Question about 1991 Toyota Camry

1 Answer

1991 camry alarm won't let it start

Alarm went off and my friend disconnected the battery to make it stop. Now it will not start. Is there anyway to bypass this feature since I don't have a remote to it or should I just junk this car?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 65 Answers

Put the key if the door lock and unlock it and see if that unarms it

Posted on Dec 03, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vats system


Instructions
    • 1
      Insert your key into the ignition. Turn the key forward until it can go no further, without starting the vehicle.

    • 2
      Press and hold the "Valet/Override" button located under the dash. Hold the button until the blinking LED light on your dash is solid. Switch your "Valet" button to "Off" if you have a button labeled "On/Off." Your alarm should now be reset. If you wish to enable the alarm, repeat these steps to turn the alarm back on.

    • 3
      Remove wires from your battery if you wish to temporarily turn off your alarm. Disconnect the wire connected to the main power source to permanently disarm your alarm. Trace all wires connected to your battery and disconnect them. If you have no familiarity with your vehicle's wiring, you should take your vehicle to a neighborhood installer to disconnect the wires for you.


God bless you

May 31, 2013 | Pontiac Firebird Cars & Trucks

1 Answer

1997 jeep grand cherokee won't start after alarm went off


I just had the same prblem. Reconnect your alarm first of all. You need to use your key bob "remote" to deactivate the alarm before starting. It is a feature "good one" i might add that should someone try to steal it the jeep will not start until u deactivate it w theke bob.

Jan 20, 2013 | 1997 Jeep Grand Cherokee

2 Answers

92 Toyota 4runner truck was running perfectly fine Later in the day went to start and the alarm just started going off and wouldn't turn off. Truck won't start even with keys turned in igniti


The alarm system somehow got activated , this is usually because the battery becomes discharged or disconnected try doing this:
Remove the key from the ignition
disconnect the negative battery terminal
put the key back in and turn to ON
exit the truck and leave door open
reconnect the battery terminal
get in and leave door open, if the alarm horn stays off it should start.

Dec 07, 2012 | 1992 Toyota 4Runner

1 Answer

2001 mercury cougar can't get car to start alarm light lit and steady what do I do


sounds like your alarm is preventing the car from starting.

you can disconnect your negative battery cable, and wait about 10 minutes. put the key in the ignition and turn it to the ON position, but NOT to the START position. reconnet the battery cable CAREFULLY with the key ON, and the driver's side door OPEN. your alarm should "chirp" a few times, while reconnecting the battery. afterwards, try to start the car when the battery is tightly connected.

if the car still refuses to start, use the "panic" feature on your remote, to intentionally set off your alarm, and then turn it back off, to make sure it stops properly.

if this does not work, remove the fuse for your alarm, and try to start the car again without the fuse in place.....otherwise replace the fise and remove the pwoer connector from your alarm.

your actual alarm should be behind the trim plate, on the bottom side of your dash, above your gas and brake pedals....then try to start the car AGAIN....

if none of this works, then your alarm is defective and needs to be serviced be the installer, or manufacturer. also, calling the manufacturer will help too, as they have "reset and disable" features that can literally "bypass" your alarm.

Oct 03, 2009 | 2001 Mercury Cougar

1 Answer

Car wont start


Sounds like you have a shorted wire causing a drain. I recommend disconnecting the alarm all together which should stop the short so battery can remain fully charged.

Jul 09, 2009 | Hyundai Motor 2002 Sonata

1 Answer

Alarm won`t stop, can`t start 96 jetta trek


find the fuse for the alarm and pull it out tha=is should solve it, but means you have no alarm

Jun 06, 2009 | 1996 Volkswagen Jetta

2 Answers

Car alarm wont let me start the car it wont stop going off


try unhooking the battery while the battery is disconnected turn the ignition on leave the ignition on while you reconnect the battery this should override the alarm

Jan 31, 2009 | 1994 Volkswagen Golf

1 Answer

How can I reset my Factory Alarm on my Jeep it wont run


Alarm Module Reset Procedure
NOTE: This information applies to a Vehicle Theft Security System (VTSS) that was armed when the battery was disconnected and reconnected.
When the armed VTSS senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed following a battery reconnection.
The power-up mode will also apply if the battery goes dead while the system is armed and battery jump-starting is attempted. The engine no-run feature will prevent the engine from starting until the alarm system has been actively or passively disarmed.
Passive disarming of the Vehicle Theft Security System (VTSS) occurs when the vehicle is unlocked using the key to unlock either front door or the lift gate. Active disarming of the VTSS occurs when the vehicle is unlocked by depressing the Unlock button of the Remote Keyless Entry (RKE) transmitter.
Once the alarm has been activated (horn sounding, lights flashing, and the engine no-run feature), either disarming method will deactivate the alarm.
Depressing the Panic button (if equipped) on the RKE transmitter will also disarm the VTSS, but the horn will sound and the lights will flash for about three minutes as part of the Panic feature. The horn and lights can be stopped by pressing any of the RKE transmitter's buttons or driving the vehicle above 15 mph.

Jan 28, 2009 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
1991 Toyota Camry Logo

Related Topics:

306 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

67912 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22011 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6817 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...