Question about 1999 Plymouth Grand Voyager

1 Answer

1999 PLYMOUTH GRAND VOYAGER SE

WHAT I NEED IS NOT THE DASH WERE U SEE THE GAUGES AND THE A/C CONTROLS AND ALL I NEED TO FIND A WAY TO GET THE PIECE WHERE THE WINDSHIELD DEFROSTER AIR COMES OUT THE SPOT WHERE THE 5 1X4 SPEAKERS ARE I NEED TO REPLACE THIS THE DASH IS FINE I NEED THAT PIECE HOW TO GET IT OFF AND WHERE TO FIND A REPLACEMENT ONLINE??? OR JUNKYARD?? WHICH IS CHEAPER???

Posted by on

  • xxnissansilv Dec 05, 2008

    well how do i get the clips off without breakin my dash then how do i get the new one bak on?? without breakin it

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 251 Answers

Junkyatd and it just pops off held on by clips

Posted on Dec 04, 2008

  • Shaun Plencner
    Shaun Plencner Dec 05, 2008

    use a flat screw drive to pop it off

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I down load the user manual for a 1993 Plymouth grand voyager SE?


Plymouth.com/manuals Look for your year. You may have to look under archives.

Dec 28, 2014 | 1993 Plymouth Grand Voyager

1 Answer

1998 plymouth grand voyager cluster illumination


I would check the dash lights fuse first. If the fuse is good and the circuit has voltage, you may have toasted the dimmer control.

Aug 13, 2012 | 1998 Plymouth Grand Voyager

1 Answer

1998 Plymouth Grand Voyager SE the instrument panel gauges does not work. what could be wrong


Here's a good link to a common problem regarding the dash cluster. Not too bad removing it and performing this if handy at all.

http://www.flickr.com/photos/landar/show/with/3474557830

Jun 02, 2011 | 1998 Plymouth Grand Voyager

1 Answer

1999 Plymouth Voyager engine compartment fuse/realy diagram


I have to assume you have lost the cover for it, as the schematic/Map, is on the underside of it.

May 24, 2010 | 1999 Plymouth Grand Voyager

2 Answers

1998 Plymouth Grand Voyager instrument cluster problem


There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over time thru vibration and such one of these solder joints will fail (happened on or 1999) you can repair this though. You will have to remove all of the trim from around the driver's side dash board, this will include the trim towards the center of the dash. Once these pieces are remove you'll need to remove the gauge panel (I believe (4) allen head screws) carefully bring the panel and release the wire clip from it. Looking at the back of the panel, where the plug was, carefully with plenty of light look for one of the pins to have a failed solder joint. It will be very faint however the failed joint will be a fine dark line around the pin. To correct use a small soldering iron and reheat this solder until it wants to flow, let it cool and reassemble.
As I fore mentioned I had the exact same issue as you are describing, our is a 99. The most tricky part is the dash, take your time with it.
I hope this may have assited you,
Tom

Oct 13, 2009 | 1998 Plymouth Grand Voyager

1 Answer

A/c blowing warm air


Start from beginning at source line going through firewall which may be attached at brake booster, or back of intake manifold, then to back of controls. Take a piece of hose if necessary, hold it up to your ear and use it to assist in hearing a hissing sound, under dash on passenger side, in behind controls etc, it may help you pinpoint it.
Do any of the doors sound like they are moving at all?

Jun 20, 2009 | 2000 Plymouth Grand Voyager

1 Answer

Air bag sensor location 1999 plymouth grand voyger se


Should be part of the ACM, (airbag control module) located behind center console, near firewall, but PLEASE BE AWARE, "VERY DANGEROUS " item to fiddle with as airbag(s) could deploy if proper steps are not taken by knowledgeable technician, prior to attempting any repairs to it.

Mar 07, 2009 | 1999 Plymouth Grand Voyager

Not finding what you are looking for?
1999 Plymouth Grand Voyager Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

63661 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...