Question about 1989 Mitsubishi Montero

1 Answer

Will not start when cold

My 1989 Raider/Montero will not start when cold. I have to use starting fluid to get it to even want to start. any advice?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Drain raditor and use anti freeze

Posted on Dec 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 1989 dodge raider with the 3.0l v6 that dies when I turn on the lights it has a new battery and alternator what could the issue be?


1989 raider / montero wont start need help please ' Mitsubishi 4x4 ...

www.4x4wire.com/forums/showflat.php?Number=1128085
Nov 20, 2008 - I have a 1989 dodge raider / montero the thing wont start. ... If it doeslight off, I'd suspect a fuel pump problem. Regards, Eric W. '89 Dodge Raider -- 3.0L V6, MT, SWB ... It sounds like a bad ECM if it's the V6. ... Also the truck was weird i started it up ran it for a moment and it died first thing i assumed it was ... 89' Gen I Montero rough idle/misfire and stall problems ...
Jun 28, 2011
Really rough idling and shakes ' Mitsubishi 4x4 & SUV Tech ...
Dec 20, 2010
1990 montero fuel pump fuse ' Mitsubishi 4x4 & SUV Tech ...
Jul 15, 2008
Raider won't start in this artic weather ' Mitsubishi 4x4 & SUV ...
Feb 5, 2007
More results from www.4x4wire.com

1989 Dodge Raider - Fixya

www.fixya.com/cars/t1360572-1989_dodge_raider
Jan 28, 2009 - 1989 Dodge Raider A few weeks ago, I was driving home when all of a ... I'll go back an hour or so later and it will start, warm up then die. ... I have replaced the plugs, wires, distributor, brain, basically .... If you are getting power to anything else (such as the interior light) .... 1989 Dodge Raider 3.0 L V6 EFI.

Dec 28, 2015 | Dodge Cars & Trucks

1 Answer

Dodge raider engine removal


It is best to remove the engine /tranny as a unit. Remove all things that will not allow the engine to move forward and up such as radiator. Undo the manifolds at the heads. Undo all electrical connections and use masking tape to number the connectors so that you know where each one is connected. Get a good engine hoist and use a load shifting lifter bar ( a tool that has a hook point that is adjusted by a threaded bar ) so that as you can adjust the center of gravity of the unit on the hook. As you come forward you can alter the lift point so that the tranny drops to the rear allowing you to lift the unit at an angle to get it up and over the front bar of the body Remember to drain all oils before you start and it won't be half as messy. Remove the bonnet as well for more room

Jul 28, 2013 | 1989 Dodge Raider

1 Answer

I have a 1989 toyota celica and it won't cold


Replace the cold start injector, it is a common issue.

Jul 09, 2013 | Cars & Trucks

1 Answer

Starts good in the morning but then takes a few minutes to start after its been running for a while


1989 I had I carburator version, Depending on where your at it will be the choke mechanism of the carb, For cold start it need to be in the closed position then when it warms up it is lock out, now for a fuel injector type there is a throttle body sensor(TBT) is 2 wire thermistor. As throttle temperature increase,thermistor resistancedecreases, this controls fuel mixture based on coolant temp sensor

Apr 23, 2011 | 1989 Dodge Raider

1 Answer

The horn on the 1989 Dogde Raider turns on when you start the car and does not turn off. What is wrong?


There is no airbag on the raider. There are metal contacts that set the horn off, pop off the center section of the steering wheel. Look for any source of grounding. If not the horn relay is inside of your odometer cluster, which is held on by screws on teh left, right and back of the cover. Its a brass looking box.

Oct 28, 2010 | 1989 Dodge Raider

1 Answer

Where is the base timing ground on 1989 dodge raider 3.0 ltr.


Looking at my manual for the Montero 3.0 V6 it would appear the ground is near the windshield wiper motor. The maunal shows a "ignition timing adjusting connector" right under the motor; the electric connector on the left side of the unit is to be grounded out. If you like I have a manual I could scan for you. Email address please.
I hope this mas assited you,
Tom

Oct 27, 2009 | 1989 Dodge Raider

1 Answer

Does the sending unit plug have to be connected to the tank to start the raider, someone took the tank off to fix a leak he does not remember where all the vacum lines went will the car still start anyway,...


Would say the sender harness must be connected as this completes the circuit for the submersable pump. The vacuum pipes may also affect starting.

Aug 12, 2009 | 1989 Dodge Raider

1 Answer

My 1989 dodge raider wont start


you must have fuel,fire,compression for an engine to run

Jun 16, 2009 | 1989 Dodge Raider

1 Answer

Engine Starts, then immediatly shuts down


mass air flow sensor, or idle control valve.

Apr 28, 2009 | 1989 Dodge Raider

2 Answers

1989 Dodge Raider


your battry maybe

Dec 10, 2008 | 1989 Dodge Raider

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...