Hi there:
Check this Removal Procedure...
1. Remove the rear bumper step pads.
2. Remove the license plate lamps.
3. Remove the nuts and the bolts that retain the rear bumper impact bar to the bumper bracket.
4. Remove the rear bumper impact bar from the vehicle.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the rear bumper impact bar to the vehicle as follows:
1.1. Position the bumper impact bar on the bumper brackets so that the
holes in the impact bar are aligned with the bracket holes.
1.2. Install 2 bolt plates and 4 nuts on top of the impact bar.
1.3. Install 2 bolt and nuts through the bottom of the impact bar.
Tighten the rear bumper impact bar nuts to 90 N.m (66 lb ft).
2. Install the license plate lamps.
3. Install the rear bumper step pads.
Hope this helps; also keep in mind that your feedback is important
and I`ll appreciate your time and consideration if you leave some
testimonial comment about this answer.
Thank you for using FixYa, have a nice day.
Go under the truck and remove the four to six bolts that hold it to the frame and into the wiring harness then careful lower the bumper down with a hydraulic floor jack.
SOURCE: Remove rear plastic bumper cover
please email me at [email protected] with any other info or questions if you have already gone to a body shop
SOURCE: Rear axle removal
Remove wheel, remove rear diff cover, remove small bolt that retains spider gear cross shaft in the carrier. Push axle in, remove "c" clip on end of axle and remove axle from housing. Reverse to replace. Only problem you may have is that sometimes small bolt is broken inside carrier. if broken you will need to drill a tiny hole into it and remove with tiny "easy out" or other similar device.
Do not turn carrier when shaft has been removed or spider gears will rotate and fall out!
SOURCE: how do i remove a rear bumper from a audi a4
If I remember correctly, you just push forward and pull the side out, just like the front bumper.
SOURCE: Volkswagen Passat rear bumper removal
all the screws/bolts are underneath the plastic cover.hex head.(allen key)
2,602 views
Usually answered in minutes!
×