Question about 2004 Volkswagen Jetta

1 Answer

Would like to know how to change the oxygen sensor on a 2003 vw jetta 2.0 the one behind the 3-way catalytic converter

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 345 Answers

Difficult to get to unless you have a garage lift,but you can get to it from the top,the connecting plug is underneath on the drivers side in a small black box....good luck..

Posted on Dec 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many o2 sensors are on a 1999 Silverado 5.3


The 1999 5.3 V8 engine had 4 oxygen sensors. There are two catalytic converters on this engine, one on the driver side of the engine, and one on the passenger side of the engine. This is important to know, as the number of oxygen sensors is directly related to the number of catalytic converters on the vehicle. Driver side is referred to as Bank 1, passenger side is referred to as Bank 2. This is very important to know when looking up replacement oxygen sensors. There is one oxygen sensor in front of, or before the catalytic converter, usually referred to as a pre-catalyst O2 sensor. There is also one behind, or after the catalytic converter, usually referred to as a post-catalyst oxygen sensor. So, you have two oxygen sensors on Bank 1, and two oxygen sensors on Bank 2, for a grand total of 4 oxygen sensors.

Oct 03, 2013 | 1999 BMW 318 ti

1 Answer

01 vw Jetta trubo 2.0 code p1113



Trouble Code: P1113

O2 Control (Bank 1 Sensor 1) Internal Resistance Too High
Possible Causes:


Oxygen sensor (before catalytic converter) is faulty. Oxygen sensor (behind catalytic converter) is faulty. Oxygen sensor heater (before catalytic converter) is faulty. Oxygen sensor heater (behind catalytic converter) is faulty. Circuit wiring has a short to power or ground. Engine Component Power Supply Relay is faulty . E-box fuses for oxygen sensor are faulty . Leaks present in the exhaust manifold or exhaust pipes. HO2S signal wire and ground wire crossed in connector . HO2S element is fuel contaminated or has failed. ECM has failed .Here is what is listed.

Sep 05, 2012 | Volkswagen Jetta Cars & Trucks

1 Answer

Code of PO174 1 system too lean (bank 1) Code PO420 Catalyst efficiency below threshold (bank 1) Code PO430 Catalyst efficiency below threshold (bank 2)


hi,my friend, you can try,

Check for exhaust leaks at the manifold, pipes, catalytic converter. Repair as required.

Use a scope to diagnose the oxygen sensor operation (Tip: The oxygen sensor in front of the catalytic converter normally has a fluctuating waveform. The waveform of the sensor behind the converter should be more steady).

Inspect the downstream heated oxygen sensor (HO2), replace if necessary

Replace the catalytic converter

Sep 14, 2011 | 2003 GMC Yukon XL

2 Answers

I have an 03 Camry 4cyl LE that needs an O2 sensor. Does this model have more than one sensor? I have gotten conflicting info about the number of sensors and corresponding pns.


YOU HAVE 2 OXYGEN SENSOR UPSTREAM OXYGEN LOCATED ON THE EXHAUST MANIFOLD. THE DOWN STREAM OXYGEN SENSOR LOCATED BEHIND THE CATALYTIC CONVERTER.YOU CAR HAS ONLY 2 OXYGEN SENSORS.

Aug 05, 2011 | 2003 Toyota Camry

1 Answer

Where is the oxygen sensor located on a VW jetta 1998, 4 cylinder engine? I was told there are 2, I need to know where the top one is located.


They are going to be found on your exhaust pipe. One is located before and after the catalytic converter.

Sep 22, 2010 | 1998 Volkswagen Jetta

1 Answer

P1176 2000 VW JETTA ALREADY CHANGED THE 02


17584/P1176/004470 - Bank1: O2 (Lambda) Correction Behind Catalyst: Control Limit Reached Possible Causes
  • Intake Air System leaking
  • Oxygen Sensor(s) and/or Oxygen Sensor Control faulty
Possible Solutions
  • Check Intake Air System for Leaks (False Air)
  • Check Oxygen Sensor(s) and/or Oxygen Sensor Control (all of them!)
This is the pre 02 sensor located before the catalytic converter.

May 10, 2010 | 2000 Volkswagen Jetta TDI

1 Answer

Install heated oxygen sensor number 1 in volswagen jetta


Hi:
The Number 1 Heated Oxygen sensor is located in front of the catalytic converter. You would need to get the car up in the air, and then disconnect the electrical connector, and possibly need a special socket to remove the sensor. Also remember to purchase and use Oxygen sensor safe anti sieze compound on the threads of the new sensor, if you do this your self

Oct 30, 2009 | 2003 Volkswagen Jetta TDI

1 Answer

Check engine light on for sometime; Response to throttle sluggish


If your catalytic converter is "below efficiency" or otherwise clogged, you will lose power as you drive and the vehicle heats. The more you drive the vehicle, the worse the problem will become. The exhaust can't escape properly through the catalytic converter, therefore your engine won't run properly. Your issues are related, and if you replace your catalytic converter they should go away.

May 26, 2009 | 2001 Volkswagen Jetta TDI

1 Answer

CATALITICO


some time a bad oxygen sensor can give you a code like you got they change the sensor first its cheaper then the converter catalytic if no more code good if not they change the catalytic the oxygen sensor was change for nothing hope it help you thank you pierre

Jul 30, 2008 | 2003 Volkswagen Jetta TDI

Not finding what you are looking for?
2004 Volkswagen Jetta Logo

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...