Question about 1999 Isuzu Rodeo

1 Answer

Clutch kit for a 99 rodeo 5 speed 3.2 v-6

I'll be replacing the clutch soon and I was wondering what all I should replace while I have the suv up and apart, fluids,seals,etc.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 261 Answers

Replace the complete clutch assembly which includes the disk, pressure plate and the release bearings, some of them also have a polot bearing / bushing, replace it while you are at it make sure that the fly wheel is nto overheated or scored if it is replace the fly wheel or atleast machine the fly wheel in a machine shop, and replace the rear main engine oil seal. when every thing is out and dont forget to rate me please

Posted on Dec 04, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

99 Isuzu rodeo 5 speed stuck in 4th gear stalls when forced into neutral


You need to see a transmission / clutch specialist for a proper diagnosis

Jul 03, 2015 | Isuzu Cars & Trucks

2 Answers

99 Isuzu rodeo "99 Isuzu rodeo 5 speed stuck in 4th gear stalls when forced into neutral" triple posted now.


see your other post Richard, the transmission, gearbox is fairly complicated and any sstatement given here would be seculation.
Whatever
Manual transmission gets stuck

Jul 03, 2015 | Isuzu Cars & Trucks

1 Answer

I have a 1994 Isuzu Rodeo 5 speed V6 3.2L, it'll


Sounds like clutch adjustment or replacement. (Not disengaging the trans fully). Check to make sure you have enough juice in the clutch master reservoir and that there isn't a leak at the clutch slave cylinder first.........

Sep 13, 2013 | Cars & Trucks

2 Answers

I have a 05 Kia Spectra 5 speed manual transmission. The clutch is slipping. Is there any way to adjust the clutch or do I have to replace the clutch?


What mileage? where does the pedal "take up". You have given no really useful information to assist.On experience I will say this. The clutch may be worn or spirngs weakened through your poor driving techniques... or it could simply have engine oil on it from a faulty rear main seal...whatever it is you should have the box out and the items inspected yes for analysis..but replace the oil seal, machine flywheel (sanding is NOT good enough and instal a new clutch kit. .

Clutches slip at every clutch change..but that is limited.... a slippng clutch during driving should always have the flywwheel machined and the work done as stated above. Cheers Tony.

Jan 27, 2011 | 2005 Kia Spectra

1 Answer

2000 Isuzu rodeo.2.2 5 speed. Manual clutch. Pedal sticks to the floor.....no pressure. No dot 3 fluid so I added and pumped well over 100 times..still no pressure. Can't change gears. Car starts.


You have air in the line, and your slave is probably leaking. Check slave for leak and replace if leaking. Then bleed system of air at the slave bleeder. If you need instructions, please let us know.

Sep 20, 2010 | 2000 Isuzu Rodeo

1 Answer

1995 Isuzu Rodeo 4cyl 5-speed 2.6L engine starts and runs smooth for 1 min then idles rough, misses and dies. Just replaced oxygen sensor, had head and gasket replaced after overheating, fan clutch...


make sure you are using the right firing order and all the plugs are good i head this problem could just need to adjust the timing just a bit

Aug 08, 2010 | 1995 Isuzu Rodeo

1 Answer

1998 rodeo 5 speed getting hard to put in gear


ur cluch is burnt out you should probably get a new one and soon

May 28, 2010 | 1998 Isuzu Rodeo

1 Answer

I have a 95 Isuzu Rodeo and it has a hard time going into gear during the initial start. It goes smoothly into gear after the SUV has been running for a while. The clutch was replaced last year and I was...


in short its a ,,,yes! i would check the oil in the gear box it may need just toping up if its low you can do damage to the box so its well worth a look at, also this could well be the fault you are having no or little oil around the gear box on start up after it turns over a fuw times the oil is up the gears

Dec 29, 2009 | 1995 Isuzu Rodeo

1 Answer

Hard to shift 5 speed manual speed transmission on 1995 rodeo


pending on the type of clutch in the vehicle, you may be low on clutch fluid. (if your clutch is hydraulic)
other than that it is most likely the entire clutch itself.

Jun 16, 2009 | 1995 Isuzu Rodeo

1 Answer

99 PSD AUTO-MANUAL CONVERSION KIT ?


It would be cheaper to fix the automatic

Feb 23, 2009 | 1999 Ford F350 Regular Cab

Not finding what you are looking for?
1999 Isuzu Rodeo Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...