Question about 1997 Jaguar XJ6

1 Answer

Replacing Side view mirror cover on 1997 xj6

I have the factory repair manual and the only instruction is to " carefully remove the old cover and replace with new" This is of little help. A local Jag service shop explained they break off the old ones and glue the new ones on....................

Posted by on

  • steve_kinoya Dec 12, 2008

    Thank you but how exactly do I get the old ones off?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 110 Answers

On the covers there is clips attached to them just put cover on top of mirror and push down until bottom clips in

Posted on Dec 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driver side mirror replacement


Instructions1.
    • 1
Remove thedoor panel. Refer to your Honda Accord repair manual for theinstructions in removing the door panel. Unhook the rods and connectors on theinside of the door panel and set it on the floor.
    • 2
Remove thefilm covering the access to the side mirror. It's difficult to avoid damaging thefilm while removing it so you will need to purchase a new piece of filmcovering when you buy a new side view mirror.
    • 3
Reachthrough the service hole into the mirror housing with a screwdriver. Loosen thescrew that holds the mirror. Twist the screw out with your hand.
    • 4
Reacharound the door and support the mirror with your other hand. Continue to twistthe screw out, then catch the mirror as it drops out when you remove the screwcompletely. Put the screw in a safe place so you don't lose it.
    • 5
Installthe new side view mirror by positioning it where the old mirror was. Insert thescrew you took out in Step 4 and twist it in with your hand. Insert ascrewdriver into the service hole to tighten the screw.
    • 6
Replacethe film covering that was damaged when you took out the old mirror. Push itinto place in the indentation on the door.
    • 7
Sit in thecar seat and adjust the mirror so you can use it properly.

Jul 06, 2012 | 2005 Honda Accord

4 Answers

Replace the review mirror


You need to remove the plastic plate that cover the mirror joint from the inside and undo the three bolts.

Oct 30, 2008 | 2006 Chrysler Town & Country

1 Answer

I need instructions for replacing a passenger side view mirror on a 1997 Isuzu Rodeo


Side Mirrors - Power Mirror
Removal & Installation
  1. Disconnect the negative battery cable.
  2. Remove the door mirror cover (3).
  3. Remove the three bolts and disconnect the connector (2), then remove the mirror assembly (1).
  4. Installation is the reverse of the removal procedure.

    0047d6d.jpg
    Fig. View of the power mirror (1), connector (2) and cover (3)

Hope this helps.

Sep 07, 2010 | 1997 Isuzu Rodeo

1 Answer

Remove/replacing side view mirror on a jeep grand cherokee


    Remove the Old Mirror
  1. Step 1 Disconnect the negative battery cable before you take off the grand Cherokee front door trim panel. Remove all screws and clips.
  2. Step 2 Detachthe window trim cover screw, and control lever screw beforedisconnecting the entire mirror trim cover. Remove the rubber coverinside the mirror cover, and disconnect the electrical wire.
  3. Step 3 Remove three nuts from the power mirror using a Torx® star-shaped screwdriver.
  4. Step 4 Pull out the outside rear view mirror. Guide the power wire through the hole in the door.
  5. Install the New Mirror
  6. Step 1 Replace the old mirror. Put the new power mirror in place. Push the new wiring through the hole in the door.
  7. Step 2 Install and tighten the three retaining screws you took off when removing the old mirror.
  8. Step 3 Connect the power mirror wiring to the connection located on the door panel. Replace the rubber cover and interior mirror cover.
  9. Step 4 Put the front door trim panel back in place by securing all clips and tightening all screws.
  10. Step 5 Connect the Subaru Outback's battery cable to restore the power.

i will recommend i site where you will get all the information you need to remove and replace your side mirror
http://www.wjjeeps.com/mirrors.htm

Sep 10, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Replacing passenger side-view mirror on 1999 Dodge Stratus


Watched my dad do it this afternoon. There is an exposed screw on the left side of the door panel and one at the bottom of the panel. There are also two hidden screws, one behind the door handle and one inside the little hole in the armrest (pop off the plastic plugs). There are also three recessed screws behind the speaker cover. You can pop the speaker cover off with a flathead screwdriver. I'm pretty sure thats all of them. You can pop the panel off then, but watch the wires connecting stuff inside. The hardest part is getting it over the door lock. .

Once the panel is loose you have to pop off the black plastic cover hiding the back of the mirror. There are three recessed bolts holding the mirror. My dad had to get a special wrench to get those off and he dropped one inside the door, so be careful (we fastened a magnet to a coat hanger and got it back). Mine had some remote gizmos, so he had to had to unplug the little square thing and then popped off what was left of the old mirror. If your new mirror has a wire with a little box, feed it through the hole and plug it in. Once you have it positioned correctly, you can screw on the bolts and put eveything back together. It helps to have another person there while you are trying to position the mirror correctly. Hope I didn't miss anything. Good luck!

Apr 19, 2009 | 1999 Dodge Stratus

1 Answer

Jaguar xj6 door light cover


look carefully for the trim screw on the bottom side of the light and remove it, from there carefully pry the lens straight towards you It wil pop right off just fine.

Apr 05, 2009 | 1996 Chevrolet Cavalier

1 Answer

2008 Ford Fusion Wing Mirror Replacement


I checked Ford Focus mirror replacement and it seems to be the same. This is for the manual, unheated mirror.

Remove the mirror cover inside the door - slide a screwdriver behind the cover and pry loose carefully.

Remove the single 10mm bolt and the mirror comes free.
NB. Do not drop the bolt into the door.

Apr 02, 2009 | 2008 Ford Fusion

1 Answer

Changing Door Mirror Glass XJ6(X300)


Hi

You need to put on a pair of gloves, and safety glasses. (Safety First !)
Prise off the broken mirror from the plastic base that it is stuck too.
Give the plastic a clean with nail polish remover or similar.
Peel off the backing on new mirror glass, and carefully stick it on.

Good Luck !

Don´t forget to FixYa Rate Me Please !

John.

Feb 05, 2009 | 1998 Jaguar XK8

1 Answer

Replacing side view mirror cover on 200 SAAB 9-5


I need a complete passenger Side Mirror (2nd Hand) N-95 (S Reg) contact 07966 366195

Jan 26, 2009 | 2000 Saab 9-3 Viggen

1 Answer

Changing Door Mirror Glass XJ6(X300)


just clips into place use wd40 and be very carefull

Oct 07, 2008 | 1995 Jaguar XJ6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...