Question about 2001 Hyundai Elantra

1 Answer

I own a 1999 Hyundai Elantra 4 door the Heater will not work

I would like to know what I need to get to fix the heater so it will heat.I get nothing. I hope you can help

Posted by on

  • collinsa Dec 04, 2008

    the heater has been acting up going on and off all we did was hit the dash move the controls and it would go back on but you could only get the blower go up to number 2 or it would not work. Now it dont work at all so it is very cold in the car. We have not done anything to fix since it just stopped today and are in hope that someone would be able to tell us what to replace or fix. I will have my husband look at the hoses but hope someone might know what part we need or if the hoses are not the problem what it might be thanks for reading.

  • yadayada
    yadayada May 11, 2010

    What have YOU done to try and fix it?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Black rubber vacuum hoses are often a cause for heater failure, especially in older cars. Anytime the hood is up and engine is cool start inspecting and following these hoses as far as possible. They should be firm, springy upon pressing and fairly smooth. If soft,crumbly,powdery,oily, stiff/inflexible etc. they should be replaced. The ends should fit very tight over their fittings. Vacuum hose is not expensive so just replace any which are suspect. You may get lucky and find a leaker. If not you have eliminated a future leak. Be sure to mention the vac. hoses have been replaced if you need to write back and ask more questions.

Posted on Dec 04, 2008

  • olderstudent Dec 04, 2008

    It now sounds like it could be a loose electrical connection since it was intermittent and hitting/operating caused it to work some. First check all fuses to eliminate them as possible problem. The fan blower control switch may be the problem but may also be very difficult to access, depending on vehicle. Don't pound the dash but somehow try to wiggle the wires which go to the switch. If blower activates any then it probably needs replacing or proper reconnection. All the time be looking for clips, screws, fittings that may release the control panel. These can be hard to see/find. Search web for repair manual. Try AutoZone.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No heat /but blower works in my hyandi elantra 2004. Whats wrong?


Either heater control valve stuck or blend door is stuck depends on if you have climate control or standard controls. Also make sure it full of coolant.

Apr 03, 2015 | 2004 Hyundai Elantra

1 Answer

Clean a heat coil for hyundia elantra 1999


get the cooling system flushed, that also clears out the heater core.

Sep 23, 2012 | 2001 Hyundai Elantra

1 Answer

How do I fix the heater


Check your antifreeze level/condition, check thermostat, check heater control valve for leaks/faults. Sorry it took so long to answer.

Dec 08, 2011 | 2000 Hyundai Elantra

2 Answers

I have no heat in my 2004 hyundai elantra..turn it on and nothing


Check for a blown fuse. If there is no blown fuse then I woudl replace the heater fan relay.

Dec 15, 2010 | 2004 Hyundai Elantra

2 Answers

2002 Hyundai Elantra, thermostat, radiator, and fluid has been


the solenoid that opens the hot water into the coil is not opening

Dec 31, 2009 | 2001 Hyundai Elantra

1 Answer

Hyundai elantra air cond heater stuck on heat from when you start the engine with fan only on and the cold /hot control at full cold it blows red hot


sounds like the heat blend cable is either dislodged or frozen, the cable runs from the control head to the blend door located on the drivers side just above the gas pedal ,it is not an easy job to replace, i sugest to take it to your local dealer, its not that costly and they will know exactly what to fix.

Nov 29, 2009 | 2001 Hyundai Elantra

1 Answer

The heater works great, however, you can't direct the air


The possible causes you describe are many... Take/tow the vehicle into a Hyundai Service Center (dealership), pay the diagnostic fee. They will tell you EXACTLY what the problem is and what's needed to fix it (parts, labor, tax, time-frame, etc.).

Jun 12, 2009 | 2000 Hyundai Elantra

1 Answer

Does not heat in idle


is the heater fan working

Jan 20, 2009 | 2001 Hyundai Elantra

1 Answer

Heater control switch


To replace the control module, you'll need to remove the front dash facia panel to access the virtical console modules. Four (4) phillips head screws must be removed to pop out the this panel.
16ad4e6.jpg
def318e.jpg The facia has several 'clips' which pop loose when you pry it out.

cba91a1.jpg As you can see, there are four (4) screws in the environment control module. Reassembly is in reverse order.

Dec 22, 2008 | Hyundai Motor 2003 Elantra

Not finding what you are looking for?
2001 Hyundai Elantra Logo

Related Topics:

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...