Question about 2004 Ford Focus

1 Answer

Ford focus zetec 53 plate

I was driving on the motor way, roughly about 80 mph and my break light came on, i slowed down and the light went from being bright to slightly dull. This stayed on for a couple of days. I check the fluids all were fine and then the light went out. What could be the problem

Posted by on

  • Greg Wilkins
    Greg Wilkins May 11, 2010

    Is there wires running to the Brake fluid reservoir?

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 99 Answers

Hi where the brake fluid goes check the wires on the cap wiggle them around and have a friend look at the light for any changes (could be faulty connection) also have the brake pads checked to make sure they are not to low and activating the sensor, if all is good there then it sounds like a faulty sensor, Hope this helps

Posted on Dec 04, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is the maximum speed of ford focus 2001


The 2011 Ford Emphasis Design Array Provides You A lot more Choices in Body Design, Engine, Transmissions, as well as Various Readily available Alternatives. The basic transmission is a five-speed guidebook with an optional six-speed PowerShift Automatic. The 2016 Ford Emphasis is mainly a carryover from in 2011. A six-speed handbook transmission permits accuracy changes, and also 4 various offered drive settings offer vehicle drivers, even more, means to place the power down on the track. An ingenious Ford Efficiency Four-wheel drive configuration with Dynamic Torque Vectoring permits class-leading catching rate as well as makes the Emphasis RS an extremely enjoyable vehicle to own at any kind of rate.
Check out 2001 Ford Focus Cloud 9 White Clearcoat ZTS Zetec FWD 4-Speed Automatic 2.0L I4
Ford Dealership near Buford GA Ford Dealer near me Angela Krause

Oct 10, 2016 | 2001 Ford Focus

1 Answer

57 plate, Ford Focus Zetec, 1.8 diesal. ABS warning light,Steering Failure Assist light and Battery light on again. Alternator replaced 9 days ago, and been sluggish,heavy steering since and now won't...


2009 Ford Focus Zetec, 1.8 diesal. ABS warning light,Steering Failure Assist light and Battery light all on. Can't steer car. Then takes twenty minutes to restart car. Any ideas?

Dec 26, 2010 | 2008 Ford Focus

1 Answer

The car hasn't got any go to it after 70 mph. its a 2009 ford focus zetec 1.6 auto


You should not be driving 70 mph in the first place. Later in life you will out grow that practice.

Oct 01, 2009 | 2009 Ford Focus

2 Answers

Alarm warning sound bit no warning light on dash board, cmax


It maybe the seatbelt connection fault as some fords don't all have an illumination on dashboard

Jul 03, 2009 | 2004 Ford Focus

1 Answer

Rear wiper stopped working on my 2000 1.6 Focus Zetec auto


IF IT IS A HATCHBACK(3DOOR)THE WIRING FROM THE HATCH TO THE BODY BREAKS.BUT IF THE MOTOR WAS GOING SLOW THEN STOPPED.SOUNDS LIKE THE WIPER MOTOR IS BAD

May 05, 2009 | 2001 Ford Focus

2 Answers

Air bag light keeps coming on in ford focus 03 plate zetec 1.6 wa


Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.


Just push it together properly and it should clear the AirBag fault


Apr 08, 2009 | 2003 Ford Focus

1 Answer

How easy is it to replace a noisy clutch thrust bearing. 53 plate Ford Focus 1.6 petrol zetec.


The thrust bearing is normally a part of a new clutch kit.Comprises pressure plate, clutch plate and thrust bearing.You will need to remove the gear box to change the bearing.The bearing basically slides onto the gearbox shaft. Recommend changing all three rather than just the beaing.You may want to get quotes from garages as dealers are expensive.

Mar 08, 2009 | 2003 Ford Focus

1 Answer

Cant get second or third gear


on your focus you got a hydrolic clutch get someone to check that you have got no air in the
clutch system .

Feb 28, 2009 | 2003 Ford Focus

Not finding what you are looking for?
2004 Ford Focus Logo

Related Topics:

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5626 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...