Question about 2003 Honda Pilot

2 Answers

Need to find the fuse box to disconnect it - 2003 Honda Pilot

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My fuse box is on the bottom panel near the passenger door, under the glove box...

Posted on Feb 03, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 109 Answers

Check under the dash behind the plastic panel on the left side under the steering wheel..

Posted on Dec 04, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I need to disable my truck myself isn't there something I can disconnect or a fuse I could just take out


Pull the fuel pump relay ! simple . in the underhood fuse box , should be marked on inside of the fuse box lid . You don't say what make . model or year vehicle . You could disconnect power connection to ignition module , pull the PCM fuse in the under hood fuse box .

Oct 08, 2016 | Cars & Trucks

1 Answer

How do I remove the complete fuse box from this unidentified vehicle?


generic answer --disconnect battery disconnect feed to fuse box unbolt box than carefully pull every wire from bottom you can photograph each location or make a diagram for each wire color and placement

Aug 30, 2015 | Cars & Trucks

1 Answer

Put a new fuel panda starter in 97 chevy silverado 5.7 engine but still doesn't crankup.checked fuses under the hood and the only ones that didn't light up was the ign, eng, and ecm fuses.i could sum...


I am a little confused by your light test of the fuses. If you put a test light across a fuse while in the fuse box it will light if the fuse is bad. A good fuse should let the power go through the fuse first instead of the light so a good fuse should not light a test light. That fact you jumped the fuse with wire also suggests the fuse is bad but you grounded it directly to the body instead of letting the power run its proper course through the wiring harness. That's probably why you can't get it to shut off unless you disconnect the wire.

Mar 24, 2015 | Cars & Trucks

1 Answer

Lighter socket not working ,, looked at fuse box under bonnet found nothing


Check the interior fuse box...probable location is behind the glovebox....you will need to remove the glovebox to gain access. Open the glove box, reach in and disconnect the glovebox tray and hinges. Once the glovebox is out, you should be able to get to the fuses.

Mar 05, 2014 | 2003 Ford Mondeo

1 Answer

2005 vw Jetta no power to the radio


changing a battery should not blow a fuse if changed correctly ie ign off and all electricks switched off ,,,, disconnecting earth first and connecting it last when putting in new battery ,,,,, maby its just a security code you need for it as this will happen in some cases when you disconnect the battery ,,,,, if it is a fuse i do not know the fuse number but it will be a low ampage fuse ,, usually a 5 amp fuse ,,, most cars have a few fuse boxes now so look for two fuse boxes at least ,,,

Dec 06, 2013 | 2006 Volkswagen Jetta

1 Answer

How do i change a mega fuse in a 2003 chevy trailblazer? Do i need to disconnect the battery first?


THE FUSE LINK TO ALTERNATOR. YOU HAVE TO DISCONNECT NEGATIVE BATTERY CABLE BUT FIRST TURN OFF RADIO BEFORE DISCONNECTING NEGATIVE BATTERY CABLE.TELL ME WHAT SIZE MEGA FUSE YOU REPLACING 40 AMP FUSE IN FUSE BOX..FORD CARRIES MEGA FUSE 175 AMP FUSE A MEGE FUSE DOES SAME JOB FUSE LINK.YOU NEED TO REPLACE FUSE LINK.FUSE LINK IS HEAVY GAUGE WIRES TWISTED TOGETHER THEN USE ROSIN CORE SOLDER AND SOLDER WIRES TOGETHER.WRAP A LOT OF ELECTRIC TAPE AROUND SOLDER WIRES TO KEEP FROM GROUNDING STARTING A ELECTRICAL FIRE. FUSE LINK LOCATED IN THE WIRE FROM THE BATTERY TO THE ALTERNATOR YOU WILL SEE WORDS FUSE LINK ON THE LINK.

Aug 27, 2011 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

1998 Ford F150. windshield wipers,interior light,and warning alarm system not working.Fuse and relays are good.


check to see if you have corrosion in the fuse box or the GEM module, by removing the fuse box completely, disconnect the battery, take out the two screws and two 8mm bolts that hold the fuse box in, it will take some maneuvering to get it positioned right to disconnect the two wiring harnesses from the fuse box, they are bolted through the middle. Once removed, take the GEM module off the back of the fuse box and look for what would be something like the same corrosion you would see on your battery posts, usually one of these components is corroded and causing the problem, my buddy got a replacement fuse box for his from a wrecking yard for only 15 dollars, with all the fuses and relays. If you have this corrosion, then you probably have a windshield leak at the lower left hand corner of the windshield, it lets water drip onto the fuse box and GEM module. Hope this helps, let me know

Nov 03, 2009 | 1998 Ford F150 Regular Cab

1 Answer

Trying to find the fuel pump FUSE.


There is no fuse specifically dedicated to the fuel pump on this year and model of Suburban. This Suburban is equipped with dual tanks and as such has two relay switches, primary and secondary, both of which are located at the main fuse box in the engine bay, that power up the respective fuel pumps.

The closest fuse (15A) controlling either of these relays also powers up the main control module (located beside and below the main fuse box). So, if one needs to disconnect the fuel pumps from functioning, then the only effective method is to disconnect the fuel pump relays.

May 27, 2009 | 2003 Chevrolet Silverado Ss

1 Answer

Need to disable alarm on my v reg Ford escort 1.8 van 55


check the fuse box under the hood on the passenger side next to the fire wall it is actually a relay box but it has some fuses in it..

Dec 04, 2008 | 2000 Ford Escort

1 Answer

Fuse


The fusde is bolted in. You need to unbolt the fuse box, and then pull the fuse panel out of the box to access the bolt. Make sure that you have the battery disconnected when you do this.

Sep 05, 2008 | 1993 Toyota Corolla

Not finding what you are looking for?
2003 Honda Pilot Logo

Related Topics:

232 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...