under the dash to the left of the steering column. The repair was about $20.00 but it works well now. You can also go to a website called Auto Forum and post questions regarding auto problems that's what I did first. The Gm dealer was useless for getting any information. Good Luck

Posted on Feb 05, 2009

chuck943
  • 783 Answers

SOURCE: ford expedition yr'00 headlight not working checked fuses..

The low beam headlamps have a seperate fuse for each lamp in the central or underdash fuse panel.
The right headlamp is fuse fuse 26 (10amp) and the left is fuse 28 (10 amp). These fuse are hot only when headlamps are on so you need to test them with a test light with headlamps on. If they do not have power to them then concern is either headlamp switch or daytime running lamp relay if your vehicle is equipped with this feature, or a bad multifunction switch.
Power leaves the headlamp switch on the RD/YE wire and goes to multifunction switch. It leaves multifunction switch on the other RD/YE wire The wire will then go thru either a connector c2003 located behind the passenger side air bag behind the dash or to the DRL relay if your vehicle has this feature and leaves there on RD/BK wire to the headlights .

Posted on Feb 24, 2009

  • 31 Answers

SOURCE: instr. panel and running lights fuse blow when headlights turn on

Do yourself a favor before taking to a dealer. Open the hood and find the fuse box. It will be on the firewall on the drivers side. Open it and fine the low beam relay. Finding it is easy. If you open your owners manual and look up relay in the index in the back of the manual there will be a listing of the relay locations. If you dont have the manual any more. A relay is a black or grey box. There are two diffrent types. The types look like a square and one looks like a rectangle. You are looking for the rectangle. The low beam relay is in the row of rectangle relays closest to the driver's side fender. Remove the two closest to the windshield. The one closest to the windshield is for high beam. Take that one and place it where the low beam is.If that fixes it go to an auto parts store and buy a replacement relay. Then try the lights. Let me know and good luck !

Posted on Mar 14, 2009

alicantecoli
  • 21949 Answers

SOURCE: High and low beam Headlights on a 1998 ford

new switch or one from a junk yard??

Posted on Mar 15, 2009

gpgab97
  • 77 Answers

SOURCE: diagnostic code meaning

Low boost. Here's a detailed forum explaining several techniques for trouble shooting.

http://www.powerstroke.org/forum/99-03-7-3-motor-problems/60995-engine-code-p1247.html

Posted on May 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 f-350 headlights not working. new mfs, new headlight switch, no power to fuses


Did you check fuse # F2.7 in the central junction box ? This fuse powers the main light switch an the MFS an the headlamp fuses ! Does your truck have auto lights ?

Jun 22, 2015 | 2002 Ford F-350 Super Duty

2 Answers

1999 Toyota Camry . Low beams work, but no high beam.


I would guess the switch on the steering column
is worn out,thus no high beam feature

That switch & that part of the lighting system has to be tested

Best if you have wiring diagrams & electrical skills

As with almost all folks that come to any web site, I assume
everyone ends up at a repair shop,because no one says otherwise

May 10, 2014 | 1999 Toyota Camry

1 Answer

Is my 2007 Lincoln Navigator (HID headlights) equipped with HIGH BEAMS? If so - they don't seem to work. Allow me to explain; 1. The headlights come on automatically in low light conditions. 2. The...


First of all are your headlights a double filament type headlight? If yes then I would suspect that a power wire to the high beams is broken or shorted. If your high beams are a separate set of lights from your regulars running lights then either the high beams headlights are missing. or has a broken power wire or shorted or...You could check the fuse box under your dash and under the hood of the car to see if you have a fuse for the high beam lights.

Oct 28, 2013 | Cars & Trucks

1 Answer

2003 Ford F250 headlights will not come on.


Check the fuse in the engine fuse junction box the fuse is listed F 2.7 this is a 30 amp fuse. It supplies power to the multifunction switch and the main light switch. Do a test headlamp switch on flash the high beam do they come on. Then you need a multi function switch

Mar 09, 2012 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

2002 f-350 headlight issues


I'm not sure about your model, but my 1991 EB Ford has a high-beam relay in the engine bay, near the battery. When you find it, replace it, and I'll bet your lights work then.

Nov 18, 2011 | 2002 Ford F350 Super Duty DRW Reg. Cab

1 Answer

On my f250 super duty, the left low beam head light does not work - high beam OK. Already changed bulb


my 2000 f250 did the same thing. i did what you did also. changed bulbs everything else, but had to bring it in to have the wireing harness changed and that seamed to do it. Check the connection (plug) that goes into the light. mine was over heating and causeing the bulb to burn.

Sep 20, 2010 | 2000 Ford F250 Super Duty Crew Cabs

2 Answers

Camry headlights not working


it sounds like a bad light switch

Mar 25, 2010 | 1993 Toyota Camry V6

1 Answer

Ford Focus Flight 2005


The main/high beam relay/switch must be stuck on high presuming the high beam stalk selector does not operate. Probably needs replacement.

Oct 17, 2008 | 2005 Ford Focus

Not finding what you are looking for?
2002 Ford F250 Super Duty SuperCab Logo

Related Topics:

225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...