How to change buick riviera turn signal replacement bulb

SOURCE: signal bulb on 2003 buick regal

To change front turn signal –
open the hood; look in back of headlight; two white clips; pull straight up, and then whole headlight comes out including turn signal; it is all one unit; remove rubber cover, then you take bulb out of unit. Mechanism that bulb fits in will need to be turned clockwise (looking from the front) and pulled to get it out of the larger unit holding all lights. Be sure and put rubber cover back on before re-inserting the two white clips.

SOURCE: 1998 Buick Century Signal Issue

i had this exact problem maybe A LOOSE WIRE . IT SEEMED TO SOLVE MY PROBLEM . NEVER DID LOCATE THE FLASHER UNIT . BUT YES YOU CAN BUY ONE FOR ABOUT 5-15 BUCKS.

SOURCE: how do i change the front turn signal bulb in my

k you will have to pop out the whole light fixture and there should be a conduit where the bulb is conected to just turn it and take it out and replace the bulb

SOURCE: How do I change the turn signal bulb on a 2005

in the front, there should be two plastic clips (white or black) that you pull up on and that will release the entire front headlight assembly so you can then access the sockets for the individual bulbs.

As for the rear,I believe you just need to pull the trim of the trunk out of the way and you can access the rear of the light assembly right in the trunk

SOURCE: 1998 Buick Riviera battery

Make sure that you have the ventilation tubing when replacing the battery. The car is designed to vent battery gases from beneath the car. Substituting a different type battery (without vent ports, a small hole that is located at each end of the battery ) or if you decide to use the battery without the ventilation tubing, you run the risk of an explosion. This is due to the proximity of the battery to the fuel pump, which is also located beneath the seat.Underhood batteries vent naturally into the air within the engine compartment. In your car there is a small hole in front of your battery that leads to the underside of your car.Your tubing is designed to carry the battery's vapors way and direct it out of your car through this hole.