Question about 1996 Jeep Cherokee Country

1 Answer

Rear driver side power window regulator doesn't work

How do you disassemble the window regulator on a 96 Cherokee sport? Specifically the part that attaches to the window itself. It has a hex nut but I can't get it off. Please help.

Posted by on

  • b_hornet Dec 02, 2008

    It's not a nut, it's a hex screw on a spring clip. The rear drivers side power window where the part attches to the actual glass. The rest I have off, it's that spring clip and hex that I can't get off. When I turn the hex, the whole assembly turns.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 203 Answers

Its normally a 10mm nut use a wrench size 10 to turn it anti clockwise

Posted on Dec 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where would you suggest looking for body parts and seats for a 1992 Jeep cherokee SPort 4 DR 4 WD? Specifically the drivers side rear qtr panel and what is the most I should pay for one?


1992 Jeep Cherokee Sport drivers side rear qtr panel, for complete set, basically it costs Approx $370 to $450.------- Click this link below to order the parts:--- http://www.automotix.net/usedautoparts/1992-jeep-cherokee-quarter_panel-inventory.html ---------- This will help.Thanks.Helpmech.

Sep 22, 2011 | 1992 Jeep Cherokee Sport

1 Answer

Where is the crank position sensor located on a 96 jeep cherokee sport


Sensor is at the 11 o'clock position on the bellhousing even with the flywheel (looking from the rear) on the drivers side. The harness connector is near the master cylinder.
(no fun to get to)

Dec 03, 2010 | 1996 Jeep Grand Cherokee

1 Answer

On my 2002 vw cabrio, the drivers side front power window works intermittently - mostly won't work. Passenger side is fone as are the rear power windows. Is this a switch problem?


The most common problem with Cabrio auto windows is the Window regulator. Each window has it's own. My wife also owns a 2002 Cabrio, that had a mis-behaving window driver window and the passenger was locked in the up position. After inspecting the drivers window, I found one of the cable roller guides was broken, causing the cable to snag when using the window open / close, and resulting in the window seeming to have a mind of it's own. I had a local garage order the regulator for me, and then I disassembled the drivers door and installed the new regulator (problem is now solved).
The passenger window was bound up, I also had to remove the regulator and let loose the tension in the cable system by carefully removing the cover over the cable roller. This window works fine now as well.

Jun 13, 2010 | 2002 Volkswagen Cabrio

1 Answer

I have a 2000 Cherokee sport 4 door, 4wd. The left windows work fine but the right front and rear do not work. The LED light on the switch itself is lit. I replaced the window regulator for the front left...


Take a door panel off on the right, and see if you have power and ground going to the regulator when you press the button. If you dont, then your going to be chasing wires

Mar 25, 2010 | 2000 Jeep Cherokee 2WD

1 Answer

I need instructions on how to replace power window motor for the front driver side window of a 2002 Grand Cherokee


Power Window Motor: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the window regulator from the door.
3. Place the window regulator on a suitable work surface and remove the screws that secure the power window motor to the window regulator.
4. Remove the power window motor from the window regulator.
INSTALLATION
1. Position the power window motor onto the window regulator.
2. Install and tighten the screws that secure the power window motor to the window regulator. Tighten the screws to 9 Nm (80 in. lbs.).
3. Install the window regulator onto the door.
4. Reconnect the battery negative cable.

Oct 30, 2009 | 2002 Jeep Grand Cherokee

1 Answer

1999 Jeep Cherokee Sport How do you


I WOULD CHECK THE WIRING BETWEEN THE DRIVER'S DOOR AND THE POST..YOU WILL SEE A RUBBER BOOT BETWEEN DOOR POST AND DOOR..HAVE SEEN PARTIALLY BROKEN WIRES CAUSE ALL SORTS OF PROBLEMS HERE

Sep 03, 2009 | 1999 Jeep Grand Cherokee

4 Answers

2004 Jeep Grand Cherokee driver side power windows do not work


I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.

Nov 25, 2008 | 2004 Jeep Grand Cherokee

1 Answer

Drivers side window


replace the regulator.
There are no bushings.

Oct 25, 2008 | 2004 Jeep Grand Cherokee

2 Answers

2001 cherokee rear driver side power window will not go up


Power window cable broke off. Drivers door. Do the cables sell seperate, or do I have to buy the motor with the cables and were does the cable attach to the window. It looks like a plastic clip broke off, Dennis

Jul 26, 2008 | 1998 Jeep Cherokee

Not finding what you are looking for?
1996 Jeep Cherokee Country Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...