Question about 1989 Ford Mustang

1 Answer

Where is the multifunction switch

Is that the one one the steering columb?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,369 Answers

Yes. with turn signal, wipers, flash to pass, etc.

Posted on Feb 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove a ignition swith on a 1971 corvette


I believe the ign. switch sits on top of the steering columbe diconnect - battery cable lossen the 2 nuts that hold steering colume in place take of the nuts if necessary to get to ign switch,unplug electrical connector from switch remove & replace switch &bolt back up the steering columb dont over tighten or pinch electrical lines whendrawing steering columb back up reconnect - battery cable

May 30, 2011 | 1972 Chevrolet Corvette

1 Answer

Where is the ignition switch located in a 1989 Chevrolet Astro non-tilt steering? How do I remove, replace this switch?


down at the bottom of sterring columb on the top you will probly have to lower the columb a little to get to it its just two bolt and a couple plugs then you will need to make sure its adj correctly should go in all positions including acc by turning key back

Feb 09, 2011 | Chevrolet Astro Cars & Trucks

1 Answer

I have a 1999 GMC sierra and one day I tilted my steering wheel down and my ceiling gauge stopped working along with my engine temp odometer push button 4wd and the windshield wiper don't work nor does the...


its hard to say but when you tilted columb could pinched a wire in the columb or the electrical part of the ign switch has gone bad suggest you take to your local mechanic either repair is quite involved

Feb 04, 2011 | 1999 GMC Sierra

1 Answer

Where does the dimmer switch go


under the steering column shroud, the plastic that wraps around the steering columb. Philip screws. once removed the switch is visible on the left side.

Sep 11, 2010 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Rear brake lights and turn signals do not work people say switch in steering columb


the turn signal switch (Multi function switch) is the likely suspect

Jun 10, 2010 | 1999 Dodge Caravan

1 Answer

How do I fix the automatic signal return on a 2001Ford Focus?


There is a plastic cancel lever on your signal switch, which is located in your steering columb. Air bag must be removed.

May 20, 2010 | 2001 Ford Focus

1 Answer

Steering columb noise


you have answered you own question ,WD what else do you expect from fish oil.use a proper oil can with some engine oil it then get it in where it need it

Oct 30, 2009 | 2003 Volkswagen Passat

1 Answer

Replace ingnition switch on a 1995 vw passat ?


You must also remove the wiper / turn signal switch cluster. Before you can do this... Most of the 1995 Passats were fitted with a splined cone fitted on the steering columb just under the steering wheel. However a special pullers is needed to remove this cone. With this cone and the trim around the switches removed its a simple enough to remove the ignition switch.
All the best
John

Aug 15, 2009 | 1995 Volkswagen Passat

3 Answers

Steering


ford is usually pretty good about using same parts in things like that so i would think it would be fine

Dec 15, 2008 | 1990 Ford Bronco

2 Answers

Left turn signal turns on emergency blinkers


These functions are all controlled by the turn signal switch, also known as the multifunction switch, this is a common issue you have and will require you replace the switch.

Oct 02, 2008 | 2004 Chevrolet Silverado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...