Question about 1995 Mercury Villager

1 Answer

Headlights don't work

The headlights on my '95 Mercury Villager quit working. When I pull the high beam switch, they work, but not the low beams.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Try replacing the bulbs in the sealed beam. Bulb #9007, do both. Lift lid, disconnect electrical wires, unlock o ring, pull out bulb. Replace bulb and reverse the order

Posted on Dec 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Headlight switch turns on parking lights but not headlights. Have to hold high beam switch on to have headlights at night.


Replace light switch assembly. Remenber some switches pull up to flash headlights and press down to change from low to high--press down again goes from high to low.

Apr 25, 2013 | 1993 Mercury Topaz

1 Answer

2005 Dodge Magnum low beams do not work


Obviously you have a connector which has come partially apart somewhere between the Headlights and the Headlight Switch. Most modern vehicles have several connectors between the Headlight Switch and the Headlights, Start at the Firewall Connector and work forward toward the Headlights making sure all connectors are securely mated. Another remote possibility is that you have fractured the "Low Beam Filaments" in BOTH Headlights. You don't mention how hard you hit the Speed Bump but if it caused the car to "Bottom Out" the front suspension it was a hard enough impact to fracture the filaments. You can use a 12 Volt Test Light at the Sockets for the Headlight Bulbs and see if you are getting 12 Volt power there. If you are in Low Beam position you have fractured the filaments. Check with High Beam too.

Nov 18, 2011 | 2005 Dodge Magnum

1 Answer

Headlights If on low beams for a while, then switch to high beam, when i go back to low beams- NO headlights of any kind. Complete darkness. High beams will come on but low beams will not come on. If i...


on that year i did not find one either when i rsearched it . so i"am going to say that headlight switch and relay all in one . . but if you have a enigine type fuse box check it anyway or goto headlight swtich and follow the wiring down a bit and see if there is anything connected to it .

Oct 08, 2011 | 1994 GMC Sierra

1 Answer

I have just repaired my taillights and brakes by replacing the ground wire. Now all of a sudden I no longer have high or low headlights. However, when I pull back on the beam selector switch and hold it...


Check power coming from headlight switch if none when on replace headlight switch, if there is power coming from it, replace your high/low beam switch.

Feb 19, 2011 | 1985 Mercury Grand Marquis

2 Answers

Camry headlights not working


it sounds like a bad light switch

Mar 25, 2010 | 1993 Toyota Camry V6

1 Answer

95 dodge caravan low beam headlights don't work


IF BULBS ARE OKAY.MORE LIKELY DIMMER SWITCH BAD.

Mar 07, 2010 | 1995 Dodge Caravan

2 Answers

Low beam headlights do not work ..replaced switch and high beam bulb


try the lights with the tilt wheel in the up position. If the low beam works then, a wire has pulled out of the connector on the mutipurpose switch inside the steering column. remove the covers behind the steering wheel on the column and there is a large multi wire plug with many wires. it should be obvious which wire has pulled out or broken.

Jan 18, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Headlights on 1998 villager just stopped working. Both sides. High beams still function as do side lights. where do I start looking??


check the 2 relays in the engine compartment, but it may be your turn signal switch on the column. The lights go through there for high & low beam.

Switch is about $50 and just 2 screws hold it on. remove plastic shroud whcih has 3 or 4 screws from bottom of shroud.

http://groups.yahoo.com/group/villagerquest/

Dec 05, 2009 | 1995 Mercury Villager

Not finding what you are looking for?
1995 Mercury Villager Logo

Related Topics:

272 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...