Question about 2000 Chevrolet Prizm

1 Answer

Heater fan motor

The fan for heater only works on high.

Posted by on

  • Anonymous Dec 15, 2008

    only works on high

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 37 Answers

You most likely need a blower resistor

Posted on Dec 06, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I fix heater fan to operate at low and medium speeds. It only works on High.


depending on car some have a fan relay or its your switch itself

Jan 13, 2016 | Cars & Trucks

1 Answer

Heater / air conditioner fan control doesn't engage fan. Previously, it only worked in high speed.


I would replace the blower motor resistor first then see if that corrects this. The resistor is located next to the blower motor under the dash.

Jul 16, 2012 | Cars & Trucks

1 Answer

1986 TOYOTA CRESSIDA FAN BLOWER DO NOT LAST BECAUSE IT ALWAYS WORKS ON HIGH


A heater motor only working on high is a sign of a bad heater blower resistor. It is mounted near the heater motor and is replaceable. (Normally behind the glove box door.)

Dec 08, 2010 | 1986 Toyota Cressida

1 Answer

My heater fan on my 99 jeep chereeke Larado does not work on high and the next lower squeeks so bad at first and then quits and does work but it's getting colder and I need the high to work.


heater fan relay i believe blower motor relay it controls the speed of the fan or your blower motor may have something stuck in it or its starting to go bad

Dec 03, 2010 | 1999 Jeep Cherokee

2 Answers

Heat/ac fan only blows on high


Check the heater control switch,,,,,and the number of wires at the heater motor....Some motors have more than one winding...in which case there will be three or more wires going into motor..there can be burnout in those windings and will require a new motor....check the plug which attaches to the motor....can be bad connection...or at the switch.....but if there is only two wires....then the heater switch uses resistors to slow down the different speeds...and direct connection for high speed....and the problem is definitely the switch...

Apr 27, 2010 | 1996 Lincoln Town Car

1 Answer

Heater control only works on high and fan doesnt blow heat thru the vents sounds like its a fan being blown in the wind.


100%: Heater Control on High Only?
This is the Blower Motor Resistor that needs to be replaced. It is located adjacent to the Blower Motor.

Jan 28, 2010 | 2000 Oldsmobile Alero

1 Answer

Heater fan only works on high


this problem is caused by a defective fan speed control resistor. This part is located in the air duct work next to the blower motor.
see photo.


f8e3f01.jpg

May 07, 2009 | 2002 Dodge Caravan

2 Answers

Heater fan motor wont run on high


Check or have checked the blower motor resistor. This is usually how they act.

Oct 25, 2008 | 1995 Oldsmobile 88

1 Answer

Air condition


Check the following fuses:
10 amp GAUGE under the dash, and the 40 amp HEATER under the hood.
If both fuses are good, I suspect that you may either have a bad fan switch or a bad heater fan motor. The switches are rare to fail, I would suspect the heater motor first. Please try this: Turn the key on; turn the fan switch to high. Look under & behind the glovebox, for the bottom of the heater fan motor. Round thing with 3 screws holding it to the heater box. Using a small hammer, or something that you can tap with, tap on the bottom of the heater fan motor. You just may jar the motor enough to make it run. If it comes back on, you may need to replace it at some point in the near future. Worked for me quite a few times. Try that, repost to me what happens. Hope this helps.

Oct 10, 2008 | 2003 Toyota Corolla

Not finding what you are looking for?
2000 Chevrolet Prizm Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6879 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...