99 dodge caravan parking lights stay on after engine is off.
My 99 dodge caravan's parking lights stay on after the engine and lights are turned off. Sometimes you can restart and turn off the car and the lights will go off. Sometimes they don't. Sometimes turning the light switch on and off makes them go off. Sometimes it doesn't.
Re: 99 dodge caravan parking lights stay on after engine...
I had the same problem on my Chrysler Sebring but it was with the headlights staying on. The lights are on a relay called a "delay relay" of which will allow the lights to stay on for a minute after shutting off the ignition (after using your lights let's say when its dark). This of course helps provide light for you to see to walk to your house, keys, etc. But sometimes these relays stick on and just need to be replaced.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
99% of the time, the gas cap wasn't tightened properly, or is leaking. Make sure you twist it tight and it clicks a few times. If the "Check Engine" light stays on after a few days, buy a new gas cap. Again it may take a few days to clear.
Things haven't changed much...look on top of the transmission in the engine compartment and look at the shifting linkage. Look for anything that could be interfering with the shifting. One linkage is the cable to the Shift Lever and Rod that goes down into the transmission. Remove the cable adjustment screw.
Move the shift lever rod towards the front of the Van into the Park Indent Position. Place the Driver's Position (Dash) Shift Lever into Park and then reconnect the Cable to the Shift Lever and tighten down the cable adjustment screw to 70 in-lbs.
Let me know if this helped, or if you have any additional information, questions of problems, Feel free to contact me at FixYa.com!
take out the screws in the top of the cluster.remove the cluster.it is a double sided pc board and there will be broken solder joints on the back side of the pc board.resolder all the pins if you can solder,if not take it to an electronics shop and have them solder it.