- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I found these on a site I'm assuming they're in order from number 1
Layout Diagram Parts: Direction signal lamps, Right tail lamp, license plate lamp, instrument lights, Left tail lamp, Interior lamp, Heater motor, stop lights, Horn, windshield wiper
if the fuse is good and the wires are not broken or disconnected it may be the wiper motor is bad
All your lights, with the exception of the interior, run threw the turn signal switch. start here and let me know. The TS switch is easy to replace.
there are 3 or 4 screws to remove on the bottom of the steering column bezel and they pop loose. then there are two screws, most likely torx, that hold the switch.
Look at fuse #18, a 15 amp fuse, in the fuse block. This fuse powers both the tail lights and instrument cluster lights. Usually both of these light systems are powered by the same fuse so when your cluster isn't lit up you'll know right away that your tail lights aren't working as it's not safe to drive without tail lights. Your brake, turn, and head lamps are powered by different circuits. Hope this helps and good luck!
No interior dash lights and no tail lights on a GM usually means it's time for a new headlight switch. To check the fuse, it's in the middle of the fuse box marked instrument cluster. If the fuse is good, buy the switch. Lights blowing fuses means you either have a bare wire running down the driver's side of the truck or up into the tail light assemblies. There is also a plug in under the box on the driver's side near the bumper that may be getting wet. Hope this helps.
I had the same problem with my 1996 Mystique about a year ago. The brake and tail lights stopped working, except for the center brake light in the window. Turned out to be oxidation of the terminals at the connector on the turn signal. Yes, that's right, turn signal. The electrical signal to the tail lights goes thru the connector on the turn signal. To fix, I cleaned the contacts and the brake lights started working again. Hope this helps. Cheers, Henry